transformer station的例句大全

Problems and Solutions in Longquan Station Converter Transformer Installation Process

龙泉站换流变压器安装过程中的问题及解决办法

Design of Dry-Type Rectifier Transformer for SFC In Pumped Storage Power Station This paper describes a Static Phase Advancer using thyristor AC-AC frequency converter which is designed for asynchronous induction motor.

抽水蓄能静止变频器用干式整流变压器的设计介绍了一种由可控硅构成的交交变频器为主要结构的异步电动机静止进相器。

The simulation method was used for other devices ( such as reactor, station transformer room, grounding transformer room) to find the best supply parameters.

并以此模拟方法研究了其它设备间（电抗器、站用变室、接地变室）的最佳空调送风参数。

The auxiliary power supply of Nuclear Power Station is used to supply the engineered safety features to ensure the safe shutdown of the reactor, when unit trip causes the house supply switch from Main Transformer to it.

核电站的辅助电源系统作为安全电源，在机组故障导致厂用电从主电网切换到辅助电源时向必须运行的专设安全设施供电，以保证反应堆安全停堆。

The station control level is led 2-circuit AC power supply through different buses, through isolating transformer to UPS with single-phase з-line power output to eath user.

站级控制层由不同母线引入2路交流电源，经隔离变至UPS后输出单相三线电源至各用电设备。

Choice of Dry Type Transformer for Pump Station

泵站干式变压器的选用

Generator step-up transformer is one of the major and key components for the electricity output of nuclear power station.

发电机升压变压器，即主变压器（主变），是核电站电力输出的重大、关键设备之一。

Retrofitting Design and Equipment Selection of Station Supply of Transformer Substation

变电站站用电改造设计与设备选型

Analysis of Short Circuit Magnetic Force in the Split Transformer Used for Station Service

厂用分裂变压器短路电磁力计算分析

In the analysis of main transformer phase B of unit 2 in Ling' ao Nuclear Power Station ( LNPS) by chromatography, acetylene was found. In order to carry out the inside check, the main transformer had been stopped and restored after necessary maintenances.

针对岭澳核电站2号主变压器B相油样色谱分析发现乙炔事件，将主变压器停运并进行了内部检查，在完成了必要的改进性维修后变压器恢复运行。

The master station sends parameters of power control period, power setting, setting depreciation coefficient, alarm time and control turns to the data acquire terminal of special transformer and the terminal will set the corresponding parameters after receiving the order.

主站依次向专变采集终端下发功控时段、功率定值、定值浮动系数、告警时间、控制轮次等参数，终端收到这些命令后设置相应参数。

Analysis of a maloperation of transformer's backup protection in 110 kV Zhaodong station

昭东电站110kV主变后备保护拒动原因分析