theoretical length的例句大全

The change of pressure in the flow passage of plate thin channel filter device and the main factors effected on the largest theoretical length of plate thin channel filter device at the lower pressure ( < 5 × 10 5Pa) were discussed.

探讨了稳态状态下板式膜过滤器薄层通道中压力变化的规律，并讨论了低压下（＜5×105Pa）影响板式过滤器理论最大过滤组件长度的主要因素。

Theoretical calculation of air column length of charge structure for smooth blasting

光面爆破装药结构空气柱长度理论计算

Study of Theoretical Plate Length on the Inclined Plate Separator

斜板沉降器的理论板长的研究

Then theoretical resonance length, small end diameter, displacement node, magnification factor, shape factor and other parameters of the amplitude amplifier pole could be determined.

确定出其理论共振长度、小端直径、位移节点、放大系数、形状因数等参数。

Installation error will cause the bevel gear meshing error in low-load or overload conditions, the actual contact length is less than or greater than the theoretical contact length.

安装误差会引起锥齿轮副啮合误差，在低载或重载条件下，实际接触长度小于或大于理论接触长度。

The harmonic chain drive has a periodically varied theoretical chain length during its operation. This paper analyzes the changes in theoretical chain length when wave generator is at different positions, and indicates their effect on driven sprocket angular speed and transmission ratio.

谐波链传动在传动过程中所需链条的理论长度呈周期性变化，分析了传动中波发生器处在不同位置时链条理论长度的变化情况，并指出了这种变化对从动链轮角速度及传动比的影响。

This makes it possible for theoretical powder charge length of a row or a tier boreholes to be further calculated complexly for wider use.

从而可进一步对一排（层）炮孔理论装药长度进行复合计算和更广泛使用。

Then, the theoretical meshing arcus length and the simutaneous meshing tooth numbers of four tooth and two tooth difference harmonic drive are analyzed.

对双波四齿差和二齿差谐波齿轮传动的理论啮合弧长和可能同时啮合的齿对数进行了分析比较；

Based on the theoretical model, the length of trajectory, number of grinding marks and grinding stable period are deduced. The relationship between grinding surface quality and the density of grinding marks is theoretically analyzed.

在运动学模型的基础上，推导了磨粒轨迹长度、磨纹数量以及磨削稳定周期的公式，并分析了磨粒轨迹对表面质量的影响关系。

A theoretical research on the size and evenness of the fixed size silk& ii. on the delayed length under the limit size for cocoon feeding

定纤生丝纤度与匀度理论研究&Ⅱ、细限纤度以下的落细丝长

Theoretical research on specific impulse performance and chamber length of hydroreactive metal fuel motor;

水反应金属燃料发动机系统构型研究需要以燃烧数值模拟作为研究基础。

It has been shown that the substitute mark of the muscle origins and terminations have an important theoretical meaning and an applied value for the determination of muscle length, muscle tension curve and muscle arm and for the rational assessment of the muscular function.

研究结果表明：肌肉代起止点对确定肌长度、肌拉力线、肌力臂和定量评定肌肉功能有十分重要的理论意义和应用价值。

The theoretical research shows that the SBS induced damage mostly happens at the entrance surface of pump laser and the threshold intensity is inversely proportional to laser pulse width and the interaction length.

研究发现，SBS作为一种破坏机制，表现为前表面破坏，且破坏阈值与激光脉宽以及作用区长度均成反比。

Theoretical analysis and computational simulation show that ( 1) there are a group of finite length generalized inverse signals for any finite signal, which form the GIG;

研究表明，有限长信号存在多组有限长广义逆信号，它们构成原信号的广义逆群；

The authors designed a kind of improved control system based on the theoretical relation among the initial gauge length of sample, travel rate of testing machine transom, time and sample's real constant-strain rate.

根据试样初始标距长度、试验机横梁移动速度、试样真实恒应变速率和时间的理论关系式，设计了改进的控制系统。

On the basis of analyzing transiting characteristics of the rope in transiting area, two theoretical formulas length and angle of transiting area are derived by means of differential geometry, mechanics and mathematical analysis methods.

从钢绳多层缠绕过渡过程入手，运用微分几何、力学、数学分析的方法，研究钢绳过渡情况，提出层间过渡块的几何形状和计算公式及钢绳圈间过渡长度和角度理论公式。

The paper study the problem by constructing theoretical model of diffracted sound attenuation of limited length barrier.

通过建立有限长声屏障的绕射声衰减的理论模型，进行了这方面的探讨。

After theoretical analysis, system construction, experimental verification and error analysis, the thesis argues that the method has fair value for practical use, and the system based on this scheme possess of advantage in the great length Guide-ways straightness measurement.

本文通过理论分析、系统搭建、实验验证以及测量误差分析等一系列工作，论证了该系统具有一定的实用价值，基于该方案的系统在大长度导轨直线度测量中具有一定的优越性。

In addition, we compared the efficiency of extraction in two-stream and three-stream laminar flow. A theoretical model based on diffusive length was also established. 5.

此外，还比较了两路层流和三路层流对于萃取效率的影响，建立了基于扩散距离的萃取模型。

The influences of molecular bond length and bond angle on molecular volume were also analyzed. Those provide theoretical basis for using what kind of membrane and solvent for membrane separation of isoflavone.

并且分析键长和键角对体积的影响，从而对于采用何种膜、何种溶剂对大豆异黄酮进行膜分离提供了理论依据。