sprue的例句大全

The mobility test part comprises a sprue gate, a melting liquid cavity and an exhaust hole.

流动性试验部件包括浇注口、熔液腔和排气孔。

MPI-based analysis of injection molding process and setting of sprue

用MPI分析注射成型工艺确定浇口数量

Influence of Sprue Section on Technological Yield in Investment Casting

直浇道截面形状对精铸件工艺出品率的影响

Design of injection mould with offset sprue opening for large-scale plastic part

大型塑件的偏心浇口注射模设计

Analysis for aluminum ingot casting machine sprue spreader invalidation and improve measures

铝锭铸造机分配器失效分析及改进措施

Detecting and Positioning System of the Sprue on the Barrel of Poison Liquid

剧毒液体灌装机桶口的检测与定位系统

The Principle of Gas Absorption and Slag Removal About Liquid Metal Having Through Sprue and Its Application

液态金属流经直浇道时的吸气、撇渣原理及应用

Effect of sprue designs on the as-cast microstructure of a precious metal ceramic alloy

铸道设计对贵金属烤瓷合金铸态组织影响的实验研究

Computer-aided design of sprue in extrusion die head for plastic profiled bar inner rib

塑料异型材挤出模头内筋流道的辅助设计

Research of relationship of the sprue designing shrinkage cavity of Cr-Ni alloy cast crown bridge.

目的：探讨镍铬合金铸造冠桥铸件缩孔与铸道设计的关系。

Discuss on Structures of Automatic-Sheared Side Sprue for Injection Mold

注射模侧浇口自动切断结构探讨

The Sprue and Gate Design of a Multi-cavities Injection Mold for Special Hooks

塑料扣码多腔注射模浇口的设计

The Defects of the Submarine Gate and Its Maintenance MPI-based optimization design of injection forming sprue

潜伏式浇口的缺陷及维修基于MPI的塑件浇口优化设计

MPI-based optimization design of injection forming sprue

基于MPI的塑件浇口优化设计

Here is the cast faceplate with the gate and sprue still attached.

以下是与门面板和浇道演员仍然重视。

The injection mold with double parting surfaces was usually used in the multi-cavity structure and pin sprue injection system.

双分型面注射模，常用于一模多腔、点浇口形式浇注系统的注射模。

Annular secondary flow at die entrance, which was perpendicular to sprue, was proved in the experiment.

实验证实PP-R熔体在入口区发生了垂直于主流道方向的环向次级流动。

Normal small intestinal mucosa is seen at the left, and mucosa involved by celiac sprue at the right.

左侧为正常小肠黏膜，右侧为脂肪痢黏膜。

To decrease the casting pinholes, there should be higher pouring temperature and a suitable sprue height and area.

为减少铸铝件的针孔，铝合金消失模铸造应有适当高的浇注温度和合适的直浇道高度及面积，并尽量采用空心直浇道。

The system includes sprue, runner, gate, overflow launder, venting launder.

该系统包括压铸模浇注系统的直浇道、横浇道、内浇口、溢流槽和排气槽。