threshold power的例句大全

Power-fail threshold accuracy +-2 % .

电源故障门限准确度 +-2%.

While the theoretical power output of the motor increases first with the increase of the pressure drop, reaches its maximum value when the pressure drop gets to a threshold value, then decreases gradually until the motor stops.

而马达的理论输出功率先随压降增加而增大，压降达到某一临界值时，理论输出功率达到最大，随后逐渐减小，直至马达停转。

The output power of high-power semiconductor lasers is greatly influenced by the temperature change, small temperature change can cause large fluctuation in output power and wavelength, threshold current and life will be affected.

大功率半导体激光器的输出功率受温度变化的影响很大，微小的温度变化就会导致输出功率很大的波动，而且波长、阈值电流和使用寿命也会受到影响。

The mode whose lifetime is longer has less threshold. ( 5) The morphology and temporal dependence of the power spectra in two-dimensional random media are studied.

寿命越长的模式，其阈值越小。（5）研究了不同形态对二维被动随机介质功率谱的影响。

We can monitor many parameters and characteristics by measuring TEN, such as surge frequency, spectrum width, threshold current, mode jump and stability of output light power.

通过对激光的电噪声的测量可以监测激光器的诸多参数和特性，如弛豫频率，谱线宽度，阈值电流，模式跳变及输出光功率是否稳定等。

Threshold voltage adjustment in low power digital circuit

低功耗电路阈值电压的调节

An effective way to reduce the leakage power is by means of multithreshold CMOS technique, which can restrain the leakage current by adding a MOS transistor to low threshold circuit.

多阈值CMOS技术是一种降低电路漏电流功耗的有效方法.它通过接入高阈值MOS管来抑制低阈值模块的漏电流。

In addition, the power modules, the clock circuit, a threshold level circuit and the USB interface circuit were implemented.

另外，完成了电源模块设计、时钟电路的设计、门限电平产生电路设计、串口转USB接口电路设计。

In this paper, the stability condition of optical resonator is introduced, the power losses of stable resonator and the threshold condition of optical oscillation is discussed, and the formulation of the relationship between the gain coefficient of work substance and the losses factor is derived.

本文对光学谐振腔的稳定条件做了介绍，并讨论稳定谐振腔的功率损耗和光振荡的阈值条件，导出了工作物质的增益系数与损耗因子的关系式。

Low Threshold Current High Output Power Fundamental Transverse Mode 1.3 μ m InGaAsP/ InP BH Laser

1.3微米低阈值大功率基横模BH InGaAsP/InP激光器

Further, a maximal output power of 9.4W, vertical divergence angle of 32 °, and threshold current density of 239A/ cm2 can be obtained by adapting broad waveguide layers.

采用宽波导结构可以得到器件的最大输出功率为9.4W，发散角为32°，阈值电流密度为239A/cm2。

The InGaAs/ GaAs strained quantum well lasers are able to work with extremely low threshold current density, high characteristic temperature and high COD limit, which make Ld lasers achieve higher output power and longer Ufe.

InGaAs/GaAs应变量子阱激光器具有级低的阈值电流密度、较高的特性温度和较高的光学灾变损伤阈值，这使得激光器具有更高的输出功率和更长的寿命。

Choosing three cases of Al-content of the waveguide layer and the cladding layer, we calculate and analyze the dependences of the optical confinement factor, maximal output power, vertical divergence angle, and threshold current density on the thickness of the waveguide layer.

选取了三种情况的波导层和限制层的铝组分，分别计算和分析了波导层厚度与激光器光限制因子、最大出光功率、垂直发散角和阈值电流密度的函数关系。

Calculated results show that when the Al-content of the waveguide and cladding layers are 0.4 and 0.5 respectively, a maximal output power of 11.2W, vertical divergence angle of 19 °, and threshold current density of 266A/ cm2 can be achieved by adapting narrow waveguide layers;

根据计算结果可知：当波导层和限制层铝组分为0.4和0.5时，采用窄波导结构可以获得器件的最大输出功率为11.2W，发散角为19°，阈值电流密度为266A/cm2；

Low power design methods of setting threshold on viterbi decoder

Viterbi译码器设置门限的低功耗设计方法

Response threshold detection of auditory brainstem response by phase spectral analysis together with power spectral analysis

相位谱结合功率谱分析在听性脑干反应阈值客观自动化测试的应用

Three methods for analyzing and processing the laser scattering signal of bubbles in water, the threshold detection, noise elimination processing and power spectral estimation, are put forward.

提出了阈值检测、降噪处理和功率谱估计三种分析和处理水中气泡激光散射信号的方法。

In addition, the programmable threshold detector allows monitoring of the incoming signal power, using the four fast detect bits of the ADC with very low latency.

此外，利用ADC的4个快速检测位，可编程阈值检测器可以监控传入信号的功率，并且延迟非常短。

When the zero sequence voltage is below the threshold, this element adopts the recorded voltage of the faulted-phase to replace the zero sequence voltage, and then determine the zero sequence power direction. The simulations use recorded fault data show that this element is correct and reliable.

当零序电压低于门槛值时，依据选相结果，该元件采用保护安装处故障前的故障相电压代替零序电压，进行零序功率方向判别。

Considering the noise effects on the fault identification and detection in power system, with the analysis on wavelet transform characteristics of noise signals, this paper puts forward a threshold evaluation method based on wavelet transform coefficient.

考虑电力系统中噪声因素对故障检测与识别的影响，在分析了噪声信号的小波变换特性的基础上，提出一种基于小波系数的阈值估计方法。