torque calculation的例句大全

calculation of harmonic torque for single-phase permanent magnet low speed synchronous motor

单相永磁式低速同步电动机谐波转矩的计算

calculation of dynamic torque and loss of stretching force for coilers

卷取机动态力矩及张力损失计算

the calculation of the planetary gear transmission ratio and torque and its power flow chart

行星齿轮变速器传动比和力矩计算与功率流图

calculation and verification of scroll conveyor pushing-material torque for the wlg-900 screen-bowl centrifuge

WLG-900型沉降过滤式离心机螺旋推料力矩的计算及其验证

research on torque ripple calculation of lci fed synchronous motor drives

LCI驱动同步电机调速系统中转矩脉动的工程计算方法研究

calculation of friction torque of the locking clutch in a planetary transmission

行星齿轮变速箱闭锁离合器摩擦力矩的计算

calculation of friction torque of the locking clutch in a planetary transmission based on section method

基于截面法的行星变速箱闭锁离合器摩擦力矩的计算

Based on the model of two kinds of relative stream surface, a finite dement method for internal flow field calculation in torque converter is developed.

本文以两类相对流面模型为基础，发展了变矩器内部流场计算的流体有限元法。

In this article, the control principle of coiler tension is generally introduced. Some calculation methods for coiler tension torque, torque compensation, coil diameter and taper tension unit are described in detail.

简述卷取张力控制原理，并着重论述了卷取张力力矩、力矩补偿、钢卷直径、TAPER张力环节等检测与计算方法。

Dimensionless parametrization is carried out for the calculation formula of magnetically transmitted torque. The simplified formula is simple, directly perceivable and convenient in use.

对磁力矩计算公式进行无量纲参数化处理，使公式简单、直观，使用方便。

With reference to calculation sheets, illustrates the procedure and method of tightening torque design.

结合实例，对螺栓紧固力矩的设计过程和设计方法进行阐述。

The calculation aim is to determine the rated tilting torque for converter tilting device design.

倾动力矩是转炉倾动机构设计的重要参数，计算它的目的是确定额定倾动力矩值，作为倾动机构设计的依据。

The power calculation methods of three-roll planetary mill by using cone rolls are discussed. A series of formulas, including the deformation zone, contact area, rolling force and rolling torque, are presented for practical use.

论述了三辊行星斜轧机利用锥形轧辊轧制时的力能参数计单方法，包括变形区形状、接触线方程、接触弧长和接触面积，以及轧制力、轧制力矩的理论计算和数学模型。