strain theory的例句大全

For rubber-like material half space compressed by a rigid cone, the stress singular field near the tip of the rigid cone is analyzed by large strain theory.

应用大变形理论对刚性锥压缩作用下橡胶类材料半空间锥尖附近的应力奇异场进行了分析.研究揭示，奇异场由两个区构成；

According to the analySis, a dynamic initiation fracture criterion-maximum tangential strain theory is put forward.

据此提出最大周向应变理论作为动态起裂准则。

If the small-ring cycloalkanes are under considerable strain as predicted by the Baeyer strain theory.

如果象拜耳张力学所估计的那样,小环的环烷烃具有相当大的张力.

Control Theory, General Strain Theory and Social Learning Theory, this quantitative study explored the effects of family, school, and peers on the deviant behavior of deaf junior high school students.

本研究主要依据社会控制理论、般化紧张理论以及社会学习理论之观点为基础，探讨家庭、校及同侪因素与国中听觉障碍学生偏差行为之关联性。

the maximum linear strain theory

最大应变理论

Taking the XRL aluminium bushing complex rubber roller as one example, the paper touches on the compressive stress and stretch stress of rubber and aluminium tubes running in pressure by application of static and dynamic stress and the strain theory.

本文以XRL型铝衬套复合胶辊为例，运用静态和动态应力、应变理论，分析了运转过程中胶管、铝管承受加压后所产生之压缩应力及拉伸应力情况；

A Study of Cracking on the Conjugate Crowned Tooth Flank with the Theory of Maximum Tensile Strain

基于最大拉应变理论的共轭鼓形齿面裂纹研究

The prediction values of shear strain and temperature in shear band based on gradient-dependent plasticity are higher than those by use of classical elastoplastic theory.

由于微结构效应，基于梯度塑性理论的剪切带内部的最大塑性剪切应变及最高温度的预测值高于经典理论的预测值。

The Theory of Three-Dimensional Finite Strain Consolidation of Saturated Soil

空间描述的三维有限变形固结理论

Equivalent Strain Tensor in the Gauge Field Theory of Dislocation Continuum

位错连续统规范理论中的等价应变张量

In order to verify the current time-domain buffeting theory, not only the buffeting-induced structural displacements but also the buffeting-induced internal forces at the bottom of the towers were measured by means of dynamic strain gauges in a full model test of the Hangzhou Bay Bridge.

为了进行对现有抖振时域分析理论的实例验证，在杭州湾跨海大桥全桥模型风洞试验中，不仅对抖振位移进行了测量，还通过在塔根布设动态应变片完成了桥塔内力的实测。

The ultimate loading of the thick-wall cylinder based on unified plane-strain slip line field theory

用统一平面应变滑移线场理论求解厚壁圆筒的极限荷载

Application of State Estimation Theory to Observation of Strain Meter Set

状态估计理论在应变计组观测中的应用

Plastic limit load of viscoplastic thick-walled cylinder and spherical shell subjected to internal pressure is investigated analytically using a strain gradient plasticity theory.

基于应变梯度塑性理论，分析了内压作用下厚壁圆筒和球壳的塑性极限荷载。

According to capillary tension theory, the elastic strain energy of porous materials will be released when their capillary water loses completely in the drying precess.

根据毛细管张力理论，多孔材料在干燥过程中，当毛细管水完全失去时，积聚在固体材料内的弹性应变能将释放，导致材料的不连续收缩。

At the same time, from the basic theory of mechanics of materials, particularly expatiate the material secant stiffness of the principal strain direction and the principal stress direction and the element transformation matrix; they provide the theory basis of the procedure presented in this paper.

同时由材料力学出发详细推导了主应变或者主应力方向上的材料割线刚度、单元坐标转换矩阵，为本文程序的编制提供了理论基础。

The thermal activation theory interpreted such a relationship and derived strain rate equation.

利用热激活理论不仅解释了这一关系，还获得了应变速率方程，指出控制合金拉伸形变的微观机制是原子扩散过程。

The nonlinear theory of the active earth pressure produced by the interaction of two media, which are composed of strain-hardening medium and strain-softening medium for the soil masses behind the retaining wall, is studied by using catastrophe theory when the wall back is vertical and smooth.

应用突变理论方法，研究当挡墙墙背竖直、光滑，且墙后土体由应变硬化介质与应变软化介质组成时，两种介质相互作用产生主动土压力的非线性理论。

Based on the liquid film theory of hot crack formation and results of numerical simulation of solidification and thermal strains, equivalent strain is proposed to serve as the criterion for hot cracking.

从热裂产生的液膜理论出发，根据凝固过程温度场和应力场、应变场的数值模拟结果，提出了热裂形成的等效应变判据；

The grain size, temperature and strain-rate dependence of the yield strength of silicon steel under dislocation slip mechanism is obtained by experimental measurements, and the result is interpreted by the theory of thermal activation of dislocation motion.

从实验结果总结出了硅钢在滑移机制下的屈服强度与晶粒尺寸、温度和应变速率的关系，并用位错运动的热激活理论进行了解释。