temperature range的例句大全

The thermal stable temperature range for various types of diamond and its relation with diamond's strength are also provided.

提出了各种类型人造金刚石的热稳定温度范围及与强度的关系。

The results showed that the normal growth of refined grain at the pertinent thermal processing temperature range and holding time has no deteriorative effect on the refinement, i.e., the refined grain was still much finer than unmodified grain.

结果表明，热加工温度下材料内部正常晶粒长大不会使其丧失变质细化效果，晶粒仍比无变质细化的铸棒细得多。

No obvious abnormal heat capacity was observed within this low temperature range. The thermal decomposition temperature range of the complex was near 333 K. Its decomposition temperature, decomposition enthalpy and entropy were 320.010 K, 40.714 kJ/ mol and 127.227 J/ molK, respectively.

333K附近是该配合物的分解温区，配合物的分解温度、分解焓和分解熵分别是320.010K、40.714kJ/mol和127.227J/molK。

The increase in thermal cycles or temperature range aggravated the damage of the composites.

增加循环周次或扩大温度区间都会加剧材料的破坏。

The thermal cycle dwell time, thermal cycle temperature range and the maximum dwell temperature were changed to observe their effects on the thermal fatigue life of solder joint; the length and thickness of substrate were also changed to research the dimension effect.

通过改变热循环保温时间、温度范围和最高温度，研究各参数对焊点热疲劳寿命的影响，同时也考察了基板的长度和厚度的影响。

The processing method for latent heat releases in alloy castings is introduced by the combination of the temperature recovery and the equivalent heat capacity, which can be applied in alloy solidification of any temperature range with the high efficiency.

通过温度回升法与等效热容法的结合，提出了一种能够处理铸件凝固潜热释放问题的方法，它可适用于任意结晶温度区间，且计算效率很高。

There are a minimum value of the porosity and a maximum value of the thermal conductivity in the sintering temperature range.

在烧结温度范围内随着气孔率出现最小值时，导热系数出现最大值。

Based on thermodynamics and experiments, the temperature range for dephosphorization was obtained.

将热力学计算与现场试验相结合，确定了该法的脱磷期控制温度范围。

The mechanism of friction and wear of different temperature range was discussed by the analysis of the results of Friction and wear test through SEM and EDS. Compared with other high quality products which from domestic and foreign.

运用SEM和EDS对样品的磨损表面进行了分析，讨论了不同温度范围内的摩擦磨损机理，并与国内外优质的摩擦材料进行性能对比。

The dynamic viscosity of In-55wt% Sb hypoeutectic alloy melt was measured in a wide temperature range above liquidus in heating and cooling processes by using a torsional oscillation viscometer.

利用回转振动粘度仪在液相线以上较大温度范围内，测量了In-55%Sb（质量分数）亚共晶合金熔体在不同的升降温过程中的粘度。

The TG experiments of SVR and Shenfu coal showed that the reaction temperature range on co-processing was 430~ 490C.

神府煤和胜利减压渣油的热重实验表明430～490℃为煤油共处理适宜反应温度。

With the heavy fraction of FCC naphtha as feedstock, the experiments were conducted in a fixed-fluidized bed reactor over different type of acid catalysts respectively in a reaction temperature range of 400-520 ℃.

以FCC汽油重馏分为原料，采用不同类型的酸性催化剂，在小型固定流化床装置上进行催化裂化反应类型实验，反应温度为400-520℃。

The experiments were designed to remove HCl, NH 3, organic sulphur and coal tar component in high temperature coal gas, in combination and simultaneously by using a fixed-bed reactor at the reaction temperature range from 300 ℃ to 550 ℃.

在固定床反应器中首先对高温煤气中氨、有机硫化物、氯化氢及焦油4种污染物进行了同时脱除，其中选择CS2和1-甲基萘分别作为高温煤气中有机硫化物和焦油蒸气的模型化合物。

Under the operation pressure of 30 kg/ cm2 and the reaction temperature range of 155-180 ℃, the Rh(ⅰ) complex catalyst would not be decomposed and precipitated by the change of partial pressure, the insufficient supply and uneven distribution of carbon monoxide.

当操作压力为30kg/cm~2，反应温度在155&180℃范围内，发现该催化剂不因一氧化碳分压改变或供给不足、分布不均等而引起分解沉淀。

The main results are as follows: The best interface temperature, optimum length ratio, and maximum output power of n-type Bi2Te3/ CoSb3thermoelectric materials with wide temperature range were investigated with the intersection method of the ZT curves.

得到了以下主要结果：采用ZT值曲线交点法研究了n型Bi2Te3/CoSb3宽温域梯度材料的最佳界面温度、最佳长度比和该材料构成的n型热电臂最大输出功率。

Self-transformation kinetics of porous glass granules into B-Al-MFI-type zeolite in a vapor phase of ethylamine and water was studied in the temperature range of 408~ 453 K. The products obtained in the transformation process were investigated with XRD.

以XRD为表征手段详细研究了408～453K温度范围、多孔玻璃粉在乙胺和水的蒸汽相中自转变为B Al MFI型沸石的自转变动力学。

Desulfurization experiment of metallurgical dust has been done under conditions of different reaction atmosphere with temperature range of 50~ 650 ℃.

在50~650℃的温度区间内进行了冶金粉尘在不同反应气氛条件下的硫化穿透实验，结果表明，反应温度与反应气氛对冶金粉尘脱硫有较大的影响。

The temperature increment is proportional to the inputted power in a certain temperature range. Pan-based carbon fiber mat has temperature sensibility.

在一定的升温范围，PAN基碳纤维毡的稳定温升与输入功率成正比；

Layered zinc benzoate hydroxide compound with a basal spacing of 1.44 nm was prepared by hydrothermal reaction in a temperature range of 110~ 180 ℃.

在110～180℃范围内，以Zn（OH）2与苯甲酸为原料水热法成功合成了层状氢氧化苯甲酸锌化合物。

The results indicate that the crosslinking agent can significantly improve the tensile strength, tear strength, water resistance and the dynamic mechanical properties in a wide temperature range.

结果发现，此交联剂可以显著改善水基PUR膜的拉伸强度、撕裂性能、耐水性和较宽温度范围内的动态力学模量。