stress surface的例句大全

In the shape analysis of stress surface contour of 3D footprint, the consistency of datum plane cannot be strictly controlled, so a descriptor insensitive to perspective transform is needed.

在立体足迹的重压面边界围线的形状分类和识别中，由于不能严格控制基准面方向的一致性，必须采取对透视变换不敏感的描述方法。

A research on the effect of cutting force and surface residual stress of work piece on tooling wear

刀具磨损与切削力及工件表面残余应力的研究

Stress Intensity Factor Research about a Thick-walled Cylinder with an Internal Semi-elliptical Surface Crack

厚壁筒内表面椭圆裂纹的应力强度因子研究

A test-piece is shaped into a beam of about 20 cm length and its upper surface is highly polished. The test-piece is bent convex upwards; on that occasion one had better plan the maximum bending stress to be about 20 bar or less.

试件加工成20cm长的梁，并高度磨光其上表面，把它弯成向上凸，其最大弯曲应力宜为20bar或稍小一些。

By use of V notched round bars with different theoretical stress concentration factors as finite element models ( FEM) of tensile screw threads, stress intensity factors ( SIF) of surface cracks of screw threads are calculated.

将拉伸螺杆简化为理论应力集中系数Kt不同的带V形缺口圆杆，采用裂纹尖端为20节点奇异单元的三维有限元模型，对螺杆半椭圆表面裂纹的应力强度因子进行了计算。

In order to survey the degree of stability of dangerous rock slope and get reliable theoretical foundation about the slope restoration, earth stress measuring is performed in the engineering project through drilling on the slope surface.

为了研究边坡岩体的稳定状况并为某危岩边坡的治理工程设计与施工提供可靠理论依据，在边坡表面打进水平钻孔进行地应力测量。

Tectonic force source and seismic source stress field investigation on the coating's static shear stress and surface tension

构造力源和震源应力场涂料静切力及表面张力的研究

The Stress from Thermal Impact with a Rapid Temperature Drop in the Concrete Surface

混凝土表层的冷击应力

Study on Temperature Stress Intensity Factors of Gun Barrel with Internal Surface Cracks

带内表面裂纹的身管温度应力强度因子研究

The temporal response of calm sea to surface wind stress

海面对风应力的非定常响应

The measurements indicate that the weak-link of the PET fibres is the defeats on surface layer and their propagation and that the mechanical properties of fibre weak-links are low stress, low strain and low work of rupture according to the analysis of the typical tensile curve.

结果表明，涤纶纤维的弱节主要是表层缺陷及其扩展所引起的，其力学性能为低应力、低应变、低断裂功特征。

The surface characteristics of the human temporomandibular joint ( TMJ) disc specimens in normal 6% stress relaxation and 0.05 mm/ s tensile yield strain conditions were observed with the scanning electronic microscopy.

用扫描电镜观察正常人体颞下颌关节盘加载后阶跃应变为6%时应力松弛和以0.05mm／s加载拉伸破坏后的关节盘表面特征。

The stress field and the ground surface deformation associated with a vertical tension crack in a semi-infinite ground medium

半无限地下介质中与垂直张性裂缝相关联的应力场和地面形变

The thermoelastic generation stress pulse in a semi-infinite strongly absorbing solid when a pulse laser is incident on its surface is studied.

对梯形激光脉冲入射到半无限强吸收固体媒质中热弹激发的超声应力脉冲进行了研究。

This specially designed device is able to measure the stress response while the propellant surface is compressed at a constant rate.

在此技术中，采用特殊设计的装置测量出推进剂表面以恒速率受压时的应力响应。

Calculation of stress intensity factor about a thick-walled cylinder with an surface crack under autofrettage stresses

残余应力下厚壁筒表面裂纹的应力强度因子计算

The analysis shows that when same thick glass sheet is produced in same forming conditions, the transverse shrinkage stress caused by surface tension and longitudinal dragging has little effects on shrinkage of glass ribbon behind the last pair of top rollers.

分析表明，生产同一厚度玻璃，在成形条件相同时，表面张力与玻璃纵向拉引产生的横向收缩对末对拉边机后玻璃带收缩率的影响不大。

An Investigation of the Determination of Three-dimensional Stress in Metal Surface

金属表层三维应力测定的研究

Numerical simulation of surface crack propagation considering the crack closure effects and the three-dimensional stress constraints

考虑闭合效应和三维应力约束的表面裂纹扩展模拟

Through heating, raising moisture content and improving the surface condition of bamboo, plasticity of bamboo can be increased, bending stress can be reduced to opposite direction.

竹材通过加热、提高含水率和改善竹材的表面状态等三种途径来增加其塑性、减小展平时的反向弯曲应力。