stress range的例句大全

metal flow takes place within the plastic range of the metal, so that the bend retains a permanent set after removal of the applied stress.

金属的流动发生在金属的塑性变形范围之内，因此在施加的外力去除之后弯曲保持永久的变形。

in general, patients with tension pain neurasthenia performance range, but is closely related with the emotional stress.

总的来说，神经衰弱病人紧张性疼痛表现繁多，但与情绪紧张密切相关。

within the limit of ratio of zero principle tensile stress to optimal stress of concrete, the range of rational vertical prestress values is determined and design procedures for the prestress are provided.

以不出现主拉应力和最佳应力比为界限，确定合理竖向预应力值的范围，并给出竖向预应力设计步骤。

stress analysis of single range holes with simultaneous blasting

单排孔齐发爆破孔间应力分析

flicker noise ( 1/ f noise) in optoelectronic coupled devices ( ocds) is studied over a wide range of bias currents with special emphasis on the influence of electrical stress.

对电应力前后光电耦合器件的闪烁噪声（1/f噪声）进行了实验和理论研究。

this paper presents the key points to the design of these two types of masts and provides the permissible stress and deflection range that should be satisfied in design calculation of a specific application.

文中论述其设计要点，为适应工作条件，在设计计算中应满足相应的许用应力和挠度允许范围等。

Themaxium range of allowable stress under different reliability is given.

文中还给出了对应于不同可靠度下的最大容许应力幅值.

Objective To study the range and change of stress in normal radiocarpal joint.

目的研究正常桡腕关节内应力分布及其变化规律。

Discussion on the Increased Range of Allowable Stress in the Design Code for Industrial Metallic Piping

对工业金属管道设计规范中许用应力提高幅度的探讨

The calculation of stress around the opening of a dam by the program indicates that the quadratic boundary element method has a wide range of applications with high precision.

计算实践表明：二次边界元法有广阔的应用范围及较高的计算精度，且计算准备工作简单，方便易行，程序可在水电工程中推广使用。

Stress changes were in the range of die material allowed, proving that die structure was available.

应力变化在模具材料允许范围内, 验证了模具结构的合理性.

More than 300 smooth and notched specimens of 40 Cr alloy steel undergoing two kinds of heat treatments were used to study the effect of stress triaxiality and temperature on macro-mechanical behaviour and micro-fracture mechanism during the ductile-brittle transition in a range of temperature from 20 ℃ to-196 ℃.

研究了300余件40Cr钢轧制态和调质态试样在20℃至&196℃范围内温度与应力对该材料的韧脆转变力学行为和微观断裂机制的影响。

People under stress tend to express their full range of potential.

处于压力下的人容易发挥自己全部的潜力.

The interfacial failure due to thermal stress will increase with increasing the range of temperature and the number of cycles.

随着冷热循环温度区间温差的增大、冷端温度的降低、循环次数的增多，形成的热应力对材料的界面损伤越严重；