unit load的例句大全

Introduces three methods that can adjust refrigerating output according to the variation of load aimed at the varying duty condition during the practical operation process of refrigeration system, frequency inverter technique, parallel unit with several compressors and liquid refrigerant storing method.

针对制冷系统实际运行过程中存在的变负荷工况，介绍三种根据负荷变化调节制冷量的方法：变频技术、多机并联压缩机组以及液体制冷剂储存方法。

Research on the Dry Load Apparatus for Offshore Platform Generator Unit

海洋平台发电机组干式负荷装置研究

The thesis designs a frequency-power automatical control unit based on PLC, enabling generators to run reliably even if in the event of heavy load fluctuating.

本文设计了一种基于PLC控制的自动调频调载装置，可使发电机组在大负荷波动的情况下也能可靠地运行；

The energy consumption of the beam pumping unit is proportional to the coefficient of load fluctuation CLF.

游梁式抽油机的耗能量与载荷波动系数CLF成正比。

This thesis was based on the article, project of new technique research of diagnosis through the visualization of three-demission combustion and controlling load of unit, in a power station in Guangdong province and discussed the application of radiation energy signal for the superheated-steam temperature control system.

本文以广东某电厂《燃烧三维可视化诊断及机组负荷控制新技术研究项目》为背景，探讨辐射能信号在电站锅炉过热汽温控制系统中的应用。

After the wall energy unit area of high load capacity, high surface temperature, the lampdimming life.

确定后,则管壁单位面积能量负荷大, 管壁温度高, 灯管寿命低.

Technical Reformation and High Load Operation of Shifting Unit in Project of Methanol Made by Shell Coal Gasification

Shell煤气化制甲醇项目之变换装置技术改造与高负荷运行

Based on the advanced technology and instruments of visible monitoring system of section temperature field in furnace, energy saving& environmental protection test vehicle and 3-dimension furnace computational simulation, test and study are carried out on stability of peak-load regulation and optimization of operation of large unit.

利用炉膛断面温度场可视化监测系统、节能环保车、炉内三维数值模拟等先进的技术和设备对大机组调峰稳定性和运行方式优化进行试验和理论研究。

After computation, temperature change rate can been directly determined according to the unit operation time when the boiler starts up, blows out and changes load.

经过推导计算，得到直接根据机组运行时间的长短来决定机组启停炉及变负荷时的温变速率。

The terminal unit of load management plays an important part in the system of power load management, it can monitor special use and communal use transformer substation, it also can monitor the quality of the power net.

负荷管理终端是电力负荷管理系统的一个重要组成部分，它可以对专用配变及公用配变进行监控同时还能监测电网质量。

Control unit carried out the test of RF cavity load which is designed for low-power experiment, and experimental results verify the correctness and reliability of control procedures.

对高频控制单元开展了假腔体负载的测试实验，实验结果验证了控制程序的正确性和可靠性。

With the digital control, volume of compressive oil provided by hydraulic power unit in actuator can be regulated to modulate the test load value.

在油源设备提供一定压力油液的情况下，计算机调整输入到液压缸内的油液流量，由此控制试验载荷。

Simulating study on load preview control system of a thermal power unit

火电单元机组负荷最优预见控制系统仿真研究

For the installation of the balance of the unit block, with the mining, and underground load conditions changed, the balance has been affected.

对于安装平衡块的抽油机，随着开采的进行，井下负载情况发生了变化，平衡受到了影响。

Other areas where the performance was improved are the load time, locking in multi-threaded programs, pathname and date libraries and test/ unit, which gained parallel execution.

其他与性能提升有关的还有加载时间、多线程程序中的线程锁、路径名、日期类库以及测试单元，从而获得了并行执行的能力。

By employing a relatively detailed thermal load time retardation chart with the unit heat supply area net value of the nuclear heat supply system assigned as an optimization objective, an optimization of the nuclear heat supply plant thermochemical factor was conducted.

利用较详细的热负荷延时图，以核供热系统单位供热厂热面积净现值为优化目标，对核热电化系数进行优化。

Problem existing in reactive-load compensation equipment and auto-switching unit

湖南电网无功设备及自动投切装置存在问题探讨

Function Discussion on Rapidly Decreasing Load ( RB) in Unit

机组快速减负荷（RB）功能探讨

Study of Static Load on Molded Pulp Buffering Structure Unit

纸浆模塑衬垫缓冲结构单元静态载荷的研究

Energy-saving and smooth operation while forced reversing can be realized by good play of the buffer springs so long as the relative sliding length between the counterbalance weight and the movable frame on the load-belt long stroke pumping unit is properly designed.

设计宽带长冲程抽油机时，合理地确定平衡重与活动框架的相对滑移长度可以更好地利用缓冲弹簧在换向时实现节能和缓冲的目的。