simul的例句大全

The co-simulation analysis and simulation results show that the way that we connect the entire vehicle dynamics model built in ADAMS with the mathematic model of the control system built in MATLAB by which we studied the electric power steering system study is effective.

仿真结果说明以ADAMS中建立的整车动力学模型与MATLAB中建立的控制系统的数学模型联合起来研究电动助力转向系统是有效的。

The electric city buses model is established by cruise and co-simulated with MATLAB.

利用Cruise软件搭建了电动城市客车模型与MATLAB进行联合仿真。

But in simulation-based optimization, overmuch simulation number of times is an important reason of reducing optimization speed.

但在具体优化过程中，过多的仿真次数是影响寻优速度的重要因素。

encapsulating the domain models into hla federates is one of the key techniques to setup a co-simulation system based on hla.

对依附于商用仿真软件的领域模型进行HLA封装，是实现协同仿真关键问题之一。

Design of target-simulator based on virtual image injection

基于虚拟图像注入的目标模拟器设计

When the steels thermal-simulated to the peak temperatures below Ac3, the well-performed precipitation of carbides from the martensite matrix occured, which could soften the matrix and therefore increase the ductility.

模拟热循环的峰温低于Ac3时，高温下马氏体板条内的碳进一步析出，基体软化，塑性提高；

Wild-simulated ginseng is planted in the fall.

模拟野生养殖的高丽参在夏天种植。

Research on Fault Model Technology in Testability Simulation-based Fault Injection Experiment

测试性模拟故障注入试验中的故障模型研究

The variations of mass changes of polyimide films during exposure in different flux of atomic oxygen ( AO) beams which was a ground-simulated low earth orbit ( LEO) space environment, were in-situ studied using QCM.

用石英晶体微天平（QCM）原位监测并研究了聚酰亚胺薄膜在地面原子氧模拟装置中暴露时的质量变化。

Effects of waterlogging of soil on sorghum root were studied on the Experimental Farm of Shanxi Agricultural University with pot culture utilizing waterlogging-simulation method at later growth stage.

为了研究抽穗后渍水逆境对高粱根系及地上部生长发育的影响，在山西农业大学试验农场进行了人工模拟高粱渍水盆栽试验。

The mathematical-simulant model system dis-cussed in the paper is put to practical use in a regional education programming.

文中提出数学-模拟模型体系，已在重庆地区的教育规划研究项目中得到了实际的应用。

Methods The chest radiographs and CT findings in two cases of intrathoracic tumor-simulating EMH with thalassemia were analyzed respectively and some related literatures were reviewed.

方法回顾性分析2例地中海贫血患者的胸部瘤样髓外造血组织平片和CT表现。

In addition, he said, war-simulation shooting games have become popular there, creating an inroad for the' Call of Duty 'games.'

他说，除此以外，模拟战争场景的射击游戏已经在中国流行开来，为《使命召唤》之类的游戏进入创造了条件。

The CCT curve of the bainite transformation of the Mo bearing and Mo free trial steel has been measured and the metallographic structure of the steels observed by expansion method in a thermo-simulation machine.

在热模拟试验机上采用膨胀法并结合金相组织观察，测定了含钼和不含钼的试验钢贝氏体转变CCT曲线。

The variation of hardness and precipitation behavior during aging at 525 ℃ after relaxation in deformed Nb-bearing microalloyed steel were studied by thermo-simulation test, metallographic analysis, measurement of hardness and TEM.

采用热模拟手段、金相及硬度测量并结合透射电子显微镜观察，研究了简单成分的含Nb微合金钢在热变形弛豫后、525℃时效时硬度变化及析出过程。

In this paper, by weld thermo-simulation test with different peak temperatures, the variation of HAZ charpy impact toughness of Cr-Al steel was determined.

本研究采用模拟焊接热循环试验方法，测定了Cr-Al钢被加热到不同峰值温度后热影响区冲击韧性的变化。

The microstructure evolvement of bainite under different relaxation time after deformation in austenite for microalloyed steel was studied by applying thermo-simulation test, metallographic analysis, semi-quantitative measurement and PTA technique.

利用热模拟、金相分析结合半定量测量统计及径迹显微照相技术（PTA），研究了微合金钢奥氏体区变形后弛豫不同时间的贝氏体组织演化情况。

By using the thermo-simulation and Charpy-V notch impact test along with observation of the microstructures in the cleavage crack is initiated, the effect of manganese on the toughness of various zones in C-Mn multipass weld metals is investigated.

本文通过热模拟、夏氏冲击及启裂源组织观察等实验，研究了锰对C-Mn钢多层焊缝韧性影响的机理。

The stress-relaxation method is used to monitor the strain-induced precipitation curves with thermo-simulation machine in Nb and Nb-Ti microalloyed steel. Meanwhile, the strain-induced precipitation process is also obtained with the aid of carbon replica technique under the TEM observation.

利用应力弛豫法在热模拟机上分别测定了Nb钢及Nb-Ti微合金钢的应变诱导析出曲线，并采用萃取复型技术在电镜下直接观察了应变诱导析出过程。

By using thermo-simulation, Auger analysis and Charpy V impact test and with observation of the microstructures in which the cleavage crack initiated, the morphology and toughness of the local brittle zone of C-Mn and Cr-Ni-Mo multipass weld metals have been investigated.

以C-Mn，Cr-Ni-Mo手工多层焊缝为研究对象，采用示波冲击，俄歇分析，启裂源组织观察及热模拟实验，对薄弱环节组织的形态，韧性及对焊缝韧性的影响进行了研究。