surface force的例句大全

The surface appearance and the effect of sputtering power on the roughness of thin film surface were investigated by atom force microscopy ( AFM).

应用原子力显微镜研究了薄膜的表面形貌，分析了溅射功率对薄膜表面粗糙度的影响。

Surface acoustic wave force sensor

声表面渡（SAW）力传感器

Results show that passive film obtained with this formular had bright black surface, uniform color, high corrosion resistance and abrasive resistance, and good adhesion force.

研究结果表明，采用该种钝化液获得的钝化膜油黑发亮，色泽均匀，耐蚀性及耐磨性好，附着力强。

Grinding System Based on Force Control of Three-Axis Free from Surface

三维自由曲面力控制磨削系统

So It is importance to strengthen joint force between oil film and wear surface, keeping saitable viscosity of oil and avoiding over load of machine.

因此加强边界润滑，提高油膜与摩擦副表面的结合强度，保持一定的润滑油黏度，防止超载显得十分重要。

Process fracture splitting groove with the 52D test sample in way of with the means of mechanical broaching, wire-electrode cutting and laser beam cutting. Do the tensile test on test sample and analyze the fracture force, fracture surface and microscopic figure.

用52D连杆加工试样，分别采用机械拉削、线切割和激光切割三种方法加工裂解槽，对试样进行拉伸试验，对断裂力、断裂面微观形貌进行分析。

This is the Titanic force that cuts down mountains and levels the surface of continents.

这是泰坦尼克号的力量，切割山脉及减少大陆的表面。

The computational analysis shows that such an earthworm body with the wavy surface can reduce its muscle contract force by 1.12%, and a similar amount of energy as well.

计算结果表明具有波纹形表面的蚯蚓在蠕动过程中可以节省1.12%的纵向肌肉的收缩力，在运动过程中所消耗的能量也可以节省1%左右。

3D deformation pattern picture, the stress and strain of tube surface and regularities of distribution of spinning force during the process of three-roller synchronous hot backward spinning are investigated.

研究了三轮同步热反旋过程中的三维变形图，管坯表面应力、应变以及旋压力分布规律。

Contact force generated by particles imposing on the surface of material can form contact shear stress and radial tensile stress.

材料表面受到颗粒冲击产生的接触压力形成接触剪应力，以及在接触边界上产生径向拉应力。

When a surface grinder abrasives a work-piece with a smaller contact area, a block should be added to fix the work-piece in addition to the magnetic force.

在平面磨床磨削接触面积小的工件，磁力不易吸住，必须加挡块。

The results indicate that contact area and surface adhesive force will be reduced with the decrease of fractal dimension. Furthermore, when fractal dimension is between 1.45 and 1.55, the wear ratio is the minimum. 3.

结果表明，降低表面分形维数可以减小接触面积，同时减小表面粘附力；当分形维数介于1.45和1.55之间时，磨损率最小。

The amending tangential displacement method is put forward toward the amend-ing normal displacement of stick contact to prevent the inset on the surface of a mixed ele-ment of displacement and force of Coulomb friction contact.

针对Coulomb摩擦接触问题的位移-力混合接触单元，为了防止接触面嵌入量太大，对于粘接状态在修正接触边界法向位移的同时，提出了一种修正切向位移的方法；

Three dimensional theoretical solution of a tangential force on the surface of two coating materials with the same thickness

等厚双层涂层材料受切向集中力作用的三维理论解

Tangential frost-heave force is perpendicular to frozen frontal surface and is parallel to side surface of foundation which is a pulling force make foundation move as the frost heave deformation of soil.

其中切向冻胀力垂直于冻结锋面，平行作用于基础垂向侧表面，且通过影响基础与冻土间的冻结强度，使基础随着土体的冻胀变形而产生向上位移的拔起力。

Conclusion The covers were opened for ventilation for 30 minutes after tank training, better results of disinfection of inside surface with carbonic acid and hibitane were obtained. So it can be spread in the tank force.

结论坦克训练后开盖通风30min，内表面用石炭酸及洗必泰消毒均取得明显效果，可在坦克部队内推广。

During manufacturing semisolid Al-Mg based alloy by rheocasting of incline cooling and shearing, melt alloy heterogeneously nucleated on the incline-cooling plate surface and was sheared under the gravity force, and alloy microstructure gradually evolves from big net-work composed of equiaxed dendrites to small spherical grain.

倾斜式冷却剪切流变制备半固态Al Mg合金过程中，合金在冷却板表面非均匀形核，并受到重力的剪切作用，合金组织逐渐从粗大等轴晶网络演化为细小的球形晶；

Application of Atomic Force Microscopy on the Study of Surface Relief Accompanying Martensitic Transformation

原子力显微镜在马氏体相变浮突研究中的应用

it is the same with the earth's crust, as the atmosphere moves with the earth, creating no more than hurricane force winds on the surface.

地球的地壳也是一样的道理，在大气随着地球运动的时候，在地表产生的不仅仅是飓风。

The results indicate that along with the increase of concrete cover thickness, the maximum corrosion expansion force of concrete specimen increases; stirrups encryption can be reduced the maximum principal tensile stress of specimen surface, thus inhibited or delayed the appearance of corrosive cracks.

结果表明：混凝土所能承受的最大锈胀力随保护层厚度增加而增大；箍筋加密能降低混凝土表面的最大主拉应力，从而有效抑制或延缓混凝土表面锈胀裂缝的产生。