temperature load的例句大全

Influence of temperature load in the full-stress design of arch dam

拱坝满应力设计中温度荷载的影响

Exchange from finite difference gridding temperature load to finite element gridding

有限差分网格温度载荷向有限元网格的转换

Temperature load of construction controlling for long-span bridge

大跨径桥梁施工控制温度荷载

The system is used to test the motor including resistance test, temperature rise test, locked-rotor test, no-load test, load test and M-S curve test.

用于完成电动机的各种型式试验，包括电阻试验、温升试验、堵转试验、空载试验、负载试验和M&S试验。

After computation, temperature change rate can been directly determined according to the unit operation time when the boiler starts up, blows out and changes load.

经过推导计算，得到直接根据机组运行时间的长短来决定机组启停炉及变负荷时的温变速率。

Under intermittent operation condition, temperature recovery at night and load trace at the end of running period of three ground surface forms are compared.

对间歇运行工况下，三种上垫面形式下的夜间恢复情况和运行周期末的负荷痕迹值进行了对比分析。

The system can calculate conductor temperature and rating by using the monitored cable surface temperature, real-time load and the structure parameters of tunnel cables.

该系统通过远程监测电缆表面温度、负荷电流，结合电缆的结构参数以及隧道敷设环境，计算电缆实时导体温度和载流量。

Based on gradient-dependent plasticity where an internal length parameter is included to consider the microstructural effect, the distributions of shear deformation, shear strain and temperature in adiabatic shear band were derived considering the slow and sharp decrease of load-carrying capacity beyond the peak shear stress.

采用梯度塑性理论，考虑了峰值剪切应力之后的材料承载能力缓慢降低的过程及承载能力快速降低的过程，推导了剪切带内部的剪切变形、应变及温度分布的公式。

Research of device testing environment with load and high temperature

带载高温环境试验装置的研制

The effects of contact pressure, amplitudes, applied loads, temperature, number of cycles and the ratio of high cycle load to low cycle one on fretting fatigue life and frictional coefficient were carried out.

用桥式试样研究了接触压力、微动幅度、温度、循环次数、高低周载荷幅值比等参数对微动疲劳寿命影响。

At low speed and high load the biogas& diesel dual fuel engine has a higher volumetric efficiency, the time of the mixture staying at high temperature level is longer, so even if the maximum combustion temperature is relatively lower, the NO_x emission is still high.

低速大负荷时，生物制气&柴油双燃料发动机充气效率变大，可燃气体在高温下停留时间增加，因此转速降低时虽然最高燃烧温度降低，但此时NO x排放浓度增加。

Based on the two high frequency miniature non-metallic PTCs, this paper investigated the variation of the lowest no-load temperature of the cold head and co-axial conduction heat lossed with the temperature of the warm end respectively.

本文针对所设计的两台高频微型同轴非金属脉冲管制冷机，实验研究了制冷机冷端无负荷最低温度和轴向导热损失随热端温度的变化规律。

Each of these components using new forecasting method to predict the load in the low frequency components of the summer forecast, the introduction of real-time temperature factor, the final reconstructed sequence of the final load forecast results, to improve the prediction accuracy.

分别对这些分量运用新的预测方法进行预测，在对夏季负荷低频分量进行预测时，引入实时温度因子，最后重构负荷序列得到最终预测结果，提高了预测精度。

A major challenge scramjet engines currently faced is the high aerodynamic heat load. The wall temperature of combustion chamber without cooling can reach 3000K, which exceeds the limit of the general material used.

超燃冲压发动机目前面临的一大难题就是极高的气动力热载荷，燃烧室壁面温度在未经冷却的情况下能达到3000K。这超过了一般结构材料的使用极限。

Under high temperature action, the structure and surface appearance of coal bodies around the blind hole gasifier have changed, and formed the distillation combine zone, which improves load carrying ability and integral stability for coal bodies around gasification stove.

盲孔炉四周煤体在高温作用下，其组织结构和表面形态都发生了质的变化，形成干馏组合碹，从而提高了气化炉周围煤体的承载能力和整体稳定性。

Based on the advanced technology and instruments of visible monitoring system of section temperature field in furnace, energy saving& environmental protection test vehicle and 3-dimension furnace computational simulation, test and study are carried out on stability of peak-load regulation and optimization of operation of large unit.

利用炉膛断面温度场可视化监测系统、节能环保车、炉内三维数值模拟等先进的技术和设备对大机组调峰稳定性和运行方式优化进行试验和理论研究。

At the test temperature, the maximum compressive strain, the maximum tensile strain and strain amplitude are all in exponential relationship with the axle load.

在试验温度下，最大压应变、最大拉应变和应变幅值均随轴载的增加呈指数关系增大。

This article mainly analyses the factors that affect the precise indexer life, touching surface pressure, basic motion load and temperature factor for example.

着重分析影响精密分度装置寿命的接触表面压力，基本动载荷，温度系数等因素。

Analyses the interrelation between loading and atmospheric temperature by multi element linear regression with unique special features of Heilongjiang electric power supply network taken into consideration, and forecasts load for upcoming 24 hours.

根据黑龙江电网各地区的自身特点，应用多元线性回归方法，分析负荷与气温的关系，并对未来24h的负荷进行预测。

The maximum temperature in the section under load of 250 MW is about 80 K higher than that under load of 200 MW.

250MW负荷水平下的最高温度比200MW负荷水平下的最高温度高约80K；