transition temperature的例句大全

Relationship between test frequency and glass transition temperature was studied for four TATB based PBXs and their binders ( fluoropolymers), by using dynamic mechanical analysis ( DMA) method.

用动态力学分析（DMA）方法，研究了四种TATB基PBX及其粘结剂（氟聚物）的测量频率与玻璃化温度的关系。

The thermoplastic acrylic resin with a certain glass transition temperature was prepared by choosing reasonable ratio of monomers. As the coatings binder for ABS plastics, It has good physical property and alcohol resistance.

通过选择合理的原料单体配比制备具一定玻璃化温度的热塑性丙烯酸树脂，作为ABS塑料用涂料的基料，具有较好的物理性能以及优良的耐醇性。

The decreasing of crosslink density made the glass transition temperature increase, and the tensile breaking strength and tensile elongation at break decrease.

聚合物交联密度下降使材料玻璃化转变温度提高，拉伸断裂强度和拉伸断裂伸长率下降。

Coil coatings was thermal analyzed and researched with DSC in order to test glass transition temperature ( Tg) of the paint film at the maximum precoated metal temperature ( PMT) and determine the optimal curing conditions of different coil coatings.

采用DSC进行卷材涂料热分析研究，测试在不同PMT（最高金属板温）下漆膜的Tg，以确定各种卷材涂料的最佳固化条件。

Test method for thermal transition temperature of textile material

纺织材料的热转变温度试验方法

The glass transition temperature Tg, melt point Tm, thermogravimetric curve, tensile strength and degradation rate of this blend were determined by DSC, TGA, tensile test and degradation test.

用差示扫描量热法、热重分析法和拉伸试验法等测定了CDA&PLLGA的玻璃化温度、熔点、热失重性能、拉伸强度和降解性能。

After tempering within the range 450~ 550 ℃, impact toughness dropped, and transition temperature increased. This tempering embrittlement mainly depends on M_7C_3 precipitation.

450～550℃回火，冲击韧性下降，转变温度升高，该回火脆性主要取决于M7C3沉淀。

The test temperature is determined by the critical transition temperature of the CTOD test. And the temperature shift is proposed by the author.

根据临界CTOD试验曲线与冲击韧性曲线的温度移位，确定规范冲击韧性试验温度。

The synthesis technology for PET/ nano-meter clay ( NCL) composite was studied, and the effects of NCL on the polymerization of PET/ NCL, the deformation of PET slice, the phase transition temperature and the gas barrier property were discussed.

研究了聚对苯二甲酸乙二醇酯（PET）/纳米累托土（NCL）复合材料的合成工艺，讨论了NCL对PET聚合工艺、切片的形变和相变温度以及气体阻隔性能的影响。

Regression Analysis of Ductile-Brittle Transition Temperature Curve for CrMo Steel

CrMo钢材料韧脆转变温度曲线的回归分析

The influence of glass transition temperature and homogeneity of polymer membrane on the responding feature of electrodes were also discussed.

本文还讨论了聚合物的玻璃化转变温度和膜的均匀性对电极性能的影响。

Phase Transition and Transition Temperature Hysteresis of VO_2 Thin Film

VO2薄膜相变及其温度滞后

The test results indicate that there is significant difference between transition temperature, hysteresis width and temperature coefficient of resistance of the films prepared by the two methods.

对两种方法制备薄膜的性能测试结果表明，其转换温度、相变滞豫、热电阻温度系数等都有较大差别。

Near the transition temperature, a thermal hysteresis was found in dielectric, pyroelectric and piezoelectric measurements. Thus the transition should be of the first order transition.

在相变温度区域里，介电、热电和压电都有明显的热滞效应，具有一级相变特性。

Theoretical Prediction of Glass Transition Temperature of 1,2-propanediol Aqueous Solution

1,2-丙二醇水溶液玻璃化温度的理论预测

And by means of Fourier infrared spectrometer, the glass transition temperature of the tester and transmission electron microscopy on the structure of polymer was characterized.

并借助傅立叶红外光谱仪、玻璃化温度测试仪、透射电镜等对聚合物的结构进行了表征。

However, due to high melting point of tungsten and ductile-brittle transition temperature, crocodiling, lamination and cracking were easily formed in roll processing.

由于金属钨的高熔点、高韧-脆转变温度，因此钨板在轧制过程中易出现张嘴，分层，开裂等现象。

Its glass transition temperature and weight loss temperature was higher than 320 ℃ and 435 ℃, respectively.

玻璃化转变温度大于320℃，5%热失重温度大于435℃。

The results show that SDC and carbonates have formed a composite, and its conductivity behavior has two typical features: conductivity transition temperature and conductivity enhancement effect.

结果表明，SDC与碳酸盐形成了两相复合体系，而且其导电行为具有两个显著特征：电导跃迁温度和电导率增强效应。

Structure phase transition was investigated by using temperature-change Raman scattering method for the PCT, the transition temperature from a ferroelectric tetragonal to a paraelectric cubic phase for PCT ( 0) and PCT ( 20) are 430 ℃ and 330 ℃, respectively.

变温拉曼光谱显示PCT（0）和PCT（20）从铁电四方相向顺电立方相的转变温度分别降低至430℃和330℃；