shear strength的例句大全

A solvent-free room-temperature curable two-component PU adhesive was prepared, it has higher adhesion strengths and excellent toughness. The shear strength at room-temperature was 37.1 MPa and the shear strength at 200 ℃ was 3.8 MPa, and the tensile elongation at break still was 104%.

研制了一种室温固化无溶剂双组分聚氨酯胶黏剂，具有较高的黏接强度及良好的韧性，在保持室温剪切强度为37.1MPa的同时，扯断伸长率为104%，200℃仍有3.8MPa的强度；

Study on improved double-notch shear strength test of glass laminates

复合材料层合板双切口层间剪切试验的改进研究

The paper introduces the synthesis and properties of the adhesive, discusses that shear strength can be affected by the thickness of adhesive layer and drying time of the test-piece which has been immersed in water for 24 hours.

介绍了它的合成方法和性能，讨论了粘接试件浸水24小时后的不同自然干燥时间、胶层厚度等对剪切强度的影响。

Experimental research on shear strength of basalt fiber composites reinforced by thermosetting resin

热固性树脂基玄武岩纤维复合材料性能的研究

Experimental study on shear strength of reinforced concrete slabs without stirrups

钢筋混凝土无箍板抗剪强度试验研究

Masonry shear strength can be increased effectively under the dowel action of mortar;

砂浆的销键作用能有效提高砌体的抗剪强度；

Evaluation of the life by means of the shear strength of sample which pass through heating oxygen aging test according to environmental test specification was.

以拉剪强度为特性指标，通过热氧加速老化试验，参照环境考核试验，综合评估其使用寿命。

Experimental Study on Shear Strength and Anchorage Behavior of Steel Tie Bar and Expansion Bolt in Shale Perforated Brick Masonry

页岩多孔砖砌体抗剪性能与拉结筋、膨胀螺栓锚固性能的试验研究

The effects of rolling and annealing temperatures on the shear strength of titanium cladding steel plate were investigated.

研究轧制温度、退火温度对复合板剪切强度的影响。

Titration analysis, AFM and composites IFSS measurement were used to characterize the acidic functional groups contents on the fibers surface, the surface topography and its composites interfacial shear strength.

通过酸碱滴定法、原子力显微镜表征和复合材料界面剪切强度（IFSS）测试，分析纤维表面酸性官能团含量、表面形貌及其复合材料界面强度的变化规律。

According to the relationship among structural stiffness, structural compression resistance, shear strength, and mortar strength, the masonry strength and mortar strength are obtained. And then, the quality and safety of masonry buildings are evaluated.

根据识别的刚度矩阵，利用结构刚度与层间抗压抗剪强度、砂浆强度之间的关系，则可求得砌体的强度，从而达到对砌体结构进行损伤检测和安全性评定的目的。

Study on Shear Strength Characters of Pb/ Sn Bump

Pb/Sn凸剪切性能研究

Analysis of Shear Strength of Reinforced Concrete Beams with Inclined Tension Side

受拉边倾斜的钢筋砼梁受剪承载力的解析解

Making use of the test features of ring shear apparatus, the change law of shear strength of soils under large shear displacement can be studied.

利用环剪仪的试验特点，可以研究土体在较大剪切位移下抗剪强度的变化规律。

The basic concept suggested by the second author in 1984,1986 have been extended to apply to beams with inclined tension side and the shear strength of such beams has been analyzed in this paper.

本文将蒋大骅（19841986）提出的基本概念推广到受拉边倾斜的钢筋砼梁，对其受剪承载力进行了研究。

The differences of safety factor quantity, slip surface shape and location between stability method based on slip surface FE stress and shear strength reduction method are compared and studied.

比较研究滑面应力分析法与强度折减法在安全系数大小及滑动面形状和位置的差异。

Theoretical Analysis of Geotechnical Space Slip Surface and General Shear Strength

岩土空间滑动面和抗剪强度的理论分析

Studies on the Comprehensive Shear Strength Character of Compound Slip Surface in Rock mass

岩体复合滑动面综合抗剪强度特性研究

Firstly, the shear strength parameters of slip surface are back-analysised, then quantitive evaluation of landslide is carried out, and the residual sliding force under different conditions are calculated, and abnormal operation mode two is selected as control condition. 3.

首先对滑动面的抗剪强度参数进行反算，然后对滑坡体进行了稳定性定量评价，计算了不同工况下滑坡的剩余下滑力，并选取非正常工况Ⅱ作为抗滑支挡工程设计的控制工况。

During the deformation, disintegration and failure of debris-soil landslides, in space the plastic strain of the sliding mass and shear strength of the rock or soil mass on a sliding plane are different.

在碎石土滑坡变形解体破坏过程中，在空间上滑体塑性应变和滑面上岩土体抗剪强度的发挥程度是不一致的；