thermal polymerization的例句大全

Chemical cross-linking gel polymer electrolyte was fabricated by the method of in-situ thermal polymerization.

采用单体热聚合的原位电解质凝胶法制备了化学交联型凝胶聚合物电解质。

Synthesis of DCPD Petroleum Resin by Thermal Polymerization

热聚法合成双环戊二烯石油树脂

Kinetics of bulk thermal polymerization of styrene with ethylbenzene

苯乙烯热引发本体聚合动力学

The reaction rate constant and activation energy of soybean oil thermal polymerization reaction were determined by analysis of the change of viscosity.

以大豆油为原料，根据热聚合反应过程中黏度的变化确定反应的速率常数及热聚合反应的活化能。

A model for styrene thermal polymerization process in tubular reactor has been developed starting from basic transport equation without adjustable parameters.

建立了管式层流反应器中苯乙烯本体热聚合过程的模型。

Study on the thermal polymerization preparation of pre-polymer with high-content mesophase from coal tar pitch

软沥青热聚合制备高含量中间相预聚体的研究

This paper introduced and compared the processes of catalytic polymerization, thermal polymerization and initiative polymerization for producing C9 petroleum resin;

介绍了生产普通C9石油树脂的催化聚合、热聚合和自由基引发聚合工艺，并进行了工艺对比；

Thermal polymerization temperature was too low to form a mesophase ordering; temperature was too high, the coke prepared often poor and loosely ordered.

热聚温度过低，无法形成有序性中间相；温度太高，制备的生焦往往有序性差且结构松散。

The thermal polymerization of phenylacetylene occurred to a negligible extent below 100 °; at 100-160 °, the rate of polymerization increased with increasing temperature.

苯乙炔的热聚合在100°以下很少发生，在100&160°，聚合速度随温度升高而迅速增加。

In low absorbance, the kinetics of photopolymerization is similar to that of thermal polymerization, while in high absorbance, they will be quite different.

体系低吸光度时光聚合动力学与热聚合时类似，而在高吸光度时完全不同。

Thermal polymerization time was conducive to the full formation of mesophase, financial and ultimately the formation of non-spherical mesophase streamlined, fibrous coke structure.

热聚时间的延长有利于中间相小球体充分生成，融并，最终形成非球中间相广域流线型、纤维状的生焦结构。

In this paper, the polymerization rate and average molecular weight of thermal-initiated polymerization of styrene in the range of 120~ 200C were studied. The polymerization rate was found to be proportional to the square of styrene concentration, thus a second-order initiation is inferred.

在120～200℃内，对热引发苯乙烯本体聚合的速率及平均分子量进行了研究，得到聚合速率与单体浓度二次幂有关，据此可以推论引发速率也和单体二次幂有关。

Interfacial Polymerization Preparation and Thermal Decomposition Kinetics of Polyurea Microencapsules Containing Capsaicine

聚脲体系辣素微胶囊的界面聚合法制备与热降解动力学

The hydrolytic polymerization of Cr 3+ was studied by microcalorimetry. The Thermal curve was determined According to thermokinetic theory, the Gibbs free energy and equilibrium constant of activation were calculated.

对较高浓度下3价铬离子水解聚合作用的热谱曲线进行热动力学分析，用特征热谱参量，求出了这一连串反应的速率常数和活化平衡常数及活化自由能。

Thermal initiation in the stable free radical polymerization of styrene

苯乙烯稳定自由基聚合过程中的热引发作用

A comparison between initiators and thermal initiation in the mass polymerization of styrene

引发剂引发与热引发在苯乙烯本体聚合中的比较

The effects of initiators and thermal initiation on a reaction rate, molecular weight and molecular weight distribution of products in a mass polymerization of styrene were investigated.

考察了热引发方式和不同种类、浓度下的引发剂引发方式在苯乙烯的本体聚合中对聚合反应速率和产品的分子量及其分子量分布的影响。

Thermal Pressure Coefficient and Degree of Polymerization for Poly-Dimethyl-Siloxane

聚二甲基硅氧烷的热压力系数与聚合度

Thermal pressure coefficients and densities for four poly-dimethyl-siloxanes which have different degree of polymerization were measured over the range ot temperature from 20 to 100 ℃.

本文测定了在20～100℃温度范围内，四个不同聚合度的聚二甲基硅氧烷的热压力系数和密度。

By adding calcium carbonate filler and thermal stabilizer in the VC polymerization processing, PVC special-use resins ready for processing were synthesis.

介绍了在VC悬浮聚合中添加碳酸钙填料和热稳定剂，合成可直接用于加工成型的PVC专用粉料的开发工作。