shunt current的例句大全

Design and develop the current transformers, what be used for the shunt current testing of overhead lightning conductor.

设计开发适宜现场应用的电流互感器，以用于架空避雷线分流电流的测试。

To verify the simulation approach, simulation results and experimental results of a shunt active filter for harmonic current compensation in a three-phase system are presented.

要核实模仿方法，在一个三相系统提出模仿结果和分流器活跃过滤器的实验性结果泛音当前报偿的。

Then the algorithm is extended to the four-switch three-phase system. A new SVPWM algorithm is proposed based on four-switch three-phase shunt APF current modulation.

然后将其扩展到三相四开关系统，提出了针对三相四开关APF的SVPWM电流调制算法。

Making use of a shunt-wound controlled current source between the node and the ground elucidation is carried on.

利用一个简单的并联在节点和地之间的受控电流源进行分析。

Determination of reactive current contributions of shunt loads to point of common coupling

并联负载对公共联结点的无功电流贡献的确定

dc ammeter with shunt influences of different turbulent current models and difference schemes on the flow field of hydrocyclones

带分流器的直流电流表不同湍流模型和差分格式对旋流器流场的影响

A Novel Digital Control Method for Shunt Active Power Filter Based on Line Current Detection

基于系统电流检测的并联有源电力滤波器数字控制方法

Predictive Current Traced Control Method PWM Technology Applying in Shunt Active Power Filter

并联有源电力滤波器预测电流跟踪控制PWM技术

A Study of Current Shunt Negative Feedback Amplifier Experiment

电流并联负反馈实验的讨论

A Method to Calculate Close Push Current of High Voltage Shunt Capacitor Bank

高压并联电容器组的合闸涌流计算方法

The single-phase shunt APF is taken as the hardware platform in studying the balance between convergence speed and steady state accuracy of adaptive harmonic current detection algorithm.

针对自适应谐波电流检测方法收敛速度与稳态精度需折中考虑的问题，采用单相并联有源电力滤波器（APF）作为硬件平台。

Designed fault locators are installed at sectional switches i.e.boundaries of sections, which in fact are resonant circuits connected to the feeder line in parallel to shunt the resonant frequency band component of the transient current.

在馈线各分段开关处即各供电区段边界处安装故障判断装置，其实质为并联在馈线上的谐振电路，使得在谐振频段附近的电流成分被衰减。

This paper reviews and analyzes the existing problems of shunt reactor protection, including the sensitivity and reliability of turn-to-turn fault protection, current transformer ( CT) saturation of differential relay and the characteristic of overload protection.

分析了目前超高压并联电抗器保护所存在的一些问题，包括电抗器匝间短路保护灵敏度与可靠性、电流互感器暂态特性不一致对差动保护的影响等。

Calculation to check over voltage and over current in design of shunt capacitor banks has to be carried out in combination with calculation of harmonic current, and should have a certain safety margin for the design.

在并联电容器组的设计中要结合谐波电流进行过电压和过电流的校核计算，并留有一定的设计裕度。

In this paper, we propose and discuss two new control methods for three phase shunt APFs: the sinusoidal line current control method and the instantaneous reactive power compensation control method.

本论文提出三相并联型有源滤波器的两种新的控制方法，即正弦波化控制和瞬时无功功率的控制方法。

The traditional traveling-wave differential protection cannot be applied to ultra/ extra high voltage transmission line with shunt reactor, so this paper describes a novel differential current expression. Based on traveling-wave differential protection a new scheme with low proportional restraint characteristic is presented.

传统的行波差动保护无法应用于带并联电抗器特/超高压输电线路，为此给出了一种新的行波差流表达式，并据此提出一种具有轻微比例制动特性的行波差动保护实用方案。

In this paper is presented a supplement to the theory of magnetic shunt compensation for current transformer, with a compensation formula derived which is convenient for direct measurement by instrument transformer tester. The measuring method and calculation with this formula is introduced detailedly.

本文补充了电流互感器磁分路补偿的理论.导出了一个便于利用互感器校验仪直接测量的补偿公式.并详细介绍如何运用这个公式进行测量和计算。

Examples are given to confirm the coherence of "Steinmeitz compensation" and "symmetrical shunt compensation". The essence of asymmetrical compensation is to eliminate the minus sequence shunt of asymmetrical load current with the compensate current of network.

文章通过实例分析了这两种补偿方法的一致性，指出非对称补偿的实质，是用补偿网络的补偿电流去消除非对称电流中的负序分量。

According to the discovered reason, the current limiter based shunt voltage compensation method is proposed.

提出了基于限流器的并联电压暂降补偿方法。

In most substations, detecting the voltage and current and shunt capacitors is the method used for local reactive power compensation.

变电站无功补偿控制一般方法是通过检测母线上电压电流值，控制投切电容器组实现电网无功补偿。