tensile sample的例句大全

for this reason, has to skilfully control the velocity of tensile test and take notice of abutting joint of sample and . . .

为此，应熟练拉伸试验速度的控制，注意试样的对接和断后标距的测量。

a preliminary evaluation of tensile properties of small plastic bonded explosive sample by diametric disc test

用直径圆盘试验评价小样品塑料粘结炸药拉伸性能的初步研究

the effect of shape of high grade steel pipeline sample on tensile test result

高钢级管线管试样形状对拉伸试验结果的影响

Take full account of the preparation of standard test sample, set of device parameters, temperature and other details on the polyethylene pipe specimen, constant strain rate tensile, creep test and relaxation test are accomplish.

充分考虑标准试验试样制备、设备参数设置、温度调节等细节，对聚乙烯管试样进行等速率拉伸、蠕变、松弛试验，通过合理的试验处理得到真实应力应变曲线以及力学性能参数。

after softening with se-3, various sensuous indexes of leather sample, such as tensile strength, given load extensibility, breaking extensibility and water permeability are obviously superior to the original ones.

将SE-3用于皮革柔软处理，经处理后革样的各种感观指标如抗张强度、规定负荷伸长率、断裂伸长率、透水性明显优于原革样。

Analysis Of Fracture Shape Of Low-carbon Steel Tensile Test Sample

低碳钢拉伸试样断口形状分析

Influencing Factors of Fracture Layered for Tensile Test Sample of High Strength Ship Plate Steel

高强度船体用结构钢拉伸试验样断口分层的影响因素

This paper discusses the fracture shape of the tensile test sample in practice teaching of mechanics.

本文就力学实践教学中拉伸试样断口形状问题进行探讨。

The Microfracture Analysis of the tensile Test sample of the Heavy Section Ductile Cast Iron Cask

厚大断面球铁核容器拉伸试样断口显微分析

It was different obviously between the critical macro-parameter of void divergence ratio VGC in the tensile abruption sample and those in the impact abruption sample ( diversity ratio up to the scale from 39% to 200%).

X80钢试样冲击断裂时的宏观形式的临界孔洞扩张比VGC与拉伸时的结果有很大的偏差（相差39%～200%）。

The test results show that with increase of plasticizer DOP content, surface hardness and tensile strength of sample decrease and breaking elongation ratio increases.

试验结果表明：随着增塑剂DOP含量的增加，试样表面硬度逐渐降低，拉伸强度逐渐降低，断裂伸长率逐渐增加；

After annealing, the tensile strength of sample hot-dipped with Al-7% Si, improved remarkably, and the plastic deformation increase at the same time.

浸Al-7%Si退火后抗拉强度有显著提高，塑性也有所改善。

When the deformation temperature increases, the tensile strength of deformed sample will fall.

随变形温度的升高，变形所得试样抗拉强度下降；

In this paper, the mechanical property parameters of the adhesive were gotten by tensile test on standard sample at first.

但由于种种因素，胶粘剂性能的理论研究仍然很不成熟。

The tensile strength of the sample was improved notably with the increases of the vibration frequency and pressure, where the maximum increase was 41%.

随着振动频率和振动压力的增加，振动试样的拉伸强度得到明显改善，其最大增幅为41%。

When temperature is same, the tensile strength of deformed sample will increase as increasing deformation, but it will not increase and will fall when the deformation exceeds a certain value.

在同一温度下变形所得试样抗拉强度随变形程度的增加而升高，变形程度达到一定值后，抗拉强度不再升高并有下降的趋势；

The synthetic method of HIPS inserted nano-MMT was studied, the impact strength and the tensile strength of the sample were measured, the structure appearance of the sample's impact cross section was observed.

研究含纳米蒙脱土的高抗冲聚苯乙烯（HIPS）的制备工艺，测试了试样的冲击强度和拉伸强度等力学性能，观察了试样冲击断面的结构形态。

By means of in situ SEM tensile deformation and rod sample deformation tests, the effect of brittle fracture of Nd rich second phase particles on the fracture behaviors of a near α titanium alloy has been investigated.

通过薄片试样原位拉伸和圆棒拉伸实验研究了富Nd第二相颗粒的早期脆性断裂对一种近α型钛合金断裂行为的影响。

It was found that at low injection rate the tensile specimen has the best performance for both tensile strength and impact toughness; at low melt temperature, although the tensile properties of the sample is better, but its impact toughness is reduced.

研究发现，低注射速率条件下试样有最优的拉伸性能与冲击韧性；低熔体温度条件下的试样虽然拉伸性能较好，但其冲击韧性反而降低。