solution heat的例句大全

standard practice for hot rolling mill solution heat treatment for aluminum alloy plate

铝合金板材用热轧固溶热处理标准惯例

The cutting performances of saw blade by solution and non solution heat treating were determined.

对比测定了经固溶处理和未经固溶处理锯条的锯切性能.

The experimental results show that a singlephase austenitic structure and a excellent pitting corrosion resistance are obtained after solution heat treatment at 1050 ℃ for 2h.

试验结果表明，该钢经1050℃保温2h固溶处理后，可得到单相的奥氏体组织，具有良好的抗点蚀性能。

The content of δ phase increases with increasing time of solution heat treatment.

随着固溶处理的时间增加，合金内δ相的含量在增加。

The effect of a solution heat exchanger on the enthalpy COP is also discussed.

另外,分析了溶液换热器的换热效率对吸收式热转换器系统性能系数的影响.

The paper explains the binocular structural of the steam heated lithium bromide absorption refrigerator through a case and shows the structure drawings of the upper cylinder, the lower cylinder and solution heat exchanger.

针对蒸汽型溴化锂吸收式制冷机的双筒结构作了算例说明，绘制出蒸汽型溴化锂吸收式制冷机的上筒、下筒和溶液热交换器图。

The results of experiment are in a good accordance with the simulation results, thus verify the heat transfer law described by the analytical solution of the coupled thermal conduction and groundwater advection model of buried pipe.

研究得到的实验结果与数值模拟结果具有良好的吻合性，从而验证了地埋管热渗耦合模型的解析解所描述的热量传递规律。

The changes were studied after mixing EMD with potassium hydroxide solution by the methods of titration analysis, weight lost in heat and XRD techniques.

利用滴定分析、热失重分析以及XRD方法研究了EMD和KOH溶液混合后的变化。

The heat transfer mode described in this paper is used to research the heat conduction process of coal in coke oven chamber through the heating wall. The numerical solution of the model uses finite difference method by electronic computer.

传热模型用于研究焦炉炭化室内煤料通过炉墙的导热过程，模型用有限差分法由电子计算机进行数值解。

The results show that porous surface tubes can prevent deposit of NaCl within porous surface and have excellent heat transfer properties when the concentration of NaCl solution is lower than critical concentration.

当NaCl水溶液的浓度低于某一临界浓度时，多孔管可以防止NaCl在多孔层内析出，具有高效的传热性能。

The Existence and Uniqueness of the Global Classic Solution to the Cauchy Problem of Semilinear Heat Transfer Equations

半线性热传导方程Cauchy问题全局经典解的存在性与唯一性

The solution is to allow the flippers to cool down without drawing heat away from the rest of the turtle's body.

解决办法就是在鳍的温度降低时，不带走身体其他部位的热量。

We studied the effect of the solution concentration, spin coating condition, and the thermal process ( pre-heated and post-annealed temperature) on the structure of ZnO films.

研究了溶液浓度、旋涂工艺、热处理工艺等工艺参数对ZnO薄膜晶体结构和表面形貌的影响。

In accordance with large temperature gradient in multi-stage turbine channel, an aerothermodynamic method is proposed for varying specific heat solution of S 2 surface to consider precisely the effect of temperature variation on the computed results.

针对在多级涡轮流道中沿流动方向燃气温度变化较大这一特点，为了准确反映出温度变化对气动热力计算结果的影响，提出了一种考虑变比热影响的S2流面的气动热力计算方法。

The thermal current density of dynamical heat is obtained by similitude solution of the boundary layer of laminar flow.

对于空气动力加热，运用层流边界层的相似解法，求得热流密度。

A composition coating for ferrous metal alloy surfaces was comprised of phosphates base solution, heat-resisting pigments and some additives, which could be solidified on the surface of plain steel in ambient temperature without solidification agent.

研究了一种用于钢铁表面的磷酸盐复合涂料，它由复合磷酸盐基液、耐热颜料和一定的添加剂组成，涂刷在普通钢铁表面上可在室温自然固化。

Presents the concept of accessibility analysis for heating networks especially for the multi heat sources and multi loops system, describes a mathematical model for the analysis and its solution based on a mixed generic algorithm.

针对集中供热网，尤其是多热源环形网提出了可及性分析的概念，建立了相应的数学模型并探讨了用混合遗传算法求解的方法。

The integrated boundary layer equations are employed for the solution of the laminar heat transfer of plane plate with stepwise-varying wall temperature and Pr < 1. The Mathematical expressions of the ratio of the thermal to the hydrodynamic boundary layer thickness and the heat-transfer coefficient are presented.

本文采用边界层积分方程组法，求解了Pr

This thesis proposes a method based on the temperature distribution model of inner surface and central axis of the blast furnace, adopts the approximate solution for the thermal conductivity of the solid cylinder containing internal heat source, then obtains blast furnace radial one-dimensional temperature distribution.

根据已获得的高炉内表面和高炉中心轴线温度分布，采用含内热源实心圆柱体的导热近似求解方法，求出高炉径向一维温度分布，从而得到高炉内部整体的三维温度分布模型。

the solution pumps hot water from a power plant through underground pipes to heat exchangers which heat up water in the secondary distribution network and feed it into consumer radiator systems.

该解决方案把热水从发电厂抽上来，通过地下管道至热交换器，热交换器在二级分配网络上将水加热，然后将它流入用户的散热器系统。