thrust balance的例句大全

An empirical equation for pulley thrust balance was derived. The equation is expressed in an explicit form.

还导出了带轮推力经验平衡方程式，该式以显函数形式表示。

axial thrust balance principle of high-head mixed-flow water turbine generator set

高水头混流式水轮发电机组的轴向推力平衡原理

Individually sized for pressure break down, and axial thrust balance.

个别中小企业的压力分解, 并轴向推力平衡.

It also has presented balance conditions of the thrust floating ring and the design criteria.

提出了保证浮环正常工作的平衡条件，并据此给出了浮环轴承的设计准则；

This paper has analysed the characteristics of the thrust floating ring in hybrid sliding cylindric bearing by finite element method. It also has presented balance conditions of the thrust floating ring and design criteria.

对圆柱浮环液体动静压轴承止推环的静、动态特性进行了有限元分析，提出了保证浮环正常工作的平衡条件，并据此给出了浮环轴承的设计准则；

It is a balance system that the anti-slide pile is exerted by three kinds of force, they are the tensile force of anchor, the thrust of sliding mass, the resistance of soil and rock.

一般认为锚杆（索）抗滑桩在锚杆（索）拉力、滑坡推力、桩前滑体抗力的作用下绕锚固点（锚拉力作用点）保持力矩平衡，锚固点为一铰支点。

The fastest human-powered vehicles at sea levels are recumbent bicycles enclosed in streamlined aerodynamic shells. These vehicles have an upper speed limit near 40 m/ s-the speed at which the human can just barely produce enough thrust to balance the drag force from the air.

目前最快的人力车是包裹在流线型空气动力学外壳里的躺式自行车，这种自行车的速度最快能达到将近每秒40米，再快人力就已经不足以抗衡空气阻力了。

Within the block, 4 kinds of structural transformation modes were formed: thrust nappe structure, secondary shear structure, shear and flaser structure, and arc extrusion structure, thus reaching a transformation balance between active structures with different directions and different features.

在块体内部形成了挤压推覆构造、次级剪切构造、剪切压扁构造和弧形挤出构造等四种典型的构造转换方式，实现不同方向与不同性质活动构造之间的转换平衡。

The structure of the middle load and concrete-filled steel tube ( CFST) "Fly-bird-type" arch bridges, with flexible tied bar, uses tie bar to balance the arch structure horizontal thrust.

飞燕式钢管混凝土拱桥为中承式柔性系杆拱结构，通过张拉柔性系杆来平衡拱结构的水平力。

This article analysis the major reasons that lead an axial negative thrust in unit 3, introduce the method of remove axial negative thrust with block the balance hole.

通过计算，分析了3号汽轮机轴向负推力产生的主要原因，介绍了堵平衡孔消除轴向负推力的方法。

Through comparing the simulation results with relevant experiment data, it shows that actuator disc method can well simulate the process of load overshot and gradually recovering to the balance. The characteristic time of dynamic inflow is related to thrust coefficient and spanwise location.

与实验数据的对比显示，计算结果能够较好的模拟载荷过冲并逐渐恢复平衡的过程。