shear height的例句大全

The article uses CT technology to study the radial un-uniformity of the mixture, carries out the constant height-frequency scanning test and the constant height repeating shear test to study the influence of the radial un-uniformity on the shear performance of asphalt mixture.

该文采用CT技术研究了混合料的径向非均匀性，通过恒高度频率扫描试验和恒高度重复剪切试验研究了径向非均匀性对沥青混合料抗剪能力的影响。

The bending stress has more effect on the limiting height to thickness ratio than the shear stress.

计算表明，连续组合梁负弯矩区钢梁腹板的弹性临界高厚比主要受弯曲应力的影响，其次为剪应力。

Analysis of interruptable height of shear wall in frame-shear wall structure

框-剪结构剪力墙可中断高度的分析研究

The conditions of interruptable shear wall height are proposed.

设定可中断剪力墙高度的条件。

The height of the structure has small influences to the interruptable shear wall height.

结构高度对中断剪力墙高度的影响较小。

The conditions that the most story drift angle of interruptable shear wall height are established.

设定了最大层间位移角θmax为可中断剪力墙的条件。

The results show that, with the ( increase) of the rigidity characteristic, the interruptable shear wall height increases.

计算表明：随着刚度特征值的增加，可中断剪力墙的高度随之增加。

The storey element, which can model one storey of the frame-shear wall structure is fabricated. Based on SRSS method, the frame-shear wall structure with shear wall interruption at different heights is analyzed. The conditions of interruptable shear wall height are established.

构造能模拟一层框剪结构的层单元，用振型分解反应谱法分析不同高度和结构刚度特征值的断层剪力墙框剪结构的地震反应，设定可中断剪力墙高度的条件。

Then, the actuator line code is used to study the unsteady aerodynamic characteristics of NREL wind turbine under wind shear inflow condition. Two hub height wind speeds of7m/ s and10m/ s are selected.

然后，采用致动线程序对NREL实验风力机在切变入流下的气动特性进行研究，选取了轮毂高度风速为7m/s和10m/s两种情况。

Using a framework for an example, this paper analyzes the simple loads bar stress strain rule, through the change section height, the shear displacement of the influence of vertical displacement.

最后以一三维框架为例，分析了简单荷载作用下杆件应力、应变规律，通过改变截面高度，研究了剪切位移对竖向位移的影响。

At the same time, different influences on node performance about different stiffened plate, beam web thickness, beam web height, concrete strength, axial compression ratio, shear span ratio are also obtained.

同时，通过建立不同的模型进行计算，分析了加劲板、型钢腹板厚度、型钢腹板高度、混凝土强度、轴压比、剪跨比等因素对节点性能的影响。

Calculate the shear bearing capacity and flexural bearing capacity of the designed walls, and preliminarily determined the scope of the loading height on impact of the failure modes of walls according to the calculated results. 3.

对设计的墙片进行了抗剪承载力和抗弯承载力的计算，并且根据计算结果初步确定了加载高度对于破坏形态的影响范围。

In particular, the concealed bracings have more evident effects in improving bearing and energy-dissipation capacity of the wall slabs in coupled shear walls with lintel beams of relative smaller span-height-ratio. 4.

特别是在连梁跨高比相对小的双肢墙墙肢中增加暗支撑对双肢墙承载力、耗能提高的作用更为明显。

C . shear wall with the same height-wide-ratio and different aseismic measures is compared.

比较了同高宽比但不同抗震措施的剪力墙抗震性能.

In the constant load and live load under the action of shear pin, and the circumferential weld will withstand high amplitude of cyclic stress, the strength and fatigue problem should cause height to take seriously.

在恒载和活载的作用下，剪力销以及其周边焊缝将承受幅值较高的应力循环，其强度和疲劳问题应引起高度重视。