temperature property的例句大全

With optimal design and processing. a 10-bit precision is achieved without laser trimming and good temperature tracking property is obtained in full temperature range (-55~ 125 ℃).

在设计和制作上进行优化，不用激光修调能够达到10位精度，在全温范围内有较高的温度跟踪特性。

About the static magnetic property, with the temperature increasing, the saturation magnetization increased, at first increasing obviously, and then increasing slowly;

从静磁特性看，样品的饱和磁化强度随着还原温度的升高而增大，开始增加明显，后缓慢增加；

A compensation technique for piezoresistive accelerometer's zero error, temperature excursion, dynamic property is worked out in this paper. We give the theory and achieve method of compensation.

对扩散硅压阻式加速度传感器的零点误差、温度漂移和动态特性等进行了分析研究，给出了它们的补偿原理及其实现方法。

MnZn ferrite was prepared by hydrothermal method, and its property was described by XRD, hysteresis loop and temperature rise curve.

采用水热合成方法制得了晶相单一的锰锌铁氧体，对样品进行了XRD、磁滞回线和温升曲线的测定。

And 4 diagnostic characteristics, such as Anthrostagnic moisture regime, Udic soil moisture regime, Thermic soil temperature regime and Ferric property.

并具有人为土壤滞水土壤水分状况、湿润土壤水分状况、热性土壤温度状况和铁质特性4个诊断特性。

Experimental Research on Mechanical Property of Tunnel Lining Concrete after High Temperature Effect

隧道衬砌混凝土高温后力学性能试验研究

The main methods of direct rolling technology for conventional wide strip mill in Europe and America are analyzed. The speed, temperature compensation, buffer. process control and property prediction, etc.

分析了欧美直接轧制技术的主要对策，针对速度补偿、温度补偿、缓冲，过程控制和性能预报等措施加以论述，提出可行的直接轧制方案。

The effects of cooking temperature and time on the biochemical characteristics and textural property of Young Anchovy were investigated.

研究了不同热煮温度及时间对丁香鱼生化特性和质地的影响。

The reduction property of TiO 2-promoted sulfur-tolerant Co-Mo based conversion catalyst was studied by temperature programmed reduction.

利用程序升温还原（TPR）技术研究了TiO2促进的耐硫变换催化剂还原性能，结果发现：添加适量的TiO2可以显著降低主活性组分MoO3及CoO的还原温度。

A typical example concerned with the transient heat and mass transfer process in unsaturated porous media around a buried pipe is presented, which explains the defining of boundary conditions, property data and the method to obtain the initial temperature and wet saturation values.

以埋管周围砂土内的传热传质动态过程研究为例，给出了不同边界条件的描述，介绍了介质物性数据及初始温度、含湿饱和度等的确定方法。

Thermodynamical property of the harmonic oscillator with electrical charge in the electric field under high temperature and weak degeneration

电场中带电谐振子在高温弱简并情况下的热力学性质

Study on the separation property of the temperature sensitive gel

温敏性水凝胶对蛋白质和酶浓缩分离性能

Computation Method of the Kinetic Property of Salinity, Temperature and Depth Probe with Releasing Winding

线圈释放式温、盐、深探头运动特性的数值计算方法研究

The thermal property measurement indicates the final sample in our quiescent system is 100% methane hydrate after several temperature vibration periods.

文中对样品的热物性测试表明，在经过几个温度变化周期后，反应非常完全，反应器中样品是100%的甲烷水合物。

Interface Temperature Optimization and Property Description for the Thermoelectric Materials of the p-Type Graded FeSi_2/ Bi_2Te-3

p-型FeSi2/Bi2Te3梯度热电材料的优值推证与界面温度优化

When the tempering temperature is higher, the microstructure and the property is unusual.

回火温度过高会出现组织性能的异常变化。

A Damage Property Investigation of Compound Fatigue Under Temperature Cycle of the Multiple-Hole Specimen

多孔试件在热循环下的复合疲劳的损伤特性研究

The effect of viscosity ratio on the tensile characteristics, flexural property, impact property and heat deformation temperature of PP/ HDPE were investigated.

研究了粘度比对聚丙烯（PP）/高密度聚乙烯（HDPE）共混物的拉伸性能、弯曲性能、冲击性能以及热变形温度的影响。

The synthesis technology for PET/ nano-meter clay ( NCL) composite was studied, and the effects of NCL on the polymerization of PET/ NCL, the deformation of PET slice, the phase transition temperature and the gas barrier property were discussed.

研究了聚对苯二甲酸乙二醇酯（PET）/纳米累托土（NCL）复合材料的合成工艺，讨论了NCL对PET聚合工艺、切片的形变和相变温度以及气体阻隔性能的影响。

The effect of low temperature thermomechanical treatment on precipitation kinetic, mechanical property and fracture morphology, as well as the influence of aging time on tensile property and fracture morphology was studied by means of metallography, Brinell hardness test, tensile test, DSC and TEM.

采用金相、布氏硬度、拉伸、DSC以及扫描电镜等研究手段研究了低温形变热处理对时效析出动力学、力学性能和拉伸断口的影响，以及时效时间对拉伸性能和拉伸断口的影响。