temperature loss的例句大全

Cylindrical flames with radiative heat loss and curvature are analyzed theoretically. The relation between the flame position, flame temperature, heat loss and inlet velocity is obtained.

本文从理论上分析了有辐射热损失和曲率的圆柱火焰，推导出了关于火焰位置、火焰温度同热损失和来流速度之间的关系式。

Synthesis and property of high temperature resistant fluid loss additive for oil well cement

耐高温油井水泥降失水剂的合成及性能

The higher content of the polystyrene ( PS) segments, the higher temperature of loss factor tan δ peak and its flowing.

SIS的硬段聚苯乙烯含量越高，损耗因子（tanδ）峰值温度和粘流温度越高。

Study of the Relation Between Electromagnetic Parameter and Sintering Temperature of Low Loss Mn-Zn Ferrite

低损耗Mn-Zn铁氧体电磁参数与烧结温度的关系研究

With the switch frequency IGBT switching device input impedance high, high, high temperature extremes, driving circuit is simple, driving power small, components such as small loss more than the advantages, is extremely ideal switch components.

IGBT开关器件具有开关频率高、输入阻抗高、极限温度高、驱动电路简单、驱动功率小、元件损耗小等多个优点，是极为理想的开关元件。

As an example, the variation of the temperature and heat loss of the air in the fire room are calculated.

计算了慢速、中速、快速、超快速四种火灾增长速率下，受火室气相温度及烟气热损失随时间的变化。

This paper further discusses kinetic models describing the effect of pesticide concentration and temperature on the loss rate of pesticides in soil.

本文进一步讨论了可描述农药浓度和温度对土壤中农药消失速度影响的动力学模型。

At a certain atmosphere, the characteristic temperature and mass loss proportion during wood pyrolysis is not quiet different from species.

在一定气氛下，木材热解失重过程中的特征温度值和失重率，在不同树种之间的差异较小；

Study on Preparation of Microwave Material of Yttrium and Gadolinium Doped Composite Rare Earth Garnet with High Stability of Temperature and Low Loss

高温度稳定度和低损耗的稀土钇钆复合石榴石微波材料的研究

Retorting degree influenced the start temperature of mass loss and pyrolysis process at low-temperature stage, but had little effect on pyrolysis at high-temperature stage.

干馏度对半焦热解初析温度和低温段热解过程有影响，但对高温段热解影响不明显，高温干馏所制取的半焦其热解过程包含于低温所制取的半焦热解过程中；

Based on the aging loss calculation, the limited value of temperature rise for F class insulation transformer on rated operating condition is derived. This value is satisfied with the desire of standard load system of duty class ⅴ and ⅵ.

通过寿命损耗计算，得出了F级绝缘变压器在Ⅴ级和Ⅵ级负载标准工作制条件下额定运行的温升限值。

The design of dry-type air-cored reactor is very complex, it need to comprehensively considerate the magnetic field, inductance, temperature rise, loss and other factors.

干式空心电抗器的设计比较复杂，要综合考虑磁场、电感、电流、温升和损耗等方面的因素。

The thermal decomposition of MF foam has only a large peak in nitrogen atmosphere and in air atmosphere. The peak temperature of weight loss increases with the increase of heating rate.

MF泡沫具有良好的热稳定性。MF泡沫在氮气气氛下和空气气氛下只有一个大的分解峰，失重峰温随着升温速率的提高而提高。

The experimental results show that, at definite temperature, the loss quantity of the river sand of 4 different grain-diameters increases and the reaction rate decreases with the increase of the reaction time;

实验结果表明：在一定温度下，随着反应时间的延长，4种不同粒径河砂的损失量增大而反应速率减小；

The curves of heating temperature vs the loss of ignition ( LOI) of some kinds of used resin bonded sand are shown by laboratory testing the LOI under given heating temperature and time.

通过在实验室条件下对树脂旧砂在一定加热温度、加热时间下燃烧减量的测试，建立了几种树脂旧砂加热温度和燃烧减量之间的关系曲线；

Binding with the effect of the annular fluid, wellhead injection condition and tube parameters we focal certain parameters on how to affect the fluid temperature and heat loss to reduce the heat loss and increase the fluid temperature.

结合环空流体、井口注入条件和油管相应参数影响，敏感性分析相应参数对井筒流体温度和热损失影响。

A new damping material J-03 was developed. With maximum loss factor of 1.2, and the temperature range of loss factor greater than 0.5 from& 35 ℃ to 40 ℃, this new material is suitable for making miniature damper.

研制了一种J-03阻尼材料，最大阻尼系数为1.2，阻尼系数大于0.5的温度范围为&35～40℃。

Effect of increasing ambient temperature on water loss and thermosensibility ( critical thermal maximum, CT max) was examined in last instar larvae, pupae and adults of Alphitobius diaperinus ( Coleoptera: Tenebrionidae).

本文研究了升高环境温度对小粉虫（Alphitobiusdiaperinus，鞘翅目拟步行虫总科）末龄幼虫、蛹以及成虫的失水和热敏性（临界热极值，Criticalthermalmaximum，CTmax）的影响。

It is shown that the glass-melting temperature, the homogenizing time, and the water content in the environment during the glass-melting and the fiber-drawing process are very important technological parameters in order to reduce the scattering loss.

结果表明，选择适当的熔化温度和均化时间，玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键；

Thermogravimetric analysis shows that the regenerated cellulose has lower initial decomposition temperature and maximum weight loss temperature than initial cellulose. It shows poor thermal stability.

热重分析表明，再生后的纤维素的初始裂解温度和达到最大失重速率时的温度都较低，热稳定性较原纤维素稍差。