support cylinder的例句大全

Hydraulic Support Cylinder Bore Enlarge Once More Use

液压支架中缸体的扩镗再利用

Electrical and Hydraulic Control System of Special Honer for Hydraulic Support Cylinder

液压支柱缸筒专用珩磨机电液控制系统

The structure design of mirrors and its support is reasonable. Thirdly, the Stiffener parameters of thin-walled cylinder were studied.

然后，对薄壁圆筒的加强筋结构参数进行了研究，发现了加强筋参数的影响规律。

An improved spiral escape sliding ladder consists of a main cylinder body, a spiral sliding ladder, a support board and a sliding way.

一种改进的螺旋逃生滑梯，包括主柱体、螺旋滑梯、支撑板、滑道；

The lifting oil cylinder can not work normally due to the wear of support guide ring or gluing off release at the connecting position between the support guide ring and the inside wall of cylinder after the lifting oil cylinder used for a period of time.

在举升油缸使用一定时间后，其支承导向圈磨损或支承导向圈与缸简内壁的联接处出现脱胶剥离，致使举升油缸不能正常工作。

Secure the engine support on the cylinder block.

将发动机支架固定在气缸体上。

the probe puncture guiding device comprises a support, a cylinder, a lantern ring, two connecting rods and two clips.

所述探头穿刺引导仪包括一支架、一柱体、一套环、两个连接杆以及两个夹子。

the gantry, a guided and supported bearing system, to support the load and the rodless cylinder to drive the gantry carriage. more. . .

在龙门，一引导和支持轴承系统，以支持负载和无杆气缸驱动龙门运输。更多…

single cylinder with imported balance valve for front support elevation , hoist down by gravity , low energy consumption .

单缸前支前幅，重力下降，能耗低，进口平衡阀。

The rugged design of this steam engine is unusual in combining the functions of crosshead guide and cylinder support in a single set of columns.

崎岖的设计，这蒸汽机是不寻常的结合，职能十字头，引导和支持在缸一套单一的栏目。

The second injection pump drive and installation, the secord injector arrangement, the cylinder head and rocker arm support modifications are described in detail, as well as the installation of crankshaft rotation angle grating disc which is necessity for combustion research in cylinder pressure sensor.

详细论述了喷油泵的安装和驱动、喷油器的布置、气缸盖和摇臂座的改造以及气缸压力传感器、曲轴转角信号光栅盘轴的安装。

This paper is based on result of visioplasticity test of thick cylinder during axial pressure with support of mandrel, velocity field and strain rate field were established.

本文根据厚壁圆管在两端夹持、有芯轴支撑、轴向加载的条件下，视塑性试验流线分布的结果，建立了变形区域的速度场和应变速率场。

remove cylinder attaching bolts and remove cylinder from support plate.

拆卸分泵附接螺栓并从支撑板上拆卸分泵.

A study on forming limit of thick cylinder under axial pressure with support of mandrel

厚壁管有芯镦锻成形极限的研究