sensor signal的例句大全

The input and the output of the traditional transmitting instrument are analog signal and the structure are simple, the function is unitary, which can only carry on the recuperation for the specific sensor signal.

传统的变送器器输入和输出都是模拟信号，结构简单，功能单一，只能为特定的传感器信号进行调理，当工业现场传感器繁多时，就需要多种调理器投入使用。

WHILE ROTATING THE TIRE, OBSERVE THE LR WHEEL SPEED SENSOR SIGNAL.

在转动车轮胎的同时观察左后轮速度感知器信号.

BATTERY TEMP SENSOR SIGNAL AND SENSOR GROUND CKTS FOR RESISTANCE.

电池温度感知器信号和感知器接地电路S的电阻.

The hardware of AMT control system design was described, including the main control module, the sensor signal processing module, the magnetic valve drive module, power module and communication module.

介绍了AMT控制系统硬件设计方案，包括主控模块、传感器信号处理模块、电磁阀驱动模块、电源模块和通讯模块的设计思路和设计结果。

a kind of hardware realization method of solid state image sensor signal equidistance subdivision

固体图像传感器信号插值细分的硬件实现

the concept of analytic acoustic energy flux is the basis of pressure and particle velocity combined processing, is the bridge between the technology of general acoustic pressure signal procession and the technology of vector sensor signal procession.

文中第三章介绍了‘解析声强流’概念，它是声压&振速联合信号处理的基础，是将常规声压信号处理技术，延伸到矢量传感器信号处理的桥梁。

After receiving a control console and a sensor signal, a single chip computer carries out the intelligent control to the action of the electromagnet.

单片机接收控制台、传感器信号后对电磁铁动作进行智能控制。

The variables actual value is changed to sensor signal by using the hardware circuits which produces control data.

利用硬件电路将变量实际值转化为对应的传感器输出值并产生控制量。

In the practical measuring process, noise produced by a mass of local disturbance would badly distort the sensor signal, so the method for clearing up the noise and improving the measuring precision is put forward.

再者由于实际测量过程中，大量的现场干扰导致的噪声会使传感器信号严重失真，又提出了用数字滤波消除噪声以提高测量精度的方法。

Temperature and humidity sensor signal to temperature and humidity signals into electrical signals, after signal conditioning and AD conversion, and finally obtain the corresponding concentration value.

温湿度传感器通过把温度信号和湿度信号转换成电信号，经过信号调理和AD转换，最后得到相应的浓度值。

System hardware and software design idea is presented, the analog front-end chip in hardware is used for sensor signal pre-processing, FPGA is performed signal processing, such as filtering, signal pick-up etc, the analog and digital blocks are connected with bridges.

硬件中的模拟前端器件用于获取传感器信号并进行预处理，数字部分的现场可编程门阵列（FPGA）用于数字信号处理，如滤波、信号提取等，模拟模块与数字模块通过桥路连接。

the analog unit performs four tasks, the sensor signal conditioning, ad/ da, modulation of the infrared emitter and control of the heating voltage for figaro sensors.

模拟信号处理单元，完成Figaro气体传感器的信号调理和加热电压控制，红外探测器信号调理，红外光源功率驱动，AD采样和DA输出等功能；电机控制和驱动单元，完成小车电机的功率驱动和控制。

the existing acoustic source localization techniques are typically based on three types of sensor measurement from physical variables: time delay of arrival, direction of arrival and received sensor signal strength or energy.

根据传感器探测物理量的不同，经典声目标定位方法主要分为三类：基于波达方向定位（DOA），基于时延定位（TDOA）和基于信号能量定位（RSSI）。

An FBAR tiny-mass sensor signal acquisition and processing chip is designed, fabricated, and tested. Low-power source-coupled logic dividers are introduced to reduce the frequency of RF signals from Giga Hertz to a frequency that CMOS circuit could deal with. 3.

设计、流片并测试了该FBAR微质量传感信息采集处理的芯片，该芯片前级采用低功耗的源耦合逻辑分频器对射频信号进行预分频。

The sensor signal of magnetic coating pachometer is strong non-linear function.

磁性测厚仪的传感器信号是强非线性函数，其准确拟合是测厚仪高精度测量的基础。

Adopting the reactive circuit of twice harmonic to process the sensor signal, the system is closed loop.

对传感器信号处理采用的二次谐波反馈电路，电路为闭环系统。

Equipped with controller and display panel to insert the simulation at any time for electronically controlled diesel engine fault, fault code display, digital display, speed sensor signal waveforms detection sensors, electronically controlled diesel engine monitoring and other actions.

配备的控制器及显示面板能随时进行电控柴油机故障的模拟插入、故障码的同步显示、传感器信号的数字显示、车速传感器的波形检测、电控柴油机运行监测等操作。

Accelerator Pedal Postion Sensor Signal High Exceeded Throttle Position Sensor Mounting Screws

油门踏板位置感知器信号过高节气阀位置感知器固定螺丝

Simulation of digital sensor signal QAM technology based on communication channel

基于通信信道的数字传感信号正交幅度调制技术仿真研究

The sensor signal acquisition module is isolated from the control system by using the DC-DC switch power modules and optocoupler to prevent the module from noise interference.

传感器信号采集模块的设计中，为防止外界噪声干扰传感器信号输出，与控制系统之间使用DC-DC电源模块和光耦对电源和信号进行隔离。