surface voltage的例句大全

a novel analytic model on surface voltage and electric field of the drift of offset-gate mos

一种新型偏置栅MOS管漂移区表面电压和电场的分析模型

The dielectric Loss is tested using the instrument of DETAL& 2000 and the dielectric loss obtained shows that it is negative at first and increases with higher testing voltage, furthermore becomes positive when sample surface is swamped.

利用DETAL&2000测试仪对电缆试样进行介质损耗角正切的测量试验，发现电缆试样的介质损耗角正切开始为负，但随着测量电压的升高逐渐增大，在试样发生表面击穿时，变成正值。

The damage of the cathode can be verified by measuring the surface temperature of the cathode rob head and the voltage reducing of the sub-bus-line.

通过测量阴极棒头表面温度及阴极小母线的压降可判断槽底是否破损。

The results show that the film surface morphology is reticular porous structure, at different time and termination voltage, there is large difference between membrane surface structure;

结果表明：膜层表面微观形貌呈网状多孔结构，不同时间和终止电压下，膜表层结构区别较大；

Surface doses were obtained from measured X-ray tube output data. The correlative changes were observed among X-ray tube voltage, surface dose, air kerma, and the detection threshold concentration of iodine.

观察X线管电压、表面剂量、比释动能以及碘探测阈浓度之间的变化关系。

The electric field intensity distribution over the tip surface was established through calculation with appropriate voltage boundary condition applied, and it was found that the electric field intensity was the strongest at the apex of the tip, and the field emission current was also the strongest there.

对模型的表面施加电压边界条件，计算得到尖锥表面电场强度分布，电场强度在尖锥顶点最强，场发射电流在此处也最强。

The anatase and rutile TiO_2 porous films were prepared directly on the surface of pure titanium by constant voltage and constant current anodic oxidation using sulphuric acid, pure titanium and pure copper as electrolyte, anode and cathode, respectively.

以硫酸为电解液，纯钛（TA1）为阳极，铜片为阴极，以恒压和恒流阳极氧化方式在钛表面直接获得锐钛型和金红石型TiO2多孔膜。

With the change of the bright spots on the surface of electrodes, the discharge voltage at low current region almost increases exponentially with the current in a certain pressure.

随着电极表面亮斑的变化，对于同一气压，在低电流区，放电电压几乎成指数增长；

As long as changes of voltage on the surface of the equivalent electret are measured during and after the absorption of a transient thermal pulse on one electret surface, the total charge and charge centroid in thin electret are obtained directly with this technique.

只要驻极体表面在吸收热脉冲的瞬间以及其后，测量出等效表面电压的变化，便可直接算得驻极体的总电荷量及其电荷重心。

Surface flashover characteristics of polyethylene film under ns impulse voltage in vacuum

真空中聚乙烯膜在纳秒脉冲电压下的沿面闪络特性

A design of an optical pumping source with multichannel surface discharge is introduced. The effects of the trigger voltage and risetime, and the thickness of dielectric substrate on trigger characteristic are analyzed theoretically.

介绍了多通道表面放电光泵浦源的设计，理论分析了触发电压幅值及上升时间、绝缘基板厚度等参数对所设计光泵浦源触发特性的影响。

A piezoelectric cantilever subjected to a uniform loading or a voltage on the upper surface of the beam is studied. The density of the beam is considered to be of functionally gradient properties.

研究了密度梯度功能压电悬臂梁在轴向和横向均布荷载以及外加直流电压分别作用下的解析解。

Research on the Insulator Surface Charge Accumulation under DC Voltage

直流电压作用下绝缘子表面电荷积聚的研究

Analysis and Solution on Crinkle and Twist of the Surface of High Voltage Bus Power Cable

上机高压电缆外皮起皱扭曲情况分析和解决办法

Voltage offset influence of the nanometer lithography of the surface of HOPG ( highly oriented pyrolytic graphite) and the state of the needlepoint has been inspected by way of STM.

本文以STM为手段，研究偏压值对高序石墨表面纳米刻蚀及针尖状态的影响。

It shows that the suitable bias voltage can improve the quality of the films by attracting the ions to bombard the surface to provide extra energy for the growing films.

研究结果表明适当的施加负偏压可以吸引等离子体中阳离子轰击基片表面为薄膜生长提供额外的能量。

influential factors were considered including specimen's surface state, ambient atmosphere, polarity, magnitude and method of tip sample applied voltage.

实验考虑了样品的表面状态，周围大气状况，所加电压的极性、大小和加压方式等影响纳米加工的因素。

The paper discusses the technique of increasing surface power voltage class from 380 V to 660 V.

本文就地面供电电压等级由380V提高到660V电压技术问题进行探讨.

Based on research on available electrostatic spray painting equipment, grid electrode used as high voltage electrode for electrostatic coating on food surface.

在研究已有的静电喷涂装置基础上，采用栅网电极作为食品表面静电涂敷高压电极。

Application of avalanche noise detection as a criterion for surface breakdown mechanism of high& voltage silicon p+ pnn+ junctions

雪崩噪声鉴别法在高压硅P~+PNN~+结表面击穿机理判定中的应用