simulation process的例句大全

Numerical simulation on deposition process of duplex thermal barrier coating by plasma spraying

等离子喷涂双层热障涂层沉积过程的数值模拟

Thermal crack is the main form of the crack of mass concrete. To control the thermal crack, the simulation analysis on hydration heat of mass concrete and crack control during construction process become an important research subject.

温度裂缝是大体积混凝土裂缝的主要存在形式，为控制温度裂缝，对大体积混凝土在施工过程中的水化热进行仿真分析与裂纹控制就成为一个重要的研究课题。

Investigation of thermal cracking process of n-decane by molecular dynamics simulation

正癸烷热裂解的分子动力学模拟研究

Base on the actual welding thermal cycles curve of rail through air pressure welding, welding themal cycles process was simulated by Gleeble thermal simulation tests.

通过实测钢轨气压焊的焊接热循环曲线，并以此作为基础数据，采用Gleeble热模拟试验的方法模拟钢轨在气压焊工艺条件下的焊接热循环过程。

Based on the results, the process calculation of thin film evaporator was realized by synthetically considering the optimum feed rate derived from CFD simulation.

以此为基础，综合考虑CFD数值模拟得出的最佳进料量要求，实现薄膜蒸发器的工艺计算。

Mathematical Simulation for Thermal Diffusion Process of the Power Plant Cooling Water in the Lake and Reservoir

电厂冷却水在湖泊和水库中热扩散过程的数学模拟

Numerical simulation based on mathematical model of distillation process in thin film evaporator and parameters analysis

基于薄膜蒸发器蒸馏过程数学模型的数值模拟及参数分析

Whole removal process simulation of temporary support of Jinan Olympic Stadium

济南奥体中心体育场钢结构支撑卸载全过程模拟

By using the computer simulation technique, the theoretical error inthe photodetection process of an optical pattern is correcting.

利用计算机仿真技术对光学图样光电探测过程中存在的原理误差进行修正。

Finite Element Simulation for Blanking Process of Thick Sheet Metal and Optimize Parameter

厚板冲裁过程的模拟仿真及其参数优化

The simulation of extrusion process for HDPE thick wall pipe

HDPE厚壁管挤出过程的模拟

Back-tracking simulation of constant temperature operation switch and dynamic problem of products design in free radical polymerization process is completed and validated in this simultaneous approach.

应用该求解方法进行了自由基聚合反应恒温操作切换的回溯模拟及产品设计动态优化，验证了方法的可行性。

This paper deals with the calculation and simulation done to the pressure on thick cylinder and heat transfer process of the heat exchanger with the application of ANSYS, which is compared with the theoretical calculating.

应用ANSYS软件分别对厚壁圆筒受压情况、换热器换热过程进行计算模拟，并与理论计算结果进行比较讨论。

This paper presents a simulation model of a thermofluid system, which is based on combined neural network and process mechanism characteristics.

构建了一种基于复合神经网络和过程机理特性的热流体系统仿真模型。

Verification indicate this simulation system can simulate slab heating whole process and optimize slab running velocity and temperature condition schedule of furnace operation and provide on-line control with optimum data.

验证表明，该系统能有效地模拟钢板在炉内加热升温的全过程。可以对炉辊速度和炉区温度进行寻优计算，为在线控制提供辊速及炉温制度最佳数据。

Numerical simulation of creep-damage failure process of concrete under sustained tensile loading

拉伸载荷作用下混凝土蠕变-损伤破坏过程数值模拟

The characteristics for ASTG with faults in the excitation system will appear in good working order. Simulation results of steady state operation and transient process of an asynchronized turbogenerator demonstrate that an asynchronized turbogenerator has a lot of advantages over traditional synchronous generator for power system.

以上异步化汽轮发电机励磁故障下稳态运行和暂态运行的仿真结果，显示了异步化汽轮发电机具有运行方式灵活的特点，具有显著优于传统同步汽轮发电机的运行特性。

And design of the temperature sensor and output circuit simulation of thermoelectric boiler heating process.

并设计了温度传感器和输出等外围电路，模拟了热电锅炉供热的过程。

This paper introduces the thermal simulation analysis process of a telecommunication base station.

介绍了某通讯基站热仿真分析的过程。

Molecular Dynamics Simulation of Thermal Response Process of Near-Field Thermal Storage System

近场热记录系统热响应过程的分子动力学仿真