temperature action的例句大全

The Control of Cracking and Leaking and of the Temperature and Humidity Action on Pool Structure

池类结构裂渗和温（湿）差作用的控制

It's of fundamental importance to establish restraining model in calculating the temperature and shrinkage action of concrete structures.

在混凝土结构温度及收缩作用计算中，结构的约束模型是关键。

In fact, the Fe-N lengths are related with temperature with the action of internal chemical pressure.

由于内化学压的作用，将温度和键长关联起来。

This paper discusses a method of continued heat transfer in SO 2 oxidation process with multiple differential heat transfer sections by using heat pipes, which makes the whole action course press close to the optimal temperature curve of action.

探讨了一种采用热管构成传热微元段，实现SO2氧化过程连续换热的方法，从而使整个反应过程贴近最佳反应温度曲线。

The optimal pH and optimal temperature for enzyme action was 6.0 and 65& 70 ℃ Thermal stability of the enzyme was good, after incubating at 70 ℃ for 5 minutes, 88% of the cellulase activity remained.

酶作用的最适条件为：pH6.0，温度为65&70℃。该纤维素酶是一种耐热酶，热稳定性较强，70℃保温5分钟后，酶活力剩余88%。

Study on Joint Action of High Temperature and Noise on Hypertension and Change of ECG in Workers of a Ceramic Factory

高温和噪声联合作用对某陶瓷厂生产工人血压与心电图影响的研究

The optimization technology of stepwise decrease of re-action temperature is adopted Optimum reaction conditions are 10 ℃ for 1 hour, 5 ℃ for 1 hour and 0 ℃ for 2 hours.

采用阶段降温优化工艺，最佳反应条件为10℃、1小时，5℃、1小时，0℃、2小时。

Direct action temperature regulator

直接作用式温度调节器

The action of temperature is one of main actions on the hydraulic concrete structures, so in most of the hydraulic concrete structures the temperature reinforcement must be provided.

温度作用是水工混凝土结构的主要作用之一，大多数水工混凝土结构需配置温度钢筋。

The result of failure physics analysis shows that under the action of temperature and vibration stresses, failure physics equation of aerospace electrical connectors yields the generalized Eyring relationship.

失效物理分析结果表明，在环境温度和振动应力的综合作用下，航天电连接器的失效物理方程为广义Eyring模型。

The stress of base structure is analyzed by3-D FEM under the action of temperature warping deformation and coupling with vehicular load.

方法结合试验路温度场监测数据，采用三维有限元法对基层结构在温度翘曲变形及与车辆荷载耦合作用下的受力特性进行分析。

The ablation resistance was obtained due to the combined action of both the high strength cermet with the durability to erosion and high temperature and the metal binder, Cu, performing decalescence and volatilization at high temperature.

材料的抗烧蚀机理为耐高温、耐冲刷的高强度陶瓷骨架以及高温下挥发吸热的金属Cu粘接剂，二者的综合作用使材料具有抗烧蚀性。

Once the temperature of the environment exceeds the critical explosion temperature, the delayed-action time will shorten along with the temperature of the environment ascending;

一旦环境温度超过临界爆炸温度，随环境温度的升高，爆炸延滞期将变短；

The combustion of emulsion explosive matrix is nearly relational with the temperature of the environment, the delayed-action time will extend when the non-adiabatic semenov parameter is around the critical value.

其燃烧与环境温度有着密切的关系，当非绝热semenov数处于亚临界和临界值时，爆炸延滞期延长。

The thermal desorption spectrum ( the desorption rate VS sample temperature), the desorption action order and the desorption activation energy have been obtained for main kinds of desorpted gases.

得到它们的主要脱附气体的脱附速率的温度特性，即热脱附谱，脱附反应级数和脱附激活能。

The results show that thermal treatment and dispersion strengthening action of silicon carbide greatly improve hardness, wear resistance and resistance to oxidation at high temperature of amorphous nickel-tungsten-carbide deposit.

结果表明：碳化硅的弥散强化作用和热处理能显著提高复合镀层的硬度、耐磨性和抗高温氧化性。

Thermal simulation system can change the distribution of temperature of thermal simulation region by quantity of liquefied nitrogen which was added in, sequentially simulates the different cooling environment. Thermal simulation system is characterized as direct action on the sample and high cooling velocity.

热模拟系统是通过改变液氮的加入量来改变热模拟区的温度分布，从而模拟不同的冷却环境，其特点时直接作用与试样，冷却速快。

Therefore, under the action of temperature stress, if getting rid of thermal shock effect, only need to consider the steady state of thermal flow and not necessary to think of the transient state of unstable thermal flow.

因此，在温度应力作用下，如果排除热冲击效应，只需考虑热流稳定状态，而不必考虑热流未稳定的瞬间状态。