temperature zone的例句大全

The diagnostic results further indicate that the temperature advection Plavs an evident role on the formation of the convergence zone over South China in addition to the relation with the anomalous hea-t ing;

诊断分析进一步指明，华南辐合带的形成除与异常加热直接有关外，温度平流也有显著作用；

A stirrer mounted at neck can improve the heat distribution of molten glass and drop the temperature in conditioning zone;

卡脖处安装搅拌装置可提高玻璃液的热均匀性，并能降低冷却部温度；

The analysis results showed that: after 50 cycles under temperature drop of 980 ℃, no cracks seen by naked eyes occurred on the surface and no debonding phenomenon happened in the interface bonding zone.

分析结果表明：在温差980℃下循环50次后，其表面未出现任何肉眼可见的微裂纹，且其界面未出现脱粘的现象。

The research results showed that the slab surface temperature dropping into the third brittle zone played an important role in causing transverse crack formation of microalloyed slab.

研究表明，铸坯表面温度落入钢的第三次脆性温度区是造成铸坯表面横裂的一个重要原因。

But when the Φ value is higher, as the Φ increases, τ is hardly altered. In the process of squeeze cast particles reinforced metal matrix composites, the temperature equilibrium equations of infiltration zone were established and solved.

但当Φ值很大时，Φ的升高使τ＊的减少不明显.建立了挤压铸造MMCs过程中液态金属浸渗区和未浸渗区的温度平衡方程，并求出了差分解。

Numerically results of the upwelling ( downwelling), coastal jet and temperature front zone are favorable to the observations.

计算所得的上升流、沿岸急流、温度的锋区结构与一些观测事实接近。

When extrusion granulating, the temperature of head and homogenizing zone in extruder should be strictly controlled;

挤出造粒时，应严格控制机头和均化段温度。

There is a liquid/ solid phases coexist zone with a large temperature interval below the temperature of monotectic reaction, it has no remarkable effect on the phase reparation of alloys.

Cu-Pb偏晶合金中在偏晶温度以下存在温度区间较宽的液/固相共存区，对合金的相分离影响不显著。

The composition of slag lies in 2CaO · Sio_2-liquid biphase zone, and that can assure proper smelting temperature and maximum activity of Cao;

炉渣组成位于2CaO·SiO2－液二相区内，可以保证合适的冶炼温度和最大的氧化钙活度；

Due to the individual differences of physiological and psychological responses, clothing insulation and activity, as well as the preference to air temperature and movement and so on, the comfort demanded by different people within the occupied zone is different.

由于人们在生理和心理反应、衣着量、活动水平以及对空气温湿度和风速偏好等方面的个体差异，对个人活动区域舒适的环境需求也各不相同。

This strategy consists of two parts: steady state zone temperature optimization and its dynamic compensation.

该控制策略包括稳态优化炉温设定值的求解和炉温设定值的动态补偿。

A two dimensional mathematical model for ingot solidification has been established and new methods such as revised temperature recovery method, mean boundary radiation thermal flow and variable time-step length by zone have been applied in this paper.

本文建立了钢锭冷凝过程的二维数学模型，采用了修正温度回升法、平均边界辐射热流、分区变时间步长等新方法。

At the same time, the depth of die heat affected zone ( HAZ) transfer law and influential mechanism of temperature wave have been analyzed, which lay a foundation for further research of temperature field and thermal stress filed of die. calculation of casing thermal stress;

同时分析了温度波在模具中的传递规律，热影响区范围与影响机理，为进一步开展锻模温度场与热应力场的研究提供了基础。

The convection of melt in a floating zone driven by surface tension due to temperature gradient is studied in this paper.

本文以悬浮区为背景研究液桥中气液交界面上由表面张力所驱动的流体对流。

Influence of the characteristics of air supply terminal devices on velocity field and temperature gradient in occupied zone with displacement ventilation

末端装置特性对置换通风工作区速度场与温度梯度的影响

The thermoplasticity in high temperature brittle zone was poor because of the dislocation austenite grain boundary.

Mn18Cr18N钢在高温脆性区塑性变差的原因是由于奥氏体晶界成为位错晶界；

The thermoplasticity in a high temperature plastic zone was good because of the deformation twin formed in austenite grains.

在高温塑性区塑性良好是由于奥氏体晶粒发生大量的孪生变形；

Temperature control of film oil screen zone in power capacitor

电力电容器薄膜屏带油温度控制

The calcination temperature is 6000C. a. zone, E.

煅烧温度6000C。C带，E。

A continuous hot model of lumpish zone in a blast furnace was used to get the relationship between carbon loss rate of coke and temperature in lumpish zone.

应用一个连续高炉块状带热模型得到失碳率和温度在块状带的关系。