truss bar的例句大全

In recent years, the research work in steel structure with prestressed tendons mainly concentrates on prestressing force steel truss, tension rod, compression bar, etc, but the study work to the application in the engineering of bridge building is less.

近年来，预应力钢结构研究的工作主要是集中在预应力钢桁架、拉杆、压杆等方面，而对于预应力钢结构在桥梁工程中的应用则研究得较少。

The design of the big-span steel structure is introduced for structural layout, and its dynamical characteristics and internal forces distribution under different load cases, foundation tie bar, swinging column, steel shuttle-shaped truss column and sliding bearing etc, are presented.

主要介绍了大跨度钢结构的结构布置、其动力特性及各工况下的内力分布、基础拉梁、摇摆柱、梭形钢结构桁架柱、滑动支座的设计等内容。

The modeling programs of truss based on space bar elements and the three-dimensional frame elements are written separately.

分别编写了采用三维杆单元和刚架单元对桁架动力学建模的程序，建立了桁架的动力学模型。

Application of Steel Bar Truss Deck in Steel Structure

钢筋桁架楼承板在钢结构建筑中的应用

Finite element model of truss in ANSYS is built, quadruplet bars are selected, in every group one bar is designated randomly and early damage is simulated through receding its elasticity;

利用ANSYS进行桁架结构有限元模型的建立，选定四组杆件，在每一组中随机指定一根，通过降低其弹性模量来模拟早期损伤；

The structure of bar system is divided into the frame structure and truss structure because of the different ways of connection.

杆系结构由于连接方式的不同被分为刚架结构和桁架结构。

The paper discusses the application of beret truss bearers in prestressed concrete process tie bar arch bridge construction after mechanical calculation.

通过力学验算，初步探讨组合式贝雷桁架片托架在预应力砼系杆拱桥梁施工中的应用。

This method has been applied to optimize the weight of the spring structure and 3-bar truss, respectively.

该方法被分别用于气门弹簧结构和简单静不定三杆桁架结构的质量最轻优化设计中。

a method of adjusting bar-iength of statically indeterminate truss for increasing its load capacity

提高超静定桁架承载能力的杆长调整法

correctly arranging a concrete base transverse adjusting component and connecting the component with a switch tie truss reinforcement bar;

混凝土底座横向调整件安放正确，并与岔枕桁架钢筋连接；

Calculating method of finite deformation exponential hardening of truss subjecting compress load A New High-Order Multi-Joint Finite Element for Thin-Walled Bar

杆件受压时有限变形幂次强化计算方案一种新型的高次多结点薄壁杆件单元

The bottom chord of the truss is used by pre-stress steel bar.

主楼和裙房间采用大跨鱼腹桁架，桁架下弦采用高强度预应力钢棒。

The influence of crane load to the internal force of bottom chord bar of trapezoid steel roof truss

水动力荷载；吊车荷载对梯形钢屋架下弦杆内力的影响

A numerical example of a ten-bar truss was given to demonstrate the validity and feasibility of CGA in its application, and it is found that the optimized results of CGA are superior to SGA and IGA.

通过十杆平面桁架的数值算例来验证组合遗传算法应用的可行性和有效性，组合遗传算法的优化结果也远好于标准遗传算法和改进遗传算法。