stress rate的例句大全

in addition to tension and stiffness, he said music wire's stress rate is an equal, if not more critical parameter.

他在密歇根州的安阿伯拥有一家钢琴生意，他说琴丝的拉紧率是对等的，如果没有太多的关键参数。

From the continuity equation satisfied by the stress rate and the stress concentration we gain the necessary condition of rupture expansion, and discuss the state of medium in seismic focus region before an earthquake and dynamic expression of stress drop.

由应力变化率和应力集中所满足的连续方程.得到破裂扩展的必要条件，并据此讨论了震前震源区介质的状态和应力降的动力学表示。

The new stress rate is applied to a hypoelastic body experiencing simple shear, there is no oscillation in the stresses and the general normal stress-shear stress relation for superelasticity is also satisfied.

用新应力率对次弹性体简单剪切进行了计算，得到的应力不振荡，且满足超弹性正应力-剪应力普适关系。

A constitutive relation between flow shear stress rate and the relative sliding velocity of shear band is also obtained.

推导了剪应力（率）与剪切带相对错距（速度）的本构关系。

The use of a difference measuring method for the system can reduce the influence of quantization error of A/ D converter, thereby increasing the measurement accuracy of the temperature rise rate and enhancing the accuracy of thermal stress calculation.

该系统中采用了一种测差法，该方法减小了测量中模数转换器的量化误差的影响，提高了温升率测量的准确度和热应力计算的准确度。

The influence of temperature and strain rate on the flow stress of tantalum

温度与应变率对钽流动应力的影响

The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.

研究了变形速度，试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。

Bar-bar tensile impact testing apparatus was used to study mechanical behavior of 20# steel at different strain rates. From the stress-strain curves obtained, it is found that the strain rate effect is distinct.

利用旋转盘式间接杆杆型冲击拉伸试验装置对20号钢进行了三个应变率的冲击拉伸试验研究，得到了材料在不同应变率下的应力应变曲线。

The changes of soil stress and temperature bring out the changes of p, and osmotic potential also causes the change of leaf extension rate.

土壤水势、温度的变化引起膨压（ΨP）的变化，而膨压的变化又引起叶片延伸速率的变化。

The tensile impact experimental results show that the initial elastic modulus and unstable strain of PE fibre bundles are temperature and strain-rate dependent, except for the failure stress of PE fibre bundles.

实验结果表明：PE纤维束的初始弹性模量和失稳应变具有一定的温度和应变率相关性，但是破坏应力变化不大。

Using our design of bar-bar tensile impact apparatus, we have performed an experimental study of SiCp/ Al at the strain rate ranging from 100s-1 to 1000s-1. The complete stress-strain curves of composite under tensile impact was obtained.

对SiC颗粒增强铝基复合材料在应变速率为150～1000s－1范围内的冲击拉伸力学性能进行了试验研究，得到了材料从弹塑变形直至断裂的完整的应力应变曲线。

The pipeline steel with strain-based design is usually characterized by high initial work hardening rate, good ductility, and low yield stress to tensile strength ratio.

抗大变形管线钢就是基于应变设计的方法得到的具有连续屈服、较低的屈强比、较高的加工硬化指数以及均匀塑性变形延伸率等特性的管线钢。

Effect of Tensile Strain Rate on Stress-Strain Properties of Synthetic Filaments

拉伸应变速率与化纤长丝应力应变关系探讨

The enhancement mechanism of hybrid fiber was investigated by observing the SEM photos of cross section. The main factors affecting the hybrid effect coefficient were presented and the relationship among this coefficient, transverse tensile strength and stress relaxation rate of NAFC materials was discussed.

利用扫描电镜（SEM）分析了材料拉伸断面形貌，探讨了混杂纤维增强机制，分析了混杂效应系数的主要影响因素，研究了混杂效应系数与材料横向抗拉强度和应力松弛率之间的关系。

The experimental items of the tests are tension of constant strain rate, creep at constant stress, and strain controlled low cycle fatigue of constant strain rate.

实验项目有等应变率拉伸、等应力蠕变和控制应变幅的等应变率塑性循环。

Temperature and strain rate dependence of yield stress of Al-Li-Cu-Mg-Zr alloy

Al－Li－Cu－Mg－Zr（8090）合金屈服强度与变形温度和速率间的关系

According to the experimental results of steel compact tension specimen, a empirical relationship between AE energy rate and stress intensity factor range was formulated at the stage of stable crack growth.

通过试验，得出了紧凑拉伸试样在裂纹稳定扩展阶段声发射信号能量率与应力强度因子幅值之间的关系式。

The stress corrosion cracking ( SCC) susceptibility of 2091 Al-Li alloy was studied under tension at slow strain rate by quench aging in various media.

用慢应变速率拉伸试验研究不同冷却介质淬火并时效的2091合金的应力腐蚀敏感性.用透射电镜观察合金的微观组织.结果表明，晶界无析出带（PFZ）随淬火速度的提高而变窄；

The experimental results show that 0.2% yield shear stress, ultimate shear stress and 0.2% yield tensile stress, ultimate tensile stress under torsion tension combined high strain rate decrease with increasing temperature.

试验结果表明：该材料在高应变率扭拉复合加载下的名义剪切屈服强度、剪切强度极限和名义拉伸屈服极限、拉伸强度极限均随温度的升高而降低。

Using conventional logging data to calculate terrestrial stress time difference and single well stress, and corrected, The actual application error rate is less than 8%.

通过应用常规测井数据计算横波时差和单井地应力，并进行矫正，实际应用误差率小于8%。