temperature factor的例句大全

According to the corresponding eigenvectors, the 3 principal components were explained as the anthropogenic factor, the temperature factor, and the precipitation factor.

根据3个主成分各自对应的特征向量特点，分别解释为人为因子、温度因子和降水因子并进行回归分析。

It is also demonstrated that, although the effect of the temperature factor only accounts for-19.17%, it accelerates the decrease of water resources.

而温度因子虽其影响力不是很大，只占总影响力的-19.17%，却加剧了水资源进一步减少的趋势。

Study the Temperature Factor in High-reality Numerical Simulation on Mild Wear

磨损高真感数值仿真中温度因素的研究

Analysis on the temperature factor acting on the antioxidant properties of copper additive

温度因素对铜型添加剂抗氧化性能的作用分析

The increasing of effective temperature factor at the second stage;

第二阶段主要是有效温度系数的增加；

The Relationship of Light and Temperature Factor and Yield Maize

光温因子与玉米产量的关系

The inductive lightning strike mainly effect the temperature factor hardly effect others.

感应雷击对温度要素的影响较大，对其他要素的影响较小。

The trend of new technique for manufacturing Ni-Cr alloy thin film with a combination of characteristics: high resistivity, low temperature coefficient of resistance ( CR), large gauge factor, and good thermal stability is presented.

阐明了制备具有高电阻率、低电阻温度系数、高应变灵敏系数、良好的热稳定性等优异综合性能的镍铬合金薄膜的新工艺发展趋势。

And then, photolithography and wet etching were used to pattern the ITO films for electrical measurement, which involved the measurement of temperature coefficient of resistance and the gauge factor.

然后用光刻和刻蚀的方法制作电学测试所需的图形。对于ITO薄膜的电学测试包括对其电阻温度系数和响应因子的测量两部分。

In his paper, Lafferty argues that temperature increases due to climate change are just one factor among many socioeconomic and environmental influences affecting diseases.

Lafferty在他的论文中认为由于气候变化导致的升温只是影响疾病的许多社会经济和环境影响因素之一。

The typical damage features of north asphalt pavement which suffer extreme high temperature climate have been summarized. The rut factor, creep stiffness, dynamic stability and shear parameter of base asphalt, SBS and CMA binders and mixtures were obtained.

总结了极端高温气候下北方地区沥青路面典型破坏特征，获得了基质沥青、SBS、CMA结（混）合料极端高温条件下的车辙因子、蠕变劲度、动稳定度和抗剪参数。

OBJECTIVE Probe into Ofloxacin and Sodium Chloride Injection production, such impacts on Ofloxacin and Sodium Chloride Injection quality of the factor as metal ion, hydrogen ion index of the semi-manufactured goods, activated carbon and sterilization temperature, etc.

目的探讨氧氟沙星氯化钠注射液生产中，金属离子、半成品pH值、活性炭及灭菌温度等因素对氧氟沙星氯化钠注射液质量的影响。

Because temperature is an important factor in influence of measuring accuracy, the real time accuracy testing for optical voltage transformer is important.

由于温度是影响系统测量精度的重要因素，对其进行实时性的精度检测显得尤为必要。

The determination of compressibility factor_z, volumetric adiabatic exponent k_v and temperature adiabatic exponent k_t of real gases

实际气体压缩性系数z、容积绝热指数kυ和温度绝热指数k T的确定

Multi-factors Modeling on Temperature Error of Laser Gyro Using BP Network

激光陀螺温度误差的多因素BP网络模型

The impacts of degree of gelatinization, relative crystallinity, moisture content, expansion temperature and expansion duration on thermal-expansion property were investigated through single factor experiments using expansion ratio and fracture energy as indicators.

通过单因素实验，以膨化率和断裂能为指标综合考察了糊化度、相对结晶度、饼坯水分含量、膨化温度及膨化时间对淀粉热膨化性质的影响。

Temperature error is the main factor that produces the measuring error.

温度误差是产生测量误差的主要因素。

By way of complex extraction with PCW-6 extractant to recover glycolic acid from the wastewater, the paper discussed different effects of each factor ( such as acidity, extractant concentration, oil-water ratio, temperature, and equilibrium time) to the extracting efficiency.

以PCW-6为萃取剂，采用络合萃取法回收废水中的羟基乙酸，探讨了各因素（酸度、络合剂浓度、油水比、温度、萃取平衡时间）对羟基乙酸萃取率的影响；

Through calculations obtained were for the gas film-cooled flat plate without ribs and with 45o ribs a flow field distribution and the average temperature and average heat exchange factor at the flat plate inner and outer surface.

计算获得了无肋和带45°肋气膜冷却平板的流场分布和平板内外表面的平均温度和平均换热系数。

The effectiveness factor of high temperature shift catalyst calculated by random pore model

用双重孔模型计算变换催化剂内扩散效率因子