strain ratio的例句大全

Treatment of Abnormal Value of Plastic Strain Ratio r Value about Metal Thin Steel Plate

金属薄板塑性应变比r值异常值的处理

Equiaxial prestrain will obviously decrease the forming limit on positive strain ratio zone, while it slightly improves the forming limit on negative strain ratio zone.

等双拉预应变将明显降低正应变比区的成形极限，对负应变比区的成形极限有所提高。

Effect of Cold Rolling Process on Plastic Strain Ratio-r of SUS 430 Ferrite Stainless Steel

冷轧工艺对SUS430铁素体不锈钢塑性应变比r值的影响

with the sample workpieces lubricated during ferritic rolling and coiled at high temperature, the maximum plastic strain ratio of sample was 1.38 with elongation over 50%.

采用铁素体区润滑轧制和高温卷取，r值最高为1.38，延伸率达到50%以上。

the strain ratio has little influence on the shape memory properties.

拉伸比对形状记忆性能影响不大。

Through stress, displacement straight-line picture and the strain ratio of two supports before it cracks, the stress and displacement fields of symmetric and asymmetric samples under static conditions are observed.

通过裂纹启裂前的应力、位移等直线图及两个支座的应变之比，观察静态条件下对称试件及非对称试件裂纹面两端的应力场和位移场。

Plastic strain ratio calculation of metal sheet from low-resolution texture analysis

从低分辨织构计算金属板材的塑性应变比

However, the maximum displacement ratio for the eccentrically loaded short column is generally bigger than the ultimate strain of concentrically loaded short column.

在相同的长细比下，随着偏心率的增加，试件的承载能力降低，极限纵向变形率降低，但总体来说，偏压短柱的纵向变形率比轴压短柱的极限应变要大一些。

Abrasion and mechanical properties test of concrete have shown that the degree of abrasion dependent on initial abrasion ratio, flexural strength and limit strain.

从混凝土磨蚀和力学性能试验得知，水工混凝土的磨蚀程度依赖于混凝土的初始磨损率，抗拉强度和极限拉伸变形值。

Furthermore, the modulus of elasticity, the peak strain and the ratio of proportion limit and prism strength for the former are also higher than those for the latter. For this reason the former concrete has a higher crack resistance.

前者的弹性模量、峰值应变、比例极限与棱柱强度之比也较后者高，因此前者具有更高抗裂性。

as the stress increases, the creep strain at rupture increases, whereas the ratio of the primary stage in the total creep procedure decreases.

随着应力的增大，蠕变断裂时的应变也增大，而第一阶段在整个蠕变过程中的比例减小。

in creep buckling analysis, a ratio stress-strain method is proposed.

在蠕变分析中，本文提出了比应力-应变方法。

for the analysis of creep buckling, a ratio stress-strain method is proposed and the critical ratio stress is solved accordingly.

解出比应力值后，可以或是给定载荷确定临界时间或是给定时间导出可承受的载荷。分析了圆柱壳体的轴压蠕变屈曲。

Critical dynamic stress ratio and dynamic strain analysis of soils around the tunnel under subway train loading

地铁列车荷载作用下隧道周围土体的临界动应力比和动应变分析

Strain CD4 could adjust system pH from pH3 to neutral, and the COD removal ratio reached about 50%.

多孔菌属的菌株CD4可以将体系pH由pH3调节到中性，COD去除率达到50%左右；

For an elastic material, Hooke's Law states. that the ratio of strain to stress is constant.

对于弹性材料来说，虎克定律表明应力和应变之比是常数。

The article analyzes the basic operating principle of F-P fiber-optic sensor, carries out short-term monitoring on structural strain behind abutment with the sensor, contrasts it's results with monitoring results of vibrating wire indicator, which shows that F-P fiber-optic sensor has higher success ratio and reliability.

分析了F-P光纤传感器的基本工作原理，利用F-P光纤传感器对桥台后结构应变进行了短期监测，并与钢弦应变计的监测结果进行了对比，分析表明：F-P光纤传感器成活率高，可信性高。

The acid production during 3 hours in different divisions was investigated. On 50% division ratio, the acidity could reconvert to level before division after the strain grew for 12h.

对其进行了不同分割比例下3h的产酸情况实验，证实该菌在分割50%后，12h能恢复到分割前的酸度；

The stress strain relationship in different principal stress load direction can be reflected in the anisotropy of tangent elastic ratio or strain increment in load direction induced by unit stress increment in load direction.

不同主应力加荷向的应力应变关系各向异性可以反映在切线弹模以及加荷向单位应力增量引起的加荷向应变增量的差异中。

The result shows that the tangent Poisson's ratio computed with the relationship proposed by Daniel is in conformity with the testing data, but the value obtained by assuming the relationship between the axial strain and lateral strain as hyperbola differs from the testing data.

试验还表明，高压力下的切线泊松比，用但尼尔建议的方法进行计算与实测资料相符，用轴向应变与侧向应变为双曲线关系的假设进行计算则相差较大。