temperature buffer的例句大全

It is suggested that growth temperature of the AlN buffer layer influences GaN morphology by forming different AlN seed size and density on the Si ( 111) substrate during the initial growth of the buffer layer.

进一步解释了GaN外延层表面形貌中凹坑的形成及凹坑与缓冲层生长温度的关系.结果表明，温度的高低通过影响缓冲层初始成核密度和成核尺寸来影响外延层表面形貌。

the result of stibium electrode's determining ph values of two standard buffer fluid in laboratory showed that the maximum absolute error was 0.23 when temperature went below 60 ℃ and 0.46 when 70 ℃.

室内实验中锑电极测定两种标准缓冲液的pH值，当温度小于60℃时，最大绝对误差为0.23；温度为70℃时为0.46。

The effects of pH and concentration of phosphate buffer solution, SDS micelle concentration, methanol volume fraction, applied voltage and temperature on the separation were studied.

研究了运行缓冲液的pH值、磷酸盐浓度、SDS浓度、甲醇体积分数、分离电压、分离温度等因素对这10种化合物的迁移时间和分离效果的影响。

The results showed that the better immobilization conditions were as follows: reactive solution pH 7.0, reactive temperature 37 ℃, reactive time 6 h, potassium phosphate buffer 0.1%.

实验结果表明：反应液pH值7.0，反应温度37℃，反应时间6h，磷酸盐缓冲液0.1%的条件下，固定化细胞具有较高的GSH合成酶活力。

operating temperature range operating speed range buffer type buffer stroke joint pipe bore

使用温度范围℃使用速度范围缓冲型式缓冲行程接管口径

co/ cu/ co sandwiches were fabricated on crystalline silicon substrate by uhv electron beam evaporation. the influence of substrate orientation, material of buffer layer and fabrication temperature on the giant magnetoresistance ( gmr) effect in the sandwiches was studied.

采用超高真空电子束蒸发方法在硅单晶衬底上制备了Co／Cu／Co三明治膜，研究了衬底晶向、过渡层材料和生长室温度对三明治膜中巨磁电阻效应的影响；

The effect of temperature, pH, buffer species, buffer concentration, ionic strength and light on the stability of gentiopicrin solution were investigated and the most appropriate preservation conditions for TGG were determined. 4.

考察了温度、pH、缓冲盐种类、离子强度、光照等对龙胆苦苷水溶液稳定性的影响，以确定其最适保存条件。