static pressure的例句大全

Vapor pressure data for five salt solutions with single solvent were measured at five temperatures from 328.15K to 363.15K by using static-twin ebulliometer and they were correlated by the combination of unitary model with equations of state ( EOS).

在328.15K到363.15K间用静态-双沸点仪测定了5个温度下5种含盐单一溶剂体系的蒸汽压数据。

Design of Noninvasive Measurement of the Pressure of Esophageal Varices with Static Compensation

静补型无创食管曲张静脉测压仪的设计

simulation and experiment on static characteristic of water hydraulic proportional pressure relief valve

纯水比例溢流阀静态特性的仿真与试验

the study of static and dynamic characteristics of superhigh pressure relief valves

超高压溢流阀静动态特性的研究

The reactor pressure vessel composed of spherical top and lower heads, upper and lower flanges, bolts, cylinder and two O-rings, as a static indeterminate system has been studied.

本文将反应堆压力壳的球顶盖、上下法兰、螺栓、筒体及双道O形环作为一个超静定系统进行了应力和变形分析。

Sure everyone a static and we require aspirin once blood pressure is controlled.

当然一旦血压得到控制以后,每个人还都需要使用抑制剂和阿司匹林.

Sweet orange peel oil was taken as experimental material of extraction condition. This paper systemically studied the influence of grind dree, temperature, pressure, static extraction and dynamic extraction on the extraction rate. The bases for batch process were provided.

采用甜橙皮作为实验材料，研究在超临界状态下，粉碎度、温度、压力、静态萃取与动态萃取对油脂萃取率的影响，为批量生产提供了依据。

Study on Determination of Tire Contact area Pressure Distribution under Static Load

静负荷下轮胎接地压力分布测试的研究

coulomb theory and mononobe theory are usually used to calculate static and seismic earth pressure respectively in engineering practice.

通常，设计人员采用库仑理论或朗肯理论计算静土压力，采用物部理论计算地震土压力。

Static exercise increases blood pressure and heart rate, but it may change myocardial contractility.

静态运动具有升高血压和心率的作用, 也有可能引起心肌收缩力的改变.

the relationship between the drying rate and drying air temperature, superficial air velocity, static bed height, pulsation frequency and perforation rate of screen were developed. also, the relationship of pressure drop with static bed height was obtained.

提出了干燥速率与干燥介质温度、气流表观速度、床层静止高度、气流脉动频率以及气流分布板开孔率之间的关系，同时也得出了床层压降与床层静止高度的关系。

An Approximation for Evaluation of Extra-static Pore Water Pressure in Fine-grained Mud Layer of Tailings Fill Dam

尾矿坝细粒泥层内超静孔隙水压力的近似估算方法

Before the weather changes, there are changes in barometric pressure and in the static electricity in the air.

在天气变化之前，空气中的气压和静电是有变化的。

The process of accumulation and dissipation of extra-static pore water pressure in fine-grained mud layer of tailings fill dam constructed by up-stream method is analysed.

本文对上游法修筑的尾矿坝的细粒泥层内超静孔隙水压力的积累和消散过程进行了分析。

Taking the XRL aluminium bushing complex rubber roller as one example, the paper touches on the compressive stress and stretch stress of rubber and aluminium tubes running in pressure by application of static and dynamic stress and the strain theory.

本文以XRL型铝衬套复合胶辊为例，运用静态和动态应力、应变理论，分析了运转过程中胶管、铝管承受加压后所产生之压缩应力及拉伸应力情况；

Computational fluid dynamics methods were applied to obtain the static velocity distributions in the main stage channel of the valve with different structure parameters or different pressure and flow rate.

应用流场数值模拟技术，在不同结构参数、压力、流量等条件下，对先导式纯水溢流阀主阀流道内的流场流态进行动态仿真。

Usually pilotless aircraft altitude is measured indirectly by measuring static air pressure.

目前常用的办法是通过测量大气静压来间接测量无人机高度。

The effect of flowrate arises mainly from valves 'pressure drop~ spool displacement static characteristic in the case of small d_x. The result of experiments for the effect analysis agrees with the authors' values.

在小d x区域，流量对阀芯关闭时间的影响主要取决于阀的静态压差&阀芯位移特性，在这些方面试验结果和作者的理论分析是完全一致的。

Static adjustment and examination of accuracies for the solid state resistance pressure sensor in noncontact measurement of intraocular pressure

非接触眼压测量用固态压阻传感器的校准及精度

This paper describes a simplified method for calculation of box-section girder composed of thick plates under wheel pressure acting at cantilever part of its bottom flange, welding technology used. as well as approximate distribution of static stress, residual ones and its fatigue performance.

本文介绍了轮压作用在下翼缘外伸悬臂板上的厚板焊接箱形梁的简化计算方法、施焊工艺以及该梁的静力、疲劳性能和焊接残余应力的分布概况。