saturation的例句大全

The characteristic time for the formation of magnetic islands is much longer than that of nonlinear saturation of magnetic islands caused by the streaming tearing instability.

形成磁岛的特征时间很大于流动撕裂模不稳定性引起磁岛非线性饱和的特征时间。

The conclusion is that in a certain range, increasing competition and saturation constant factor can increase the stability of the system. 2.

得出的结论认为在一定范围内，增大竞争系数和半饱和常量可以提高系统的稳定性。

Nuclear magnetic resonance core analysis technology can be used to quickly test the oil saturation, water saturation, the immobile or mobile fluid saturation with no damage to the experimental core.

核磁共振岩心分析技术能够快速、无损地检测出岩心含油饱和度和含水饱和度、束缚流体和可动流体饱和度的大小。

By taking into account the light hole and heavy hole valence band structures and their combined density of states, the expression of saturation absorption is deduced from the imaginary part of the susceptibility, which is similar to the mode of inhomogeneous broadening of two-level system.

考虑了锗中轻、重空穴价带的能带结构并利用轻、重空穴价带的复合态密度，由电极化率的虚部推得类似于非均匀展宽两能级系统模型的饱和吸收具有的形式。

Integrating the 2-D diffusion equation, the coefficient of saturation recovery is derived and its characteristics can be revealed clearly. Then the theoretical expression of coefficient of saturation recovery under the strong equilibrium condition and the corresponding calculating value have been obtained.

在此基础上积分二维扩散方程，得到了恢复饱和系数，阐述了它的特性，进而导出了在强平衡条件下的恢复饱和系数的理论表达式和相应的数字结果。

This paper points out that the current saturation computing method, when applied to clay, leads to an unreasonable great value which sometimes even exceeds the theoretical maximum.

指出现行土饱和度Sr计算方法用于粘土时出现数值偏大甚至超过理论最大值的不合理现象。

A qualitative estimate of gas hydrate saturation can be obtained by comparing the theoretical P-wave velocity for full-water saturation to actual P-wave velocity.

通过对比饱和水的理论P波速度与实际P波速度，可以得到天然气水合物饱和度。

Has Chinese Fixed Telephone Market Reached its Saturation Point?

固定电话市场的饱和度到底有多大？

They got cold, they got drenched, they had barely a clue what was happening unlike everyone else in the country who had saturation television coverage.

他们冒着阴冷，被大雨淋得湿透，却并不知道究竟发生了什么，留在家里的英国人反而能够通过铺天盖地的电视转播收看实况。

A complex resistivity measurement system under modeling reservoir condition has been developed that consists of core holder, oil-water displacement, temperature control unit, saturation measuring unit, complex resistivity measuring unit and controlling unit, etc.

模拟地层条件下的高温高压复电阻率测量系统由岩心夹持器、驱替系统、温度控制系统、饱和度计量系统、复电阻率测量装置和控制系统等组成。

Conductivity and saturation temperature method for determination of wine stability

论葡萄酒的电导率和临界饱和温度

At the same time, the effects of Ca/ S ratio, desulfurization residues recycling use, saturation temperature interval, water spray quantity and SO_2 concentration on desulfurization rate were studied.

试验同时研究了钙硫比、脱硫灰循环率、饱和温距、喷水量和SO2浓度等对脱硫率的影响。

Also when interpreting temperature logging, we must consider the effects of porosity, saturation and adjacent rock lithology on temperature profile.

另外在进行井温测井解释时，一定要注意孔隙度、饱和度以及围岩岩性对温度剖面的影响。

Study on the Measurement Methods of Curie Temperature and Saturation Magnetization

居里温度和饱和磁化强度测量方法的研究

The change of extracellular environment ( pH, temperature, saturation of O2).

细胞外环境（pH、温度、氧浓度）的改变等。

Influences of temperature and saturation states on the precipitation rate of calcium carbonates in seawater ⅰ. Mg-calcite

温度和过饱和度对海水中碳酸钙沉淀速率的影响Ⅰ.镁方解石

Sandstone geophysical response and elastic modul vary laws with pressure, temperature, saturation, liquid character in high pressure& high temperature are studied.

通过大量实验室研究分析在地层条件下（高温、高压）砂岩的地球物理特征及其弹性模量随压力、温度、饱和度、流体性质的变化规律。

The Curie temperature and saturation magnetization of manganese-zinc ferrite were measured by using the electric bridge method, induced method and vibrating sample magnetometer ( VCM).

分别用电桥法、感应法和振动样品磁强计对锰锌铁氧体的居里温度和饱和磁化强度进行了测试。

The effects of foaming temperature, saturation pressure and shear rate on the cell morphology of foamed PLA in microcellular foaming process of supercritical CO2/ PLA were investigated.

研究了超临界CO2/PLA微孔发泡过程中，发泡温度、饱和压力、剪切速率对聚合物PLA泡孔形态的影响。

The results showed that the cell morphology of a foamed blend was significantly impacted by foaming temperature and saturation pressure. A lower foaming temperature and a higher saturation pressure were more favorable for leading to a decrease in cell size and an increase in cell density.

结果表明：发泡温度和发泡压力对共混物的微孔形貌影响显著，降低发泡温度和提高发泡压力均能降低泡孔的孔径和提高泡孔的孔密度。