temperature cycle的例句大全

The coefficient of performance of R290/ CO_2 cascaded refrigeration cycle can be enhanced by using rotary compressor without suction and discharge valves and by replacing throttle with expander in CO_2 low temperature cycle.

在CO2循环中可利用无吸排气阀的回转式压缩机，用膨胀机代替节流阀，以提高R290/CO2复叠式制冷循环的性能系数。

Carry on temperature cycle test on typical components, inspects solder joint crack in different cycle, observe microstructure of solder joint in virtue of metallographic analyse, study solder joint failure mode in temperature cycle and offer basis to improve technology parameter.

针对典型元器件进行温度循环试验，在不同的循环周期检查焊点的开裂情况，并采用金相分析观察焊点的显微组织，分析焊点在温度循环条件下的失效模式，为改进工艺参数提供依据。

After the calibration process of this multimode measuring method, the frequency characteristic of surface resistance for testing sample can be described within one temperature cycle.

在校准步骤完成后，该多模测试方法可在一个温度循环内，对被测样品的微波表面电阻频率特性进行表征。

Results show that GDMP can be used as treatment agent in high temperature cycle water.

结果表明，GDMP有较好的化学稳定性，且能耐较高温度，可作为高温循环水的处理药剂。

A finite element modeling of SCSP was performed. The distribution of thermal stress of SCSP under temperature cycle was analyzed.

研究了温度循环载荷下叠层芯片封装元件（SCSP）的热应力分布情况，建立了SCSP的有限元模型。

The COP of NH_3/ CO_2 cascaded refrigeration cycle can be enhanced largely by using expander in NH_3 high temperature cycle and CO_2 low temperature cycle.

在NH3/CO2复叠式循环的NH3高温循环和CO2低温循环中都采用膨胀机代替热力膨胀阀，可以大大地提高COP。

After high and low temperature cycle experiment, the parameter still can meet industry IL standard. Finally, the high temperature and humidity test is researched.

包括封装胶的选择，使得封装后的分路器经过高低温循环实验后，IL值仍然能够符合产业标准之内。最后，文章研究了PLC分路器的高温高湿实验。

A Damage Property Investigation of Compound Fatigue Under Temperature Cycle of the Multiple-Hole Specimen

多孔试件在热循环下的复合疲劳的损伤特性研究

The formulation of life prediction for specified program-controlled temperature cycle is proposed. The fracture surface of the superalloy has also been observed by SEM.

提出了特定程序波温度循环预测合金断裂寿命的公式，并用扫描电镜观察了合金的断口。

The low cycle fatigue property of surface quenching grade C steel is higher than that of normalization grade C steel and quenching and high temperature tempering grade C steel.

表面淬火C级钢比调质C级钢和正火C级钢的低周疲劳性能高，在应变量较大时，调质C级钢和正火C级钢低周疲劳寿命较高；

The technical feasibility of this design and the availability of the device were also verified in this paper by the multinode temperature collect and feedback control tests and the static life cycle test of this device.

通过引入多个节点的温度采集与反馈控制实验和节点生命周期静态测试实验验证了本设计的可行性和实用性。

Thus, Ac 1f temperature equalization spheroidizing annealing technique is developed, which acquired good spheroidizing quality, shortened productive cycle and saved energy in production test.

由此开发出Ac1f透烧加热的球化退火工艺，生产试验取得了球化质量好、生产周期短及节能的效果。

Through water pressure test, ammonia leakage test and field high temperature melted salt cycle test, it is shown that the tube joint welding quality meets completely the design and process demands.

经水压试验、氨渗漏检验及现场高温热熔盐循环试验，焊接接头质量完全达到设计及工艺要求。

High Temperature Low Cycle Fatigue Life Prediction Models

高温低周疲劳寿命预测模型

Experimental procedure and data processing of pipe material for high temperature low cycle fatigue

管材高温低周疲劳实验方法及数据处理

Solving some thermodynamic problems related to temperature with cycle procedure means

用循环过程法求解某些与温度有关的热力学问题

Discussion of the Evaluating Criterion of High Temperature Low Cycle Fatigue

高温低周疲劳寿命评价准则的探讨

Preliminary Reconstruction of the Temperature Curve of the Last Major Climatic Cycle in North China

中国北方末次主气候旋回气温曲线的初步恢复

The performance analysis for semiconductor thermoelectric cycle which works at small temperature difference

低温半导体温差发电循环的工作性能分析

Using this device can control the test point of contact line in shortcircuit and heat cycle experiment of catenary, as a result, the temperature of contact line can be measured.

使用该装置可以对接触网短路热循环实验各个测温点进行循环测量。