shear joint的例句大全

the results show that the spot welding joint with existing welding technical parameter satisfies design standards and the shear strength requirement of japanese industrial standards ( jis), the extraneous composition of the welding joint nuggets is lower and the spot welding joint has a better plastic capability.

试验表明，在现有的工艺参数下，该点焊接头的剪切强度满足设计标准和日本工业标准，焊核组织和成分较纯净，焊点的塑性较好。

standard test methods for in situ measurement of masonry mortar joint shear strength index

现场测定圬工灰浆连接点切变强度系数的试验方法

These methods are: diagonal braces, shear walls, and joint rigidity ( frames ).

这些方法有: 对角撑, 剪力墙, 连接刚度 ( 框架 ).

It is shown that the shear strength of joint is concerned with normal stress and weighted average of mean profile angles of joint surface.

说明节理的抗剪强度与法向应力和节理表面形貌特征参数有关。

Ultrasonic Shear Wave Inspection of the Joint Screwed Tube in Aeroplane Engine

某飞机发动机连接螺管的超声横波检测

Effect of magnetic field on shear strength of adhesively bonded single lap joint

外加磁场对粘接接头剪切强度的影响

The axial stresses in a group of bolts tightened on a joint of bridge truss were measured by using both longitudinal and shear ultrasonic waves.

本文利用纵横波相结合的方法对九江大桥联接螺栓的施拧轴力进行了群检测量。

Experimental study on seismic behavior of shear walls wih X-shaped concealed bracing and concealed vertical joint

带X形暗支撑设暗竖缝剪力墙抗震性能试验研究

The results show that there exists a critical joint size ( CJS) by which the size effect of the shear strength parameters of fractal rock joints ca.

数值直剪试验结果表明：岩石分形节理存在消除抗剪强度参数尺寸效应的临界节理尺寸（CJS）。

Shear pin safety joint

剪切销钉式安全接头

steel shear key is one of important parts for the joint between elements of immersed tunnel.

钢剪切键是沉管接头的关键部件之一,钢剪切键箱体一般通过多排多列的角钢预埋件连接于沉管管体上.