slab thickness的例句大全

The production technology of adhesive polychloroprene rubber abroad was reviewed with 23 references. The differences in crystallization rate, solution adhesiveness, service life and slab thickness between domestic adhesive polychloroprene rubber ( LDJ 240) and foreign analogs ( A-90) were discussed.

比较了国产粘接型氯丁橡胶（LDJ240）与国外类似产品（如A-90）在结晶速度、溶液粘度、适用期和胶块厚度等方面的差别。

There are two ways to resolve the punching failure problem of reinforced concrete flat slab: increasing slab thickness, increasing concrete strength, enlarging column section ( setting column cap), distributing stirrup or bent bar.

解决钢筋混凝土无梁楼盖柱顶冲切问题的常用方法有：增加板厚、提高混凝土强度、加大柱的截面（设置柱帽）、配置箍筋或弯起钢筋。

According to different feature of CSP, FTSC and QSP, the production of the above processes was compared and the influence of caster type and slab thickness on the production were analyzed.

针对CSP、FTSC、QSP三种薄板坯连铸工艺不同特点，比较了它们的生产能力，分析了薄板坯连铸机型与铸坯厚度对生产能力的影响。

Based upon the equations of tension in continuous rolling, a steady state mathematical model is established, and the variation of thickness and tension with variations of roll gap, roll speed, slab thickness and hardness calculated with an electronic computer.

本文以连轧张力公式为基础建立了稳态数学模型，在电子计算机上计算了分别改变辊缝、轧辊速度、坯料厚度和坯料硬度时，厚度和张力的变化值，即影响系数。

Design slab to determine the slab thickness and reinforcement details. Discuss alternative slab systems.

设计一楼版并求取此楼版之厚度与配筋细节, 并讨论可替代的楼版系统.

AX-100L Slab Thickness Machine is adopted gantry linkage structure, autofeed driven by trolly screw mandrel and America EMERSON transducer to adjust the speed steplessly.

AX-100L大板定厚机采用龙门式连体结构，台车丝杆驱动自动走刀，并采用美国爱默生变频器可进行无极高速。

Study on the Solidified Sheel Thickness of Slab in Contunuous Slab Caster

板坯连铸机凝固层厚度的研究

Taken bovine muscle for example, the influence of operation conditions, such as surface temperature of the material being dried, chamber pressure and thickness of slab, was analyzed based on the drying dynamic model and the exergy loss model.

结合升华干燥动力学模型和损失分析模型，以牛肉为冷冻干燥过程的模型物料，计算了物料表面加热温度、干燥室压力和物料厚度等操作条件的变化对升华干燥过程损失的影响。

The effect of thickness of slab on the seismic performance of super high-rise building structure

楼板厚度对超高层结构抗震性能的影响分析

It is pointed out in the existing literatures that residual stress is linear distribution that is disadvantageous to stability of structure, because it can clearly reduce effective thickness of slab in bended zone under outer load.

这种纵向残余应力分布不同于现有文献提出的线性分布，对结构稳定性较为不利，使弯曲区的板在外荷载作用下的有效厚度明显地减小。

The movement of phase-change interface, the heat flux rate of the boundary, and the relationship of the thickness of slab and the predicted time of solidification under different cooling conditions were obtained.

获得了该蓄冷介质在板式蓄冷器中凝固时的相界面移动速度，边界面热流密度随时间变化的规律，及不同工况下蓄冷板厚度与预测蓄冷时间的关系。

How to determine the thickness of cast-in-situ slab of house rationally

住宅现浇板板厚的合理选择

Thickness of Concrete Slab Interlocking Mattress under Action of Waves

波浪作用下混凝土联锁排稳定厚度

Method of calculating critical spalling and penetration thickness of concrete slab of block under accident impact

事故型撞击混凝土板的临界震塌与贯穿厚度计算方法

For the same steel grades and the same thickness of slab the defects of sheets produced by CSP hot strip is 60% higher than that produced by conventional hot strip.

在相同的钢种和板厚条件下，邯钢CSP热轧板卷生产的冷轧板缺陷率比传统工艺热轧板卷生产的冷轧板缺陷率高62%。

In order to improve the conventional method for determine thickness of base slab of the water gate, the auther has devised a optimun design process with computer programme.

闸底板优化设计为了改变过去一贯凭经验确定闸底板厚度的方法，本文以自编程序通过电算对闸底板进行优化设计，从而经济合理地确定闸底板的厚度。

Collapse is the most representative accident in highway tunnel construction. METHOD OF CALCULATING CRITICAL SPALLING AND PENETRATION THICKNESS OF CONCRETE SLAB OF BLOCK UNDER ACCIDENT IMPACT

在公路隧道施工过程中，塌方是最为常见的典型事故。事故型撞击混凝土板的临界震塌与贯穿厚度计算方法

Safety of Punching Calculation in Codes and the Demarcation Load of Punching and Cutting Ravage for Calculating Thickness of Slab and Height of Foundation

板厚与基础高度按冲切或直剪计算的分界荷载值与规范的安全度

A critical state model calculation was proposed for the dependence of the transport critical current density on the applied magnetic field and the thickness of a slab shape type ⅱ superconducting sample.

给出了第二类超导体临界电流密度随样品尺寸及外加磁场变化的一个临界态模型计算。

The distribution of large-sized inclusions was non-homogeneous along thickness direction of slab, which contents of inner arc slab were obviously higher than those of outer arc slab.

铸坯中的大型夹杂物在厚度方向分布不均匀，内弧含量要明显高于外弧含量。