tip of blade的例句大全

Welding of Rivets on the Tip of Blade for Turbine

汽轮机叶片端部铆钉的焊接修复

Experimental Study of the Effect of Blade Tip Clearance on Turbine Performance

间隙尺寸对涡轮叶栅气动性能影响的实验研究

Experimental study of the effect of blade curving on tip leakage flow

叶片弯曲对叶顶间隙流动影响的实验研究

To slice, tip the cutting knife up on an angle, to use the far end ( away from you) of the blade.

对于切片而言，先把刀的一端抬起，成三角形，然后用离你较远的那一段的刀刃来切菜。

To analyze blade tip exhaust edge fracture failure in stage ⅳ rotor-blade of an engine HP compressor, relative vibration stress and vibration characteristics are calculated by using the finite element software ANSYS.

为了分析某发动机高压压气机Ⅳ级工作叶片叶尖掉角故障，采用ANSYS有限元软件对该级叶片进行了相对振动应力及振动特性计算分析。

The calculation method for radial clearance of turbine blade tip considering the effect of temperature and rotational speed is developed in this paper.

给出了考虑温度和转速影响的涡轮叶尖径向间隙的分析计算方法。

Study on Tip Clearance Flow of Turbine Blade-Endwall Secondary Flow Structure

透平动叶顶部间隙流的端壁二次流结构研究

ⅲ region is tip leakage flow that direction of blade flange clearance turn to suction side;

Ⅲ区为叶片轮缘部中间隙泄漏流动的流动方向转向背面；

Numerical study of unsteady tip leakage flow and heat transfer in a squealer tip blade impeller-diffuser clearance

叶轮间隙；叶片间隙；导向叶片与工作叶片的间隙凹槽叶顶非定常间隙泄漏流动和传热的数值研究

Finally, an important combination parameter was put forward to reflect the overall influence of blade loading and tip clearance distribution on the tip leakage mixing loss.

最后提出一个重要的组合参数，反映了叶片尖部载荷和叶尖间隙的流向分布对叶尖泄漏掺混损失的综合影响。

Test performance comparison of rotor model with two kinds of tip shape of blade

两种桨尖形状旋翼模型试验特性对比

Thus, 30% from the tip of leaf blade was the best measuring position.

因此，距叶尖30%处是最合适的测定位置。

The efficiency of pump will be reduce with the increase of tip clearance of blade.

泵的效率随轮缘处间隙变大会有明显减小。

He put the tip of the blade into Gus's shirt and then made an arc with his arm, as though cutting a circle.

他把尖刀伸进格斯的衬衫，随手用胳膊划了个弧圈，仿佛要圆圆地剐下一块肉来。

In addition, the tip of the blade is always thinner, which lead to deformation easily, so there is a higher demand for the stability of the machining system.

此外，桨叶叶梢部分较薄，加工中易引起变形，这给加工系统的稳定性提出了更高的要求。

The result shows: short splitter has weak influence on the suction pressure distribution, leakage flux and the position leakage vortex rotated on the tip of principle blade.

结果表明：短弦长小叶片对大叶片吸力面负荷分布、泄漏量以及泄漏涡的产生位置的控制作用较弱；

Elbows parallel to the body, not prominent, and well set back to allow a line perpendicular to the ground to be drawn from tip of the shoulder blade through to elbow.

肘部与身躯平行，不突出，位置恰当，从肩胛顶端到地面的垂直线正好经过肘部。

ⅳ region is trailing edge vortex region of tip near the flange of blade.

Ⅳ区为叶片出水边靠尾部的轮缘出口尾涡区。

Secondly, the stress intensity factor at the tip of crack of rotating blade was calculated using weight function method.

然后根据权函数思想，推导出了高速旋转叶片裂纹尖端处的应力强度因子公式；

The prediction capabilities of computational fluid dynamics ( CFD) used for simulation of flow fields in stirred vessels were assessed, and flow behavior at blade tip and the vicinity of blade was analyzed.

考察了计算流体力学（CFD）模拟搅拌设备流场的预测能力，分析了搅拌桨叶端及附近区域的流动行为。