throttle pressure的例句大全

The part of tube prescribes the throttle character and the pressure regulation principal of the valve, and calculating press lose of straight tube, siphon and cross tube.

详细分析了阀门的节流特性与调压原理，以及直管、弯管、三通的压力损失计算方法；

The flow tests under the room temperature and the cryogenic environment show the capability of the throttle valve controlled by pressure difference to adjust the flow rate is bigger than that of the capillary tube with constant flow area.

分别在室温和深冷环境下进行的流量实验表明，该压差控制节流阀调节流量的能力较强。

This paper presents a new kind of digital hydraulic control system. It is a parallel connection system and this system uses the high-speed valve as a pilot valve to control the twin throttle which controls the pressure and the flux of the hydraulic control system.

该文介绍了一种新型的数字式液压操纵系统，系统采用并联方案，以高速电磁阀为先导控制级，通过双节流阀进行操纵系统的压力、流量控制。

Such features include, for example, the use of throttle regulation for high pressure cylinder inlet steam to minimize pressure loss, the preven-tion of excessive speed after load rejection, and lond adjustement patterns, etc.

如，高压缸进汽采用节流调节、力求减少压力损失、甩电负荷后需限制转速过分飞升、负荷调整方式等。

The multistage throttle intelligence control system is a set of complex machine, the electricity and the fluid integration system, which involves many technologies, its essential technology is to control the throttle valve pressure drop to the well the real-time control.

多级节流智能控制系统是一套复杂的机、电、液一体化系统，涉及多项技术，其关键技术是对井控节流阀压降的实时控制。

By discussing the detailed structure of increasing pressure element, heat transfer elements, throttle and the working process, the structure design of the refrigerating system is introduced based on low pressure air as power and working medium.

通过详细论述增加单元，换热单元和节流制冷单元的结构和工作过程，介绍了一种以低压空气作为动力和工作介质的制冷系统结构设计。

Controlling of water wall thermal deviation of supercritical pressure boiler by use of two-step throttle scheme

采用两级节流控制超临界锅炉水冷壁热偏差

In order to reduce the loss of turbine throttle valve regulator and guarantee a high unit efficiency, the sliding pressure operation mode is widely used when unit load is changing.

为了减小汽轮机调节阀的节流损失并保证较高的机组运行效率，火电机组变负荷时采用滑压运行方式。

The simulation results showed that the high pressure fluid speed mutation and pressure drop is the largest when high pressure fluid flow through the throttle mouth place. The appearance of cavitations and eddy was easily to observe at the place of throttling mouth area.

仿真结果表明：高压流体在节流口处是速度突变最大和压降最大的地方，在节流口区域处很容易观察到有气穴和漩涡现象发生。

The monitoring and data acquisition systems of the electronic inlet air heating, low pressure injection for the intake pipes, throttle control EGR for the exhaust pipes and knocking inspecting, were developed and used well in the engine testing.

开发了进气电加热、进气道喷油、排气管节流EGR及爆震等监控和试验数据采集系统，实现了单缸进气温度、供油量、排气再循环（EGR）的控制和检测，阐明了其结构与工作原理。

Higher preburner pressure during combustion chamber ignition stage is necessary, at the same time acceleration of chamber pressure should be limited by setting throttle on combustion chamber fuel supply line.

燃烧室点火时预燃室应有较高的压力，同时应通过推力室燃料路的节流来减小燃烧室压力的上升速率；

The output characteristic of the non linear throttle hydraulic system with the constant pressure source under the effect of sine function was discussed with describing function of frequency characteristic in the article.

采用频率特性的描述函数法，讨论带恒压源的非线性节流式液压传动系统在正弦函数作用下的输出特性。

dynamic model of the closing process of a high pressure turbine's throttle valve

汽轮机高压主汽门关闭过程的动力学模型

reduced pressure near the partially closed throttle valve caused the fuel to flow from the idling jet into the intake air.

由于部分关闭的节流阀附近的压力下降，燃油由怠速喷口喷入吸进的空气。

Remove the throttle cable, cruise control cable ( if equipped ) and the transmission line pressure cable.

将节流阀电缆 、 车速控制电缆 ( 若已配备 ) 、及变速箱管线压力电缆拆下.

Flexible throttle simple structure, small pressure drop, high reliability and action.

柔性节流阀结构简单, 压力降小, 动作可靠性高.

Analytic Computation of Throttle Slice Deformation on Linear Non-uniform Pressure for Telescopic Shock Absorber

线性非均布压力下减振器环形阀片变形解析计算

Throttle body made from high temperature and high pressure liquid into the evaporator of refrigeration.

节流机构使制冷从高温高压液体进入蒸发器。

An empirical equation for hydraulic resistance was obtained after the effects of pitch number of throttles, throat diameter, temperature, pressure, flow rate and outside heat source on the hydraulic resistance of throttle set were examined.

通过研究节数、喉部直径以及温度、压力、流量和外部热源等参数对节流件阻力特性的影响，获得了计算节流件阻力的经验关系式。