surface reaction的例句大全

In a high electric field, organic molecules are polarized and react on the surface of the electrode, turning into DLC and other products. The authors believed that the reaction follows a polarization-reaction mechanism.

最后，作者提出了液相沉积类金刚石薄膜的反应机理－极化－反应机制，在电场的作用下，有机分子被极化并在电极表面反应生成DLC薄膜和其他产物。

During the implantation of IOL through surgery, the blood-aqueous humor barrier was broken. Protein and cell flood into the aqueous humor and could easily adsorb to the IOL surface, which may cause the inflamation and foreign body reaction.

人工晶状体在植入手术过程中，血-房水屏障被破坏，大量蛋白质及细胞进入房水中，容易在材料表面吸附，从而引起炎症异物反应。

These observation suggest that the hepatoma, lung cancer, breast cancer and lymphosarcoma are associated with surface changes of erythrocyte, especially those of the C_3b receptor which are responsible for immune adherence reaction.

此项观察提示肝癌，肺癌，乳腺癌和淋巴肉瘤病人红细胞表面发生变化，特别是介导免疫粘附反应的C3b受体活性发生变化。

Research on the Ceramic Coating on Metallic Surface Made by Chemical Reaction Method

金属表面化学反应陶瓷涂层的研究

Influence of Chemical Reaction Film on Lubrication Condition of Tooth Surface

化学反应膜对齿面润滑状态影响的研究

Ethanol electrooxidation on Pt is a structure-sensitive reaction. It is influenced by the catalyst surface geometry and electronic structure, such as the Pt-Pt bond energy, d-state electronic orbital.

Pt表面乙醇电氧化属于结构敏感型反应，受Pt-Pt键键能、d态电子轨道等催化剂表面几何和电子结构的影响。

Based on the effect of the GHSV of NH3 in the nitration process or the heating rate on the specific surface area and the particle size, it can be suggested that ammonia decomposition on the supported bimetallic nitrides is a structure-sensitive reaction.

据前人氮化空速和比表面积及颗粒度的关系以及升温速率和比表面积及颗粒度的关系的研究结果推测，氨分解在过渡金属氮化物上应该是个结构敏感反应。

Effects of reaction conditions such as content of coupling agent and reaction time on the surface modification are discussed. The potassium ionic sieve before and after modification are characterized respectively by XRD, SEM, FT-IR, and thermogravimetric analysis.

考察了偶联剂用量和改性时间对改性效果的影响，利用XRD、SEM、FT-IR以及热重分析等方法对改性前、后的钾离子筛进行了表征。

Effects of dispersant types and contents on membrane surface morphology are discussed. At the same time, effects of reaction conditions such as content of potassium ionic sieve, concentration of PVA, content of crosslinker and reaction time on membrane performance are also discussed.

实验详细考察分散剂种类及用量对膜形貌的影响，以及离子筛含量、聚乙烯醇（PVA）浓度、交联剂用量和交联时间对膜性能的影响。

In the short contact reaction of the hydrogenation of CO 2, methanol and ethanol were primary products and formed fast, and the chain growth came from the surface enol species, being independent of the surface CH species;

同时，在短接触的CO2加氢反应中，醇是初级产物，其生成速率较快，链增长方式可用烯醇缩合机理解释，不受表面活泼碳氢物种的影响；

Surface chain transfer reaction was used to prepare end-grafted polymer films of nanometer dimensions.

研究了通过自由基链转移反应原位接枝聚合物膜。

SiC/ SiO_2 multilayer can be obtained on the surface of fuel element matrix graphite of high temperature gas-cooled reactor by the combination of vapor reaction diffusion, slurry method and high temperature oxidation in air;

将气相反应扩散法、泥浆浸渗法和高温氧化法结合起来，在高温气冷堆燃料元件基体石墨表面制备出SiC/SiO2复合涂层；

It was shown that on ab initio surface the reaction threshold energy was much lower, the reaction probabilities, cross sections and rate constants were much larger than on extended LEPS surface.

计算表明，在AB INITIO势能面上，Br+H2的反应阈能要比e-LEPS势能面上的反应阈能低一些，而且AB INITIO势能面上的反应几率、反应截面和速率常数都要大许多。

In this paper, the contact reaction between Aluminum and Copper and its liquid phase behavior were studied by means of experiment simulation and analysis based on the theory of surface and grain boundary diffusion in metallurgy.

采用模拟的方法，系统研究了Al/Cu接触反应及其液相行为的特点，并运用金属学中表面扩散和晶界扩散等理论进行了理论探讨。

functionalization reaction of basic group on the surface of hexagonal mesoporous silica

碱性基团在介孔分子筛上的表面功能化反应

the esterification reaction of hexane diacid with 2 ethyl hexanol was studied by using modified β zeolite as catalysts. the effects of cation exchange degree, calcining temperature and the surface acidity on the catalytic activity were discussed.

用改性β沸石作催化剂，研究了己二酸与2－乙基己醇的酯化反应，讨论了阳离子交换度、焙烧温度及表面酸性对催化活性的影响。

results showed that the better technological conditions as following: reaction temperature 40 ℃, constant temperature reaction time 40 min, sedimentation time 120 min, dosage of the surface active reagent 4ml, the proportion of ammonia and magnesium sulfate 6:1.

实验结果表明，制备阻燃氢氧化镁较适宜的工艺条件为：反应温度40℃、恒温反应时间40min、陈化时间120min、表面活性剂A体积用量4ml、氨镁摩尔比6：1。

the mode of action of the zinc promoter should be explained rather by a removal of blocking or poisoning impurities or oxide layers from the active surface or a promotion of the formation of copper chloride than by a direct interference into the reaction mechanism.

锌助催化剂的作用模式应解释为除去触体表面对反应有障碍的或有毒的杂质或氧化层，或是促进氯化铜的形成而不是直接参与反应；

the existence of unbound water on the surface of lime particles is necessary to the ionic reaction which maintains high so_2 removal efficiency.

阐明了脱硫剂表面含有非结合水分是维持脱硫的快速反应&离子反应的必要条件。

4) Graft copolymerization of MMA onto wood surface can be taken place by means of MWP treatment under room temperature even under lower temperature (-17 ℃). Furthermore, graft yield increased with reaction temperature;

4）经微波等离子体处理过的木材不但在室温下，甚至在更低的温度（-17℃）下也能与MMA发生接枝共聚反应，而且，接枝率随着反应温度的升高而增大；