surface deformation的例句大全

the mean number of phonons of surface polaron via acoustic deformation potential

声学形变势表面极化子中的平均声子数

surface plastic deformation always occurs during the whole tool wear process. the drastic wear of the flank surface on cutting tool produces white layer in workpiece surface.

工件表面的塑性变形在刀具磨损整个过程中都会发生，加工表面白层在刀具后刀面磨损剧烈时产生，但X射线分析没有发现相变。

the measurement technique of its surface pressure distribution is introduced in this paper, which employs a pair of laser range finders to measure the deformation of asbestos paper.

本文介绍一种利用激光扫描石棉纸的变形量，来测量气缸垫面压分布的技术。

volume of fluid method was employed to capture the free surface of the wave. the model reaches a comparatively high accuracy, based on which propagation and deformation of the wave can be well described.

模型采用VOF法追踪自由表面，并有多种紊流模拟方式可供选择，具有较高的精度，能很好地模拟波浪的传播变形。

the results show that the higher the shot strength, the smaller the mean grain sizes in surface and the thicker the deformation layers;

结果表明，TC4钛合金经高能喷丸处理后，材料表面形成一定厚度的细化晶粒组织，且喷丸强度越高，表层平均晶粒尺寸越细、形变层越深；

in addition, in comparison with the deformation surface of ctc path, it was found that the differences between two kinds of surfaces were obvious. therefore, the effect of stress path on the constructive relation of soil cannot be neglected.

通过与CTC路径下的变形曲面比较，发现两者之间存在显著差别，验证了应力路径对本构关系的影响是不可忽略的。

therefore, the removal mechanism of no-elastic deformation in ultrasonic elliptic vibration grinding of zta ceramics had important influence on the surface integrity.

普通磨削和超声椭圆振动磨削的表面上都观察不到非晶相。试验结果表明，ZTA的非弹性变形去除对表面完整性有重要影响。

There should be no dents , no scratches, no burrs and no deformation on the surface.

产品表面无沙眼, 无毛刺,无压铸花,无变型.

The main defects are deformation and burrs of cutting surface in the square pipe end.

切口变形和毛刺是矩形管管端的主要缺陷.

Spacer ring provides bearing surface and prevents deformation of the gasket.

隔离环提供支撑面,防止垫圈的变形.

INQUIRY INTO DEFORMATION OF THE AXIAL SECTION IN CROSS ROLLING WITH HELICAL GROOVES AND INVESTIGATION OF ITS EXPERIMENT IN MOIRE METHOD Research on NC Grinding of Rotary Surface Parts with Arc Axial Section and Precision Controlling

螺旋孔型斜轧轴向断面变形的探讨及云纹实验研究圆弧轴截形回转面的磨削及精度控制方法的研究

The effect of transverse shear deformation is considered and angle of rotation of surface normal for each layer is different.

这类板的横向剪切变形效应必须予以考虑，因而层板不同层的表面法线的转角是不同的。

In this paper, the theories of elastic plastic mechanics and the finite deformation geometry are applied to study the question of surface displacement mechanism and displacement computation by mining below thick alluvia. It has an important guidance for controlling coal mining damage.

本文应用弹塑性力学理论及有限力学变形理论，研究了厚冲积层下开采地表移动的机理与移动量计算问题，对有效地控制地下开采损害具有重大指导作用。

And the concave-convex deformation of grains surface occurred in the early stage of fatigue in copper.

疲劳初期,纯铜试样表面还出现晶粒的弹性凹凸变形.

The experiments indicated that asperities of roll surface plow and stick to the aluminum strip surface, and lubrication oil film in deformation zone shields surface topography of aluminum strip are the primary reasons of surface damage of cold rolled aluminum strip.

实验发现：轧辊表面微凸体对铝板表面的犁削与粘结作用，以及变形区内润滑油膜对铝板表面形貌的屏蔽作用是冷轧铝板表面损伤的主要原因。

The deformation not only reflects the flexure behavior of slab at every loading stage, but also affects the stress status on the surface of punching shear cone and the ultimate capacity of the slab.

该变形反映了板在各个受力阶段的抗弯性能，也在很大程度上直接影响着冲切锥面上的应力分布和板的抗冲切能力。

Radiological features of knee joint were bony spur or bony bridge, osteoporosis, incomplete and thickening articular surface with sclerosis and deformation, degenerative disorders.

膝关节主要为骨刺或骨桥形成，受累关节骨质疏松、关节面不平整、增厚、硬化变形及呈退行性改变。

The late features were cystic degeneration and deformation of femoral head, obscure joint surface and narrow joint space.

晚期股骨头囊状变，股骨头变形，关节面模糊，关节间隙狭窄等。

Microstructure observation of γ-TiAl after subsequent heat treatment shows that: after the crystallization heat treatment, recrystallization occurs in the surface layer, and the center microstructure maintains the prior equiaxed grains as that before cold deformation.

对喷丸后的Q235钢进行热处理和显微组织观察，结果表明：经过在结晶热处理，表层晶粒发生再结晶，而心部组织保持为冷变形前细小的等轴晶形态。

According to the bimodal distribution mode for arc current density with a large deformation of the pool surface, the calculation mode for electromagnetic force is developed and described in this paper.

基于熔池表面变形较大时电弧电流密度的双峰分布模型，建立了电磁力的计算模型。