surface deformation的例句大全

Static deformation response of the earth to tidal potential, surface mass loading and shear stress

地球对引潮力位、表面负荷及切向应力的变形响应

The basic theories which include atomic forces between probe tip and sample surface and deformation of cantilever and so on are introduced; The design theory of AFM.

论文介绍了同AFM相关的基础理论，主要包括扫描探针与样品间原子力作用机理、微悬臂在原子力作用下的形变位移及其检测等；

The varieties of the microstructure and the surface hardness of the titanium alloys sheet after the deformation are analyzed by the metallography microscope, SEM and the microsclerometer.

并利用金相显微镜、扫描电镜（SEM）和显微硬度计分析了冲击成形后试样组织结构和表层硬度的变化。

The results indicate that a proportional relationship of 2:1 between the thickness of wear surface plastic deformation and the maximum thickness of wear particles does exist under various of testing conditions. While after the transition from adhesive wear to thermal wear, the above two thickness decreased.

结果发现在所有试验范围内磨损表面塑性变形层厚度与磨损颗粒最大厚度之间存在2∶1的直线关系，而在出现粘着磨损向熔化磨损转型后，这两者的厚度均减小。

The thermal deformation in penetration welding with a laser has been investigated as a factor which results in the elevation on the surface of the weld.

研究了热变形对激光深熔焊焊缝表面形状的影响。

By analyzing the obtained variation of the surface area and the key factors affecting droplet deformation, the formula of droplet surface area is obtained by regression analysis, and fuel droplet evaporation rate model was successfully corrected.

本文通过分析得出了影响液滴变形的关键因素和液滴表面积的变化规律，应用回归分析方法得出了液滴的表面积变化公式，并对燃油液滴蒸发速率模型进行了修正。

A Biomechanical Model for Simulating the Deformation of a Leukocyte Adhered to the Surface of a Blood Vessel under Steady Shear Flow

黏附于血管壁表面的白细胞在稳定剪切流动下发生变形的生物力学模型

For many years aeroneer is always expected that they can manipulate aircraft not by the control surface, but directly by the deformation of airplane wings to change aerodynamics, so as to obtain the best aero performance.

多年来飞机设计师一直期望不用舵面，直接依靠机翼变形来改变空气动力进行飞行操纵，以获得最佳的气动性能。

There are many plastic deformation and enfolded districts on the weared surface, which leads to the fact that the slice come off from pure aluminium surface and the wearing rate is high.

结果表明纯铝表面发生粘着磨损，存在大量塑性变形和折叠，导致片状脱落，磨损率高；

Because of its spiral surface which causes asymmetry, the deformation state of spring seat in the stamping process is much more complicated than that of general symmetry part.

弹簧座由于其螺旋面带来的非对称性，使其冲压成形过程中的受力变形状态要比一般的对称件复杂得多。

Non-local friction surface effect and approximate solution of drawing deformation with vibration

振动拉拔的非局部摩擦问题的近似求解及表面效应初探

On the basis of above study, the displacement transforming function of inner outer deformation in slope is built, the possibility using the function to study slope deformation law, influence scope of deformation and the possible slide surface is studied.

并建立了边坡内外观变形时空规律的位移传递函数，初步探索了利用位移传递函数研究边坡变形规律及稳定性的可行性。

Elastic-plastic Deformation Analysis of Multi-layers Surface Coating Under Sliding Contact

多层表面膜在滑动接触时的弹塑性有限元分析

The revised plastic index proposed in the paper will be the helpful foundations to analyze the deformation behaviour of rough surface at sliding contact.

这种影响将随椭圆比的增加而增加，在研究摩擦表面变形特征时必须考虑这一影响。本文提供的修正塑性指数表达式为进行滑动接触时的接触性能分析提供了有力的工具。

Suffering from such as earthquake, gravitation, construct stress, rainfall action etc, the sliding deformation occured along the weak structural surface in the slope, and the cracks occur under the concentrated draught stress.

经受了诸如自重应力、构造应力、卸荷变形、降雨等内外因素作用，斜坡岩体沿软弱结构面发生滑移变形。

The deep and large cavities are formed on fracture surface and grain boundary sliding and intergranular fracture characteristic is obvious on the optimal superplastic deformation condition.

在最佳超塑性条件下，断口中形成了大而深的空洞，晶界滑动和晶间断裂特征明显。

The discrete structures of the carbonate outcrop are characterized by the development of slip surface, fracture band, and deformation band.

柯坪露头碳酸盐岩断裂带不连续构造以滑动面、裂缝带和变形带发育为特征。

The change of the geotechnical deformation parameters has a great influence on the potential slip curves ( surfaces), and has a little influence on the shape, position and average stability safety factor of the most dangerous potential slip curve ( surface).

岩土的变形参数变化对潜在滑移线（面）的形状影响较大，而对边坡最危险潜在滑移线（面）的形状、位置及平均稳定安全系数影响不大；

An Analytical Approach to the Slip Deformation of the Surface of Polycrystalline Aluminum

多晶铝的表面滑移变形分析研究

The results show that the primary failure modes of the slope are sliding and fracturing and bedding sliding. The Slope is in the initial stage of slip deformation, upper Deformation and the surface rocks slipped along the dimensions.

认为该边坡为顺层滑移型边坡，在开挖过程中边坡处于滑移弯曲变形初始阶段，变形体上部及表层岩体沿层面发生滑移拉裂变形。