stress surface的例句大全

In this paper, the maximum stress of the surface plate glass in container impacted inhorizonal direction is determined by theoretical analysis and experiments.

通过理论和实验的方法，分析集装箱中表面一块平板玻璃受到横向正面冲击的最大应力。

The results indicated that: ( 1) plant height and tillering number decreased, and root length, root surface area, root volume and rootlet number increased under drought stress;

结果表明：①干旱胁迫下水稻株高降低、分蘖数减少，根系则表现出主根伸长、支根增多、根表面积和根体积增加；

In the uninjured side, the stress only locally changed in lateral of posterior oblique surface.

健侧髁突表面应力分布未发生明显改变。

According to the degree in which the original ground surface has been denuded, the magnitude and the angle of inclination of the major principal stress can be calculated ( such as the magnitude of the intermediate principal stress).

根据原始地面遭剥蚀的程度，可以大致地估算最大主应力和中间主应力的量值和方向；

In order to eliminating the stress concentration areas on the air channel surface, change the sharp edge to a round transition structure, calculate the thermal stress distribute with the same temperature and constraint condition.

为消除气箱棱边的应力集中区域将气箱的原棱边结构改为圆角过渡，在相同的壁面温度和约束下计算应力场。

The Influences of Surface Shear Stress Peak Value of Semi-Rigid Base Course Asphalt Pavement Structure

半刚性基层沥青路面面层剪应力峰值的影响因素

The measuring principle and method of surface stress for toughed glass

钢化玻璃表面应力的测量原理与方法

Effect of the earths surface denudation on the initial stress back analysis of rock masses;

影响油藏保存的地质因素主要包括风化剥蚀、差异性抬升和断裂活动。

The optimized stress on the round arc surface of bottom griddle comb is 7.7 MPa more than former stress;

作用在下层梳子圆弧面上的等效应力较优化前增加了7.7Mpa；

A clamp using this kind of surface can effectively increase the touch area, reduce the touch stress and increase the friction. Thus it can prevent the clamped object from being damaged and the stability is also reliable.

以该柔顺表面为主制成的夹具能有效地增大接触面积，降低接触应力，增加摩擦力，从而可以防止夹伤或夹坏被夹持物，并且提高夹持的稳固度。

Surface and interfacial stresses are slightly affected by FeAl layer. Therefore, when choosing thick ceramic layer and thin Al layer, there are appropriate stress distributions at surface and interfaces, and the mechanical properties of coatings can be strengthened.

FeAl层对表面应力和界面应力影响较小.因此，当选择较厚陶瓷层和较薄铝层时，涂层内将具有较优的表面和界面应力分布状态，从而可提高涂层力学性能。

the cross star structure is a kind of superficial structure, which occurs in the dipping steeply rock nearby its surface, and has formed by the effect of tectonic stress and gravity at the same place but not at the same time for its different parts.

研究表明，十字星构造是构造应力和岩体重力复合作用的产物，是一种发生在陡倾岩层临空部位的表生构造。

The cyclonic stress on the sea surface and the strong mixing processes forced by the typhoon play an important role in the processes of the heat, energy and mass exchange between the upper ocean and the deep ocean.

台风产生的海面气旋式风应力以及强烈的混合过程，对上层海洋与深层海水之间的热量、能量和物质交换产生重大影响，因此研究海洋对于台风过程的响应特征具有重要的科学意义。

Influences on surface deformation by the three different stress source models in volcanic area

三种压力源模型对火山区地面变形的影响

Analysis of thermal spray particle's residual stress after deposit and curdle on the substrate's surface

热喷熔滴在表面沉积凝固后的残余应力分析

Off load rock mass of excavated slope can be divided into 3 zones: surface loose zone, off load deformation zone and stress adjustment zone.

开挖边坡卸荷岩体可为3个带：表层松动带、卸荷变形带以及应力调整带。

The contact element method and original stress method were used to analyze the elastic plastic contact problem of wheel/ rail with measured surface micro roughness. The distribution of surface contact pressure on the rail was obtained.

采用接触单元方法，结合初应力法，采用测量获得的表面微观粗糙度，对轮轨弹塑性接触问题进行了研究，获得了轮轨的表面接触压力分布等结果。

Under adequate water stress condition, the young field grapevine surface of leaves are dealt with betaine and FA, the effect is not obvious.

在非水分胁迫条件下，对田间葡萄幼树进行处理，叶面施用甜菜碱和FA旱地龙后对葡萄新梢生长无显著影响；

The amount of deformation and tooth contact line stress curves are extracted from the finite element calculation results. That is used to understand the contact stress distribution of the whole tooth surface in the process of contact. And the main areas of modification are determined.

提取了有限元计算结果的变形量、全齿面接触线应力曲线图，以了解全齿面在整个接触过程中的应力分布情况，确定修形的主要区域。

And the three dimensional surface of stress-strain relation in the whole stress field ( p, q) were drawn through visualization.

通过可视化绘出了在整个应力场（p，q）中的三维应力-应变关系曲面和屈服轨迹。