simulated line的例句大全

And testing a vehicle's position related to the line of magnetic marks in the virtual trailing ground is simulated in favor of successive control models.

在虚拟试验场场景中实现了对车辆相对于磁道钉位置的检测模拟，以利于后续自动控制模型的处理。

Wave field and wave factors of interesting points are simulated through the third generation wave model SWAN, and the wave field characteristics of Jiangsu Coastal line is analyzed.

通过第三代浅水波浪数值模型SWAN模拟江苏沿海风浪场，并对江苏沿海的波浪场特征进行分析研究。

Two dimensional flow fields in different nozzles, with equal section throat area and different section length have been simulated. The change of sonic line with the section length, and optimum length of the section have been given.

模拟得到了喉部具有不同等截面段长度的二维喷管流场，指出了音速线随该长度的变化规律和等截面段最佳长度。

A method is presented, by which the plane strain state on the earth's surface can be obtained with the combination of tidal line strain data and the tidal shear strain can be simulated numerically.

提出了由潮汐线应变的组合观测资料获取地表平面应变状态和对潮汐剪切应变进行数值模拟的方法。

The thermal action of acid-containing DNT, TNT in the transition from thermal decomposition to explosion was studied in close-to-adiabatic conditions. Two samples were studied, of which one was simulated in the laboratory, the other gathered from the production line.

研究了近似绝热条件下含酸DNT、TNT模拟试样及生产现场采集试样从热分解过渡到热爆炸的热行为。

Finally, its application model to Xi' an Metro Line 1 is simulated.

最后给出西安地铁1号线的应用模型实例。

According to results of the simulated analysis, three-line slitting pass system for 12 mm rebar were new designed. The experimental results showed that the mills'productivity was increased and the quality of rebar was improved by using the new slitting pass system.

根据模拟分析的结果，设计了直径为Φ12mm带肋钢筋的三线切分孔型系统，轧制生产实验结果表明：采用优化的新切分孔型系统进行生产，提高了轧机的生产率，改善了产品质量。

On the basis of topological structure physical model and mathematical analysis models of facility layout, piston 117 production line with types of facility layout is simulated with deneb/ QUEST software.

以活塞117生产线布局形式拓扑结构的物理模型为基础，结合基于制造系统功能的设施布局设计数学分析模型，在Deneb/QUEST软件平台上建立其仿真模型，仿真研究基于制造系统功能的设施布局形式。

The electrical characters of interconnect lines with different line space and width are simulated with the ISE. The TDDB failure tests are operated on interconnect samples.

同时，我们对不同线间距以及不同线宽的互连线结构的电特性进行仿真，并且进行相应的TDDB失效测试。

The regressive equation between rape feed, cylinder line speed, cylinder length, and threshing and separating rate is established based on the test results using DPS and is simulated.

运用DPS数据处理系统对试验结果进行处理，建立了油菜喂入量、脱粒滚筒线速度、脱粒滚筒长度与脱粒分离率的回归方程，并进行了计算机仿真。

Also the configuration of holes on coaxial cavity inner wall is designed and simulated to couple with radial transmission line then coaxial line.

为使输出谐振腔的特性阻抗有很好的均匀性，设计了腔内壁通过径向传输线与同轴线耦合的结构；模拟和比较了其不同结构的特性参数，得到了较为理想的结果。

The power line channel noise is simulated by MATLAB and the attenuation is simulated through the channel transmission module of FIR filter.

利用MATLAB及用FIR滤波器做信道的传输函数模型对信道噪声和复衰减特性分别进行了建模。

And recovery efficiency obtained by stream line method as well as oil saturation method can better reflect the actual effect of the simulated ASP flooding.

流线法和含油饱和度法所得的采收率值能较好地反映模拟三元复合驱效果的实际。

Simulated studies and on-line control of plastic extruder temperatures give satisfactory results.

仿真和对温度的实时控制均给出了令人满意的结果。

In this thesis, a multi-function railway production line in an iron and steel enterprise is systematically simulated, in order to realize organization optimization, find out bottlenecks, predict processs capacity, improve equipment efficiency, and finally improve the capacity of the whole line.

本文对某钢铁企业的轨梁万能生产线进行了仿真研究，以达到优化组织生产、找出制约瓶颈、确定工序能力、提高设备效率以及持续提高万能生产线生产能力的目标。

Then, the gained network model is trained and simulated. The result of simulation shows that BP neural network which is used in monitoring furnace tangential fluid field by acoustic method on line is feasible.

然后，对该网络模型进行训练与仿真研究，结果表明，BP网络可以快速、准确和稳定地映射炉膛四角切圆流场特性，把BP神经网络应用于声波法监测炉膛切圆流场的在线监测具有可行性。

mtf simulated by directly measuring the line spread function. the dashed line is the mtf calculated from eq. (4).

直接测量线展函数模拟的MTF，点划线是由方程（4）计算的MTF。

For the chrome refractory, the corrosion rate in three iron phosphate melts containing simulated HLW waste was under 0 1mm/ day at the melt line.

对氧化铬耐火材料来说，其在三种含有模拟HLW废料的铁磷熔体中的熔线腐蚀速度小于01mm day。

The simulated seeding lines deviate from the designed line due to transport by horizontal wind fields.

从结果分析发现，实际形成的播云线受水平风场输送作用，与设计的航线产生了偏离；

The forging processes of the both kinds of billets were simulated by contrast with FEM and the distributions of their velocity, strain and fibre flown line were gotten.

然后采用有限元方法，对圆柱形和锥台形两种坯料的成形过程进行对比模拟，进一步得到了它们在成形过程中速度场、应变场和金属纤维流线的分布规律。