solid diffusion的例句大全

Investigation on the pseudo eutectic structure formed by solid diffusion of Zn powder and Al powder

Zn粉和Al粉固相扩散形成共晶类组织的研究

The solid diffusion coefficient of lithium ion within insertion-host lithium ion battery of materials LiCoO_2 was determined by capacity intermittent titration technique ( CITT) under different voltages.

采用容量间歇滴定技术在充放电仪上测定了不同电压条件下嵌入型锂离子电池正极材料LiCoO2中Li+的固相扩散系数。

The thermal explosion of Ni-Al system is induced by solid-solid diffusion reaction.

本文初步确定了Ni-Al系的热爆反应是由固固扩散反应引发的。

later on, such mathematical model is also used by people in describing the phenomenon of the competition and blackball of biology grow groups, the process of riverbed transplant and diffusion of a tiny drop on the surface of a solid.

后来在描述生物种群的竞争与排斥现象、河床迁移过程、固体表面上微滴的扩散现象的研究中也提出了同样的数学模型。

New n ￣+ p Shallow Junction Formation Method by Using Solid State Epitaxial CoSi_2 as Diffusion Source

固相外延CoSi2薄膜作为扩散源形成n~＋p浅结技术研究

Crystals in an unsaturated solution dissolve, with subsequent diffusion away from the solid-liquid interface.

当晶体溶解在不饱和溶液中时，分子就会在固液界面处产生相应的扩散。

Oxygen sensor of limiting current type with a porous layer on platinum film electrode to limit the diffusion rate of oxygen was fabricated using the solid electrolyte of nanocrystalline ( 20~ 30nm) YSZ based.

制作了以纳米（20～30nm）YSZ粉体为原料的电解质基片、Pt电极上带有多孔涂层的扩散控制极限电流型氧传感器。

The principle of the limit current type oxygen sensor are briefly described, based on this theory, the porous layers type oxygen sensor is made, which diffusion layer is composed of ZrO_2 solid electrolyte and the porous ceramics plate.

极限电流型氧传感器工作原理是基于稳定ZrO2固体电解质的氧泵作用，通过气体扩散控制供给阴极的氧而得到极限电流。

second, this paper presents a new muscle illustration approach to effectively visualize fibrous structure by leveraging diffusion tensor imaging ( dti) data and example-based solid texture synthesis techniques.

第二，本文提出一种新的利用扩散张量成像技术（DTI）和基于样本的体纹理合成技术，对肌肉纤维结构进行可视化的体图解方法。

measurement of the tortuosity factor of porous solid catalyst using improved diffusion cell

利用新型扩散池测定多孔催化剂的曲折因子

The results show that for a steel plate preheat temperature of 510 ℃ and a 32% Al-7 graphite slurry solid fraction, the Fe-Al compound increases gradually at the interface with diffusion time.

结果表明：在钢板预热温度为510℃、Al-7石墨半固态浆料固相率（体积分数）为32%的条件下，随着扩散时间的增加，复合界面上生成的铁铝化合物逐渐增多；

the results indicate that the transition zone of the joint consists of an α( al) solid solution layer and a si diffusion layer. the thickness of the transition zone varies with the welding conditions.

实验结果表明，钎焊过渡区由单相α（Al）固溶体层和Si扩散层组成，它们的厚度随钎焊条件而发生变化。

Such diffusion process is often affected by the mechanical stresses in the solid.

通常这样的扩散过程是受到固体里面内应力的影响.

The liquidus and solidus in the mushy zone was calculated based on back diffusion and a database for multi-component steel with the thermal-physical parameters depended on composition, temperature and solid fraction.

该模型根据糊状区溶质传输和反扩散理论，基于变热物性参数，采用钢中多组元成分的百分含量计算液、固相线温度。

The growth and maintenance of solid tumors is angiogenesis dependent, including colorectal cancer, The growth of new blood vessels provides nutrients and a means of eliminating metabolic waste products by a process other than simple diffusion.

包括大肠癌在内的实体肿瘤的生长和转移是血管依赖性的，肿瘤通过自身新生的血管为其提供营养，排泄代谢产物，而不能单靠物理扩散。

The main kinetic effects that can influence microsegregation were accounted for in the modeling including secondary arm coarsening, solid-state back diffusion, primary tip undercooling and variable diffusion coefficients according to temperature.

在显微偏析模型中考虑了树枝晶粗化、固相溶质逆扩散、枝晶尖端过冷、随温度变化的溶质扩散系数等影响显微偏析形成的动力学因素。

The variation of the carbon diffusion coefficient at the vicinity of the phase boundary during the process of eutectic solid state phase transformation of the phase boundary was analyzed.

然后分析了碳钢在过冷等温时，相界面共格的固态相变过程中，相界面附近碳的扩散系数变化的情况；

A PFG NMR experiment for diffusion in solid samples in the presence of eddy currents

固态样品中扩散的核磁共振测量

Studies suggested that it has greater thermal diffusion coefficient because alumina high-temperature melt, temperature wave was relatively apt to pass to solid-liquid interface, so that caused the temperature of the interface to gurgitations;

研究表明由于氧化铝高温熔体具有较大的热扩散系数，温度波较容易传到固液界面引起界面温度起伏；

Crystals in an unsaturated solution dissolve, with subsequent diffusion away from the solid-liquid interface .

当晶体溶解在不饱和溶液中时, 分子就会在 固液 界面处产生相应的扩散.