temperature optimum的例句大全

Optimization of ISSR-PCR System for Lucuma nervosa by Using Orthogonal Design Through the study on the added amount of NaOH, reaction time and temperature, the optimum production process conditions were determined.

蛋黄果ISSR-PCR反应最佳体系的构建（简报）通过对氢氧化钠的加入量、应时间、应温度等生产条件的研究，得出了最佳生产工艺条件。

The optimization technology of stepwise decrease of re-action temperature is adopted Optimum reaction conditions are 10 ℃ for 1 hour, 5 ℃ for 1 hour and 0 ℃ for 2 hours.

采用阶段降温优化工艺，最佳反应条件为10℃、1小时，5℃、1小时，0℃、2小时。

The fuel consumption rate and exhaust emission increased when the fuel temperature surpassed the optimum range, since the combustion was deteriorated by after burning which was caused due to fuel injection angle delay.

但燃油温度过高时，由于实际喷油滞后角增加过大，致使后燃增加，燃烧恶化，燃油消耗率和污染物排放均增加。

The optimum annealing temperature of the probe was 53 ℃.

探针最适结合温度为53℃。

A New Method for Controlling Optimum Temperature Profile in Tubular Reactor

管式反应器最佳反应温度分布的控制方法

Optimum Temperature Profile and Its Controlling Method in a Fixed Bed Reactor

固定床生产顺酐的最佳反应温度和控制方法

The optimum temperature range for its population increase was 27.5 ℃~ 30 ℃.

美洲斑潜蝇种群增长的最适温度条件为27.5℃～30℃。

The concept of concrete conditional temperature rise test is proposed and the test is done in this work. The results for the conditional temperature of three optimum concrete mix are compared.

提出了混凝土条件温升试验的概念，并对三组较优配合比进行条件温升试验，对比分析温升情况；试验结果显示条件温升试验经济简便，且能够满足工程需要。

Verification indicate this simulation system can simulate slab heating whole process and optimize slab running velocity and temperature condition schedule of furnace operation and provide on-line control with optimum data.

验证表明，该系统能有效地模拟钢板在炉内加热升温的全过程。可以对炉辊速度和炉区温度进行寻优计算，为在线控制提供辊速及炉温制度最佳数据。

The optimum conditions were discussed, stirring speed, temperature and adding sequence played critical roles during the process. Rare earth could lead to lattice distortion, increase lattice constant and achieve good magnetic properties and optimum doping amount was found.

讨论了最佳反应条件，搅拌速率、反应温度、加料顺序在形成纳米级粒子过程中起到关键作用；稀土掺杂能诱导晶胞畸变，使晶格常数增大，提高磁性能，实验得到了优选掺杂量。

Determination of optimum stripper bottom temperature of absorber-stabilizer system

吸收稳定系统解吸塔最佳釜温的确定

Mathematical models and computer optimum control systems are established for rotary furnace and tube reheat-ing furnace in seamless steel tube plant. The tube temperature tracking in the whole process is realized.

建立了无缝钢管热轧生产线上环形加热炉和荒管再加热炉的数学模型和计算机优化控制系统，并实现了无缝钢管热轧过程温度跟踪。

Optimum conditions determined from single factor test and response surface analysis were as follows: concentrations of β-cyclodextrin and water were 3.6% ( W/ W) and 38% ( W/ W) respectively, reaction temperature 44 ℃, reaction time 60 min.

结合单因素试验和响应面分析确定优化的工艺参数为：β-环糊精用量3.6%（W／W），加水量38%（W／W），反应温度44℃，反应时间60min。

For boric acid processing, the optimum technical parameters are reaction temperature 90~ 95 ℃, reaction period 30 min.

以硼酸为原料的合成路线最佳工艺条件为反应温度90~95℃，反应时间30min。

We established three systems for effectively preservation of the microorganism resources: sand preservation tube, freeze-dry preservation tube and ultra-low temperature tube systems. Optimum long-term preservation systems for different strains were investigated by determining the indications before and after the storage.

为了对菌种资源进行有效的保管，分别建立沙土管、冻干管和超低温保藏管三个长期保存体系，并通过入库前后各项指标的测定分析得出不同菌株的最适长期保存体系。

The effect on the microstructures of the brazing seam of Ag-CdO contact terminal and Cu contact bridge by different brazing technological parameters including temperature, holding time and joint gap was analyzed. Based on the analysis, the optimum technological criteria put forward.

分析了Ag-CdO触头与Cu触桥钎焊温度、保温时间、钎焊间隙对钎缝组织的影响，并提出了获得理想组织的最佳工艺规范。

Optimum heat exchange flow has been adopted and the heat exchange terminal temperature of coker feedstock has reached 330 ℃;

采用了优化的换热流程，使焦化原料的换热终温达到了330℃；

According to the rate equation of quasi three level system, the threshold power, slope efficiency and optimum length of the crystals of longitudinally pumped Tm ∶ YAG lasers have been calculated and discussed. The influence of temperature on the Tm ∶ YAG lasers has been studied.

用准三能级系统速率方程对纵向泵浦TmYAG激光器的阈值、效率和激活介质最佳长度进行了计算和分析，讨论了温度对TmYAG激光器输出特性的影响。

The threshold temperature and effective accumulative temperature of the egg were about 13 ℃ and 456.7 degree-days respectively, and the optimum temperature for its development was about 25 ℃.

卵的发育起点温度约为13℃，有效积温为456.7日度，发育最适温度在25℃左右；

But High-latitude Tieling and Jinan populations did not get good acclimation effect. ( 4) The developmental threshold temperature and effective accumulated temperature of 4 populations were analyzed with the liner regression method and the optimum seeking method.

而北方的铁岭、济南种群的低温驯化效果不显著。（4）应用直线回归法和直接最优法计算了中华稻蝗4地理种群卵的发育起点温度和有效积温。