roughness resistance的例句大全

The increasing of surface roughness of non-porous electrodes can also increase biomass on the anode and decrease anodic internal resistance.

增加非多孔电极的表面粗糙度也可增大阳极上的微生物量，同时还能降低阳极的内阻。

A new model of thermal contact resistance based on the statistic characteristic of roughness profile is proposed in this paper.

本文在对粗糙度曲线统计特征分析的基础上，提出了一种接触热阻的计算模型。

Grain shape and surface roughness are indicated to codetermine the abrasion resistance of the film. Further, the AR film with triangular grain and moderate roughness shows good abrasion resistance.

分析得到了粗糙度与耐磨性关系曲线，结果表明三角形晶粒以及适中的粗糙度能有效的提高薄膜耐磨性。

Effect of surface roughness on the fracture resistance of amalgam

表面粗糙度对牙科银汞合金抗折力的影响

Research is mainly carried out for the influences on the fire hose's pressure loss, such as: on-way resistance coefficient, roughness, local resistance coefficient, hose pressure, hose diameter, flow and soon.

主要分析沿程阻力损失系数、粗糙度、局部损失系数、水带压力、水带直径和流量对水带压力损失的影响。

blending porcelain powder into the gold-paste is a feasible way to improve the attrition resistance of the layer and the surface roughness after polishing has no difference.

在金泥中加入一定比例釉瓷粉是提高金泥涂层耐磨性的可行性方法，釉瓷粉加入后对金泥涂层抛光后表面粗糙度无影响，不影响临床应用；

The resistance of surface flow has a reverse relation with Reynolds number. With the same Reynolds number, the resistance coefficient of surface flow is greater than that of laminar flow in open channel and increases with increased bed roughness.

坡面水流阻力与雷诺数的呈反比关系，相同雷诺数条件下，阻力系数比明渠层流阻力系数要大，且随床面粗糙度的增加而增大。

The relationships for hydro-dynamic parameters ( Reynolds number, Froude number, resistance coefficient and flow velocity) of overland flow as a function of bed roughness, flow discharge and slope gradient were simulated by means of indoor fixed-bed resistance experiments.

在室内试验的基础上，采用定床阻力试验研究了坡面流水力学参数（雷诺数、佛汝德数、阻力系数和流速）随床面糙率、流量和坡度的变化规律。

Reynolds Number and Froude number of overland flow tend to diminish, water flow velocity tends to diminish, and resistance coefficient tends to increases as bed surface roughness increases in the condition of same slope gradient and flow discharge.

在坡度和流量相同情况下，随着坡面粗糙度增加，坡面流雷诺数和佛汝德数均呈减小趋势；

The surface roughness parameters, surface profiles, Abbot curves and the profile ratio of peak-to-valley are applied to analyse the wear resistance of the above material.

通过Ra、表面轮廓、支承长度率曲线、轮廓高度幅度分布图、轮廓峰谷比等粗糙度参数评定其加工表面的耐磨性。

The amorphous layer had more compact structure, higher hardness, lower roughness and higher electrical resistance.

结果表明,该非晶层相对于直接阳极化层,组织致密 、 硬度高 、 粗糙度低、电阻高.