shearing section的例句大全

A simple calculation expression of the shearing flow and the coordinates of bending center is introduced for the thin-walled beam with open section.

针对开口薄壁截面梁的剪流和弯心坐标的复杂计算问题，导出了简便计算公式。

Distribution method without shearing force of variable cross-section single span multilayer rigid frame

变截面单跨多层刚架的无剪力分配法

Theoretical Design and Output Signal Analysis of the Circular-section I-shaped Beam Shearing Force Sensor

圆截面工字梁剪力传感器理论设计与输出信号分析

Effect of Shearing Force on Natural Frequency of Equal Cross Section Cantilever Beam in Lateral Free Vibration

剪切变形能对等截面悬臂梁横向自由振动基本频率的影响

Back-analysis of indexes of shearing strength of slip zone with multi-sections

多剖面反算滑带土抗剪强度指标的研究

This paper discusses the distribution of shearing force and torque at the twin-box cross-sections of the two-lane railway immersed tunnel on various rectangular plates, and introduces its calculation examples.

针对双线铁路沉管隧道双室箱形截面的剪力、扭矩在截面各矩形板上的分配问题进行了探讨，介绍了剪力分配和扭矩分配的计算实例。

We calculate their strength based on finding the critical section by drawing the shearing force diagram and bending moment diagram that is relatively complex and needs lots of work.

它们的强度计算必须以剪力图和弯矩图的绘制来找到危截面为前提，而这一绘制过程复杂，计算量大。

Control and improvement of double length shearing of small section steel F, as control.

合钢小型连轧厂倍尺控制及改进F，对照组。

neglect the axial deformations and consider only the lumped masses. calculation of shearing stress for axial drawing of transform section bar

略去轴向变形不计，仅考虑集中质量。变截面直杆轴向拉伸时的剪应力计算

shearing stress distribution in the lateral section for non-uniform beam

变截面梁横截面上的剪应力分布

Calculation of shearing stress for axial drawing of transform section bar

变截面直杆轴向拉伸时的剪应力计算

Liquefaction of sand under bi-directional cyclic loading CALCULATION OF SHEARING STRESS FOR AXIAL DRAWING OF TRANSFORM SECTION BAR

饱和松砂的双向耦合剪切特性试验研究变截面直杆轴向拉伸时的剪应力计算

Shearing Stress Problem of Variable Section Round Bar in Axial Tension and Compress

变截面圆杆轴向拉压时的剪应力分析

The shearing properties of asphalt mixture in wearing layer of a testing section of Gangzhou-Wuzhou Expressway are evaluated by the single penetration test and unconfined compression test.

利用单轴贯入试验和无侧限抗压试验，对广梧高速公路试验段面层沥青混合料的抗剪性能进行了评价和检验。

firstly, the maximum shearing stress envelope line was put forward to replace section line.

首先提出采用最大剪应力包络线来代替剖面线.